- 您现在的位置：买卖IC网 > PDF目录11809 > MCP2210-I/MQ (Microchip Technology)IC CONVERTER USB-PCI 20-QFN PDF资料下载
参数资料
| 型号： | MCP2210-I/MQ |
| 厂商： | Microchip Technology |
| 文件页数： | 78/82页 |
| 文件大小： | 0K |
| 描述： | IC CONVERTER USB-PCI 20-QFN |
| 产品培训模块： | MCP2210 Evaluation Kit |
| 标准包装： | 73 |
| 应用： | 带 GPIO 的 USB 至 SPI 连接器 |
| 接口： | SPI，USB |
| 电源电压： | 3.3 V ~ 5.5 V |
| 封装/外壳： | 20-VQFN 裸露焊盘 |
| 供应商设备封装： | 20-QFN（5x5） |
| 包装： | 管件 |
| 安装类型： | 表面贴装 |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页第29页第30页第31页第32页第33页第34页第35页第36页第37页第38页第39页第40页第41页第42页第43页第44页第45页第46页第47页第48页第49页第50页第51页第52页第53页第54页第55页第56页第57页第58页第59页第60页第61页第62页第63页第64页第65页第66页第67页第68页第69页第70页第71页第72页第73页第74页第75页第76页第77页当前第78页第79页第80页第81页第82页
MCP2210
DS22288A-page 8
2011 Microchip Technology Inc.
1.7
EEPROM Module
The EEPROM module is a 256-byte array of nonvola-
tile memory. The memory locations are accessed for
read/write operations solely via USB host commands.
The memory cells for data EEPROM are rated to
endure thousands of erase/write cycles, up to 100K for
EEPROM.
Data retention without refresh is conservatively
estimated to be greater than 40 years.
1.8
Reset/POR
1.8.1
RESET PIN
The RST pin provides a method for triggering an
external Reset of the device. A Reset is generated by
holding the pin low. MCP2210 has a noise filter in the
Reset path which detects and ignores small pulses.
1.8.2
POR
A POR pulse is generated on-chip whenever VDD rises
above a certain threshold. This allows the device to
start in the initialized state when VDD is adequate for
operation.
To take advantage of the POR circuitry, tie the RST pin
through a resistor (1 k
to 10 k) to VDD. This will
eliminate external RC components usually needed to
create a POR delay.
When the device starts normal operation (i.e., exits the
Reset condition), the device operating parameters
(voltage, frequency, temperature, etc.) must be met to
ensure operation. If these conditions are not achieved,
the device must be held in Reset until the operating
conditions are met.
1.9
Oscillator
The input clock must be 12 MHz to provide the proper
frequency for the USB module. USB full-speed is
nominally 12 Mb/s. The clock input accuracy is ±0.25%
(2,500 ppm maximum).
FIGURE 1-5:
QUARTZ CRYSTAL
OPERATION
FIGURE 1-6:
CERAMIC RESONATOR
OPERATION
Quartz Crystal
12 MHz
OSC1
OSC2
RS(1)
RF(2)
MCP2210
Note 1: A series resistor (RS) may be required for
quartz crystals with high drive level.
2: The value of RF is typically between 2 M to
10 M
..
Example: muRata
CSTCE12M0G15L
OSC1
OSC2
Resonator
12 MHz
MCP2210
相关PDF资料 |
PDF描述 |
|---|---|
| MCP2210-I/SS | IC CONVERTER USB-PCI 20-SSOP |
| MCP2210-I/SO | IC CONVERTER USB-PCI 20-SOIC |
| V28C48H100B3 | CONVERTER MOD DC/DC 48V 100W |
| VI-BTN-IX-F3 | CONVERTER MOD DC/DC 18.5V 75W |
| V28C48H100B | CONVERTER MOD DC/DC 48V 100W |
相关代理商/技术参数 |
参数描述 |
|---|---|
| MCP2210-I-SO | 制造商:MICROCHIP 制造商全称:Microchip Technology 功能描述:USB-to-SPI Protocol Converter with GPIO (Master Mode) |
| MCP2210-I-SS | 制造商:MICROCHIP 制造商全称:Microchip Technology 功能描述:USB-to-SPI Protocol Converter with GPIO (Master Mode) |
| MCP2210T-I/MQ | 功能描述:USB 接口集成电路 USB to SPI Protocol Converter RoHS:否 制造商:Cypress Semiconductor 产品:USB 2.0 数据速率: 接口类型:SPI 工作电源电压:3.15 V to 3.45 V 工作电源电流: 最大工作温度:+ 85 C 安装风格:SMD/SMT 封装 / 箱体:WLCSP-20 |
| MCP2210T-I/SO | 功能描述:USB 接口集成电路 USB to SPI Protocol Converter RoHS:否 制造商:Cypress Semiconductor 产品:USB 2.0 数据速率: 接口类型:SPI 工作电源电压:3.15 V to 3.45 V 工作电源电流: 最大工作温度:+ 85 C 安装风格:SMD/SMT 封装 / 箱体:WLCSP-20 |
| MCP2210T-I/SS | 功能描述:USB 接口集成电路 USB to SPI Protocol Converter RoHS:否 制造商:Cypress Semiconductor 产品:USB 2.0 数据速率: 接口类型:SPI 工作电源电压:3.15 V to 3.45 V 工作电源电流: 最大工作温度:+ 85 C 安装风格:SMD/SMT 封装 / 箱体:WLCSP-20 |
发布紧急采购，3分钟左右您将得到回复。