参数资料
型号: MCP2515-E/PG
元件分类: 微控制器/微处理器
英文描述: 1 CHANNEL(S), 1M bps, SERIAL COMM CONTROLLER, PDIP18
封装: 0.300 INCH, LEAD FREE, PLASTIC, DIP-18
文件页数: 50/88页
文件大小: 1205K
代理商: MCP2515-E/PG
MCP2515
DS21801F-page 54
2010 Microchip Technology Inc.
FIGURE 8-3:
EXTERNAL SERIES RESONANT CRYSTAL OSCILLATOR CIRCUIT(1)
TABLE 8-1:
CAPACITOR SELECTION FOR
CERAMIC RESONATORS
TABLE 8-2:
CAPACITOR SELECTION FOR
CRYSTAL OSCILLATOR
330 k
Ω
74AS04
MCP2510
OSC1
To Other
Devices
XTAL
330 k
Ω
74AS04
0.1 mF
Note 1: Duty cycle restrictions must be observed (see Table 12-1).
Typical Capacitor Values Used:
Mode
Freq.
OSC1
OSC2
HS
8.0 MHz
27 pF
16.0 MHz
22 pF
Capacitor values are for design guidance only:
These capacitors were tested with the resonators
listed below for basic start-up and operation. These
values are not optimized.
Different capacitor values may be required to
produce acceptable oscillator operation. The user
should test the performance of the oscillator over the
expected VDD and temperature range for the
application.
See the notes following Table 8-2 for additional
information.
Resonators Used:
4.0 MHz
8.0 MHz
16.0 MHz
Osc
Type(1)(4)
Crystal
Freq.(2)
Typical Capacitor
Values Tested:
C1
C2
HS
4 MHz
27 pF
8 MHz
22 pF
20 MHz
15pF
Capacitor values are for design guidance only:
These capacitors were tested with the crystals listed
below for basic start-up and operation. These values
are not optimized.
Different capacitor values may be required to
produce acceptable oscillator operation. The user
should test the performance of the oscillator over the
expected VDD and temperature range for the
application.
See the notes following this Table for additional
information.
Crystals Used(3):
4.0 MHz
8.0 MHz
20.0 MHz
Note 1:
While higher capacitance increases the
stability of the oscillator, it also increases
the start-up time.
2:
Since each resonator/crystal has its own
characteristics, the user should consult
the resonator/crystal manufacturer for
appropriate values of external
components.
3:
RS may be required to avoid overdriving
crystals with low drive level specification.
4:
Always verify oscillator performance over
the VDD and temperature range that is
expected for the application.
相关PDF资料
PDF描述
MCP2515-I/ST 1 CHANNEL(S), 1M bps, SERIAL COMM CONTROLLER, PDSO20
MCP2515-E/P 1 CHANNEL(S), 1M bps, SERIAL COMM CONTROLLER, PDIP18
MCP2515T-I/ST 1 CHANNEL(S), 1M bps, SERIAL COMM CONTROLLER, PDSO20
MCP79400-I/MNY REAL TIME CLOCK, PDSO8
MCP79400T-I/ST REAL TIME CLOCK, PDSO8
相关代理商/技术参数
参数描述
MCP2515-I 制造商:MICROCHIP 制造商全称:Microchip Technology 功能描述:Stand-Alone CAN Controller with SPI Interface
MCP2515-I/ML 制造商:MICROCHIP 制造商全称:Microchip Technology 功能描述:Stand-Alone CAN Controller with SPI Interface
MCP2515-I/P 功能描述:网络控制器与处理器 IC W/ SPI Interface RoHS:否 制造商:Micrel 产品:Controller Area Network (CAN) 收发器数量: 数据速率: 电源电流(最大值):595 mA 最大工作温度:+ 85 C 安装风格:SMD/SMT 封装 / 箱体:PBGA-400 封装:Tray
MCP2515-I/P 制造商:Microchip Technology Inc 功能描述:CAN controller IC
MCP2515-I/SO 功能描述:网络控制器与处理器 IC W/ SPI Interface RoHS:否 制造商:Micrel 产品:Controller Area Network (CAN) 收发器数量: 数据速率: 电源电流(最大值):595 mA 最大工作温度:+ 85 C 安装风格:SMD/SMT 封装 / 箱体:PBGA-400 封装:Tray