- 您现在的位置：买卖IC网 > PDF目录1953 > MCP4452-503E/ST (Microchip Technology)IC RHEO 50K QUAD 8BIT 14TSSOP PDF资料下载
参数资料
| 型号： | MCP4452-503E/ST |
| 厂商： | Microchip Technology |
| 文件页数： | 9/22页 |
| 文件大小： | 0K |
| 描述： | IC RHEO 50K QUAD 8BIT 14TSSOP |
| 标准包装： | 96 |
| 接片： | 257 |
| 电阻（欧姆）： | 50k |
| 电路数： | 4 |
| 温度系数： | 标准值 150 ppm/°C |
| 存储器类型： | 易失 |
| 接口： | I²C（设备位址） |
| 电源电压： | 1.8 V ~ 5.5 V |
| 工作温度： | -40°C ~ 125°C |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 14-TSSOP（0.173"，4.40mm 宽） |
| 供应商设备封装： | 14-TSSOP |
| 包装： | 管件 |
Digital Potentiometer Design Guide
17
Application Circuits and Techniques
Digital potentiometers are a good fit for applications to trim
offset and gain in amplifier circuits. In this following circuit,
a resistor ladder is used to create a voltage window where
Pot1 is used to trim the desired offset for the inverting
amplifier. A second potentiometer (Pot2) is used in a
rheostat mode along with resistor R3 to control the gain of
the amplifier. The step resistance of Pot2 relative to resistor
R3 determines if the gain trimming is a fine adjustment or a
course adjustment. Capacitor C1 is for compensation of the
op amp and to inhibit the output from oscillating.
In this circuit, there is no interaction between the offset
trimming and the gain trimming, but the input signal (VIN) is
loaded by the resistance of R3 plus Pot2’s RBW value.
In the following circuit, a resistor ladder is used to create
a voltage window where Pot1 is used to trim the desired
offset for the non-inverting amplifier. A second potentiometer
is used in a rheostat mode to control the gain of the
amplifier. The step resistance of Pot2 relative to resistor R3
determines if the gain trimming is a fine adjustment or a
course adjustment. Capacitor C1 is for compensation of the
op amp and to inhibit the output from oscillating.
In this circuit, there is an interaction between the offset
trimming and the gain trimming. To minimize this interaction,
Pot2 should be small compared to resistor R3 and Pot1
should be small relative to the sum of R1 and R2. But the
input signal (VIN) is not loaded.
Additional information can be found in application note AN1316.
Inverting Amplifier with Offset and Gain Trimming
Non-Inverting Amplifier with Offset and Gain Trimming
Digital Potentiometer Solutions
In the following circuit, a resistor ladder is used to create a
voltage window where Pot1 is used to trim the desired offset
for the band pass filter. This resistor ladder setting also
works with capacitor C2 to set the high pass filter frequency.
A second potentiometer (Pot2) is used in a rheostat mode
along with R3 and R4 to control the gain of the amplifier.
The step resistance of Pot2 relative to resistors R3 and R4
determines if the gain trimming is a fine adjustment or a
course adjustment. Capacitor C1 along with Pot2, R3 and R4
is used to set the low pass filter.
Capacitor C1 is also used for compensation of the Op Amp
and to inhibit the output from oscillating.
If capacitor C1 is not present, then the circuit is a high pass
filter, while if capacitor C2 is not present then the circuit is a
low pass filter.
The following circuit will the use of an RC filter (Potx and
Cx) will filter at the selected frequency. that frequency is
determined by the rheostat value (RBW) of the Pot and the
capacitor value (Cx). each additional stage of the RC filter is
used to enhance the roll-off characteristics for the filter. The
capacitors Cx should be the same, while the wiper values
of the Pots should be similar. The differences would be to
compensate for the slight variations of the RAB values of
each Pot and the variations of the capacitors.
Band Pass Filter with Offset and Gain Trimming
Programmable Filter
相关PDF资料 |
PDF描述 |
|---|---|
| MCP4461-503E/ST | IC POT 8B QUAD NONV 50K 20TSSOP |
| MCP4561-104E/MS | IC DGTL POT 100K 256TAPS 8-MSOP |
| MCP4631-503E/ST | IC DGTL POT 50K 128TAPS 14-TSSOP |
| MCP47DA1T-A1E/OT | IC DGTL POT 30K 1CH SOT-23-6 |
| MCW1001AT-I/SS | IC INTERFACE SOCKET XLP 28-SSOP |
相关代理商/技术参数 |
参数描述 |
|---|---|
| MCP4452T-502E/ST | 制造商:Microchip Technology Inc 功能描述:IC RHEOSTAT 257POS 5K 14TSSOP 制造商:Microchip Technology Inc 功能描述:5k, I2C, quad channel Rheo, 8-bit, volatile memory, TSSOP, 14 TSSOP 4.4mm T/R |
| MCP4461-103E/ML | 功能描述:数字电位计 IC 10k I2C Quad Ch 8bit Nonvolatile Memory RoHS:否 制造商:Maxim Integrated 电阻:200 Ohms 温度系数:35 PPM / C 容差:25 % POT 数量:Dual 每 POT 分接头:256 弧刷存储器:Volatile 缓冲刷: 数字接口:Serial (3-Wire, SPI) 描述/功能:Dual Volatile Low Voltage Linear Taper Digital Potentiometer 工作电源电压:1.7 V to 5.5 V 电源电流:27 uA 最大工作温度:+ 125 C 安装风格:SMD/SMT 封装 / 箱体:TQFN-16 封装:Reel |
| MCP4461-103E/ML | 制造商:Microchip Technology Inc 功能描述:; End To End Resistance:10kohm; Track Ta |
| MCP4461-103E/ST | 功能描述:数字电位计 IC 10k I2C Quad Ch 8bit Nonvolatile Memory RoHS:否 制造商:Maxim Integrated 电阻:200 Ohms 温度系数:35 PPM / C 容差:25 % POT 数量:Dual 每 POT 分接头:256 弧刷存储器:Volatile 缓冲刷: 数字接口:Serial (3-Wire, SPI) 描述/功能:Dual Volatile Low Voltage Linear Taper Digital Potentiometer 工作电源电压:1.7 V to 5.5 V 电源电流:27 uA 最大工作温度:+ 125 C 安装风格:SMD/SMT 封装 / 箱体:TQFN-16 封装:Reel |
| MCP4461-103E/ST | 制造商:Microchip Technology Inc 功能描述:; End To End Resistance:10kohm; Track Ta 制造商:Microchip Technology Inc 功能描述:IC, DIG POT, 10kohm, 257STEPS, QUAD, TSSOP-20 |
发布紧急采购，3分钟左右您将得到回复。