- 您现在的位置：买卖IC网 > PDF目录10452 > MCP2004T-E/SN (Microchip Technology)IC TXRX LIN B/DIR 8SOIC PDF资料下载
参数资料
| 型号： | MCP2004T-E/SN |
| 厂商： | Microchip Technology |
| 文件页数： | 29/34页 |
| 文件大小： | 0K |
| 描述： | IC TXRX LIN B/DIR 8SOIC |
| 产品培训模块： | Microchip MCP20xx LIN Transceiver Overview |
| 标准包装： | 3,300 |
| 类型： | 收发器 |
| 驱动器/接收器数： | 1/1 |
| 规程： | LIN |
| 电源电压： | 6 V ~ 27 V |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 8-SOIC（0.154"，3.90mm 宽） |
| 供应商设备封装： | 8-SOICN |
| 包装： | 带卷 (TR) |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页当前第29页第30页第31页第32页第33页第34页
MCP2003/4/3A/4A
DS22230D-page 4
2010-2011 Microchip Technology Inc.
1.3
Modes of Operation
For an overview of all operational modes, refer to
1.3.1
POWER-DOWN MODE
In Power-Down mode, everything is off except the
wake-up section. This is the lowest power mode. The
receiver is off, thus its output is open-drain.
On CS going to a high level or a falling edge on WAKE
(MCP2003/MCP2003A only), the device will enter
Ready Mode as soon as internal voltage stabilizes.
Refer to the AC Spec table. In addition, LIN bus activity
will change the device from power-down mode to ready
mode; MCP2003/4 wakes up on a falling edge of LIN
bus and MCP2003/4A on a rising edge, following a low
level lasting at least 20 S of time. Refer to Figure 1-2
– Figure 1-5 about remote wake up. If CS is held high
as the device transitions from Power-Down to Ready
mode, the device will transition to either Operation or
Transmitter Off mode, depending on TXD input, as
soon as internal voltages stabilize.
1.3.2
READY MODE
Upon entering the Ready mode, VREN is enabled and
the receiver detect circuit is powered up. The transmit-
ter remains disabled and the device is ready to receive
data but not to transmit.
Upon VBB supply pin power-on, the device will remain
in Ready mode as long as CS is low. When CS transi-
tions high, the device will either enter Operation mode,
if TXD pin is held high, or the device will enter Trans-
mitter Off mode, if TXD pin is held low.
1.3.3
OPERATION MODE
In this mode, all internal modules are operational.
The device will go into the Power-Down mode on the
falling edge of CS. For the MCP2003/4 device, a
specific process should be followed to put all nodes into
Power-down mode. Refer to Section 1.6 “Enter
Power-Down Mode” and Figure 1-6. The device will
enter Transmitter Off mode in the event of a Fault
condition. These include: thermal overload, bus
contention and TXD timer expiration.
The
MCP2004/2004A
device
can
also
enter
Transmitter Off mode if the FAULT/TXE pin is pulled
low. The VBB-LBUS pull-up resistor is connected only
in Operation mode.
1.3.4
TRANSMITTER OFF MODE
Transmitter Off mode is reached whenever the
transmitter is disabled either due to a Fault condition or
pulling the nFAULT/TXE pin low on the MCP2004/
2004A. The fault conditions include: thermal overload,
bus contention or TXD timer expiration.
The device will go into Power-Down mode on the falling
edge of CS, or return to Operation mode if all faults are
resolved and the FAULT/TXE pin on the MCP2004/
2004A is high.
FIGURE 1-2:
OPERATIONAL MODES STATE DIAGRAM – MCP2003
POR
VREN OFF
RX OFF
TX OFF
VBAT>5.5V
Ready
VREN ON
RX ON
TX OFF
TOFF
Mode
VREN ON
RX ON
TX OFF
Operation
Mode
VREN ON
RX ON
TX ON
POWER
DOWN
VREN OFF
RX OFF
TX OFF
CS=1 & TXD=0
CS=1 & TXD=1
CS=1 & TXD=1 & No Fault
Fault (thermal or timer)
CS=0
Falling edge on LIN
or CS=1
or falling edge on WAKE PIN
CS=0
相关PDF资料 |
PDF描述 |
|---|---|
| VE-BTM-IV-F3 | CONVERTER MOD DC/DC 10V 150W |
| MCP2003T-E/SN | TXRX LIN STAND ALONE 8SOIC |
| VE-BTL-IV-F1 | CONVERTER MOD DC/DC 28V 150W |
| VE-BTK-IV-F1 | CONVERTER MOD DC/DC 40V 150W |
| VE-BTJ-IV-F4 | CONVERTER MOD DC/DC 36V 150W |
相关代理商/技术参数 |
参数描述 |
|---|---|
| MCP200JR-100K | 功能描述:RES 100K OHM 2W 5% MELF RoHS:是 类别:电阻器 >> 芯片电阻 - 表面安装 系列:MCP 产品目录绘图:RHM Series Top RHM Series Side 标准包装:5,000 系列:MCR10 电阻（欧姆）:27 功率（瓦特）:0.125W，1/8W 复合体:厚膜 特点:- 温度系数:±200ppm/°C 容差:±5% 封装/外壳:0805（2012 公制） 尺寸/尺寸:0.079" L x 0.049" W（2.00mm x 1.25mm） 高度:0.026"（0.65mm） 端子数:2 包装:带卷 (TR) 产品目录页面:2225 (CN2011-ZH PDF) 其它名称:RHM27ATR |
| MCP200JR-100R | 功能描述:RES 100 OHM 2W 5% MELF RoHS:是 类别:电阻器 >> 芯片电阻 - 表面安装 系列:MCP 标准包装:4,000 系列:RCL - 汽车 电阻（欧姆）:30.9 功率（瓦特）:1W 复合体:厚膜 特点:- 温度系数:±100ppm/°C 容差:±1% 封装/外壳:1812（4632 公制）宽（长端），1218（3246 公制） 尺寸/尺寸:0.126" L x 0.181" W（3.20mm x 4.60mm） 高度:0.024"（0.60mm） 端子数:2 包装:带卷 (TR) |
| MCP200JR-10K | 功能描述:RES 10K OHM 2W 5% MELF RoHS:是 类别:电阻器 >> 芯片电阻 - 表面安装 系列:MCP 产品目录绘图:RHM Series Top RHM Series Side 标准包装:5,000 系列:MCR10 电阻（欧姆）:27 功率（瓦特）:0.125W，1/8W 复合体:厚膜 特点:- 温度系数:±200ppm/°C 容差:±5% 封装/外壳:0805（2012 公制） 尺寸/尺寸:0.079" L x 0.049" W（2.00mm x 1.25mm） 高度:0.026"（0.65mm） 端子数:2 包装:带卷 (TR) 产品目录页面:2225 (CN2011-ZH PDF) 其它名称:RHM27ATR |
| MCP200JR-10R | 功能描述:RES 10 OHM 2W 5% MELF RoHS:是 类别:电阻器 >> 芯片电阻 - 表面安装 系列:MCP 产品目录绘图:RHM Series Top RHM Series Side 标准包装:5,000 系列:MCR10 电阻（欧姆）:27 功率（瓦特）:0.125W，1/8W 复合体:厚膜 特点:- 温度系数:±200ppm/°C 容差:±5% 封装/外壳:0805（2012 公制） 尺寸/尺寸:0.079" L x 0.049" W（2.00mm x 1.25mm） 高度:0.026"（0.65mm） 端子数:2 包装:带卷 (TR) 产品目录页面:2225 (CN2011-ZH PDF) 其它名称:RHM27ATR |
| MCP200JR-120R | 功能描述:RES 120 OHM 2W 5% MELF RoHS:是 类别:电阻器 >> 芯片电阻 - 表面安装 系列:MCP 产品目录绘图:RHM Series Top RHM Series Side 标准包装:5,000 系列:MCR10 电阻（欧姆）:27 功率（瓦特）:0.125W，1/8W 复合体:厚膜 特点:- 温度系数:±200ppm/°C 容差:±5% 封装/外壳:0805（2012 公制） 尺寸/尺寸:0.079" L x 0.049" W（2.00mm x 1.25mm） 高度:0.026"（0.65mm） 端子数:2 包装:带卷 (TR) 产品目录页面:2225 (CN2011-ZH PDF) 其它名称:RHM27ATR |
发布紧急采购，3分钟左右您将得到回复。