- 您现在的位置：买卖IC网 > PDF目录17108 > MCP4725DM-PTPLS (Microchip Technology)BOARD DAUGHTER PICTAIL MCP4725 PDF资料下载
参数资料
| 型号： | MCP4725DM-PTPLS |
| 厂商： | Microchip Technology |
| 文件页数： | 13/50页 |
| 文件大小： | 0K |
| 描述： | BOARD DAUGHTER PICTAIL MCP4725 |
| 标准包装： | 1 |
| DAC 的数量： | 1 |
| 位数： | 12 |
| 采样率（每秒）： | 100k ~ 3.4M |
| 数据接口： | I²C |
| 设置时间： | 6µs |
| DAC 型： | 电压 |
| 工作温度： | -40°C ~ 125°C |
| 已供物品： | 板，CD |
| 已用 IC / 零件： | MCP4725 |
| 产品目录页面： | 673 (CN2011-ZH PDF) |
| 相关产品： | MCP4725A3T-E/CHDKR-ND - IC DAC 12BIT EE W/I2C SOT23-6 MCP4725A2T-E/CHDKR-ND - IC DAC 12BIT EE W/I2C SOT23-6 MCP4725A1T-E/CHDKR-ND - IC DAC 12BIT EE W/I2C SOT23-6 MCP4725A3T-E/CHCT-ND - IC DAC 12BIT EE W/I2C SOT23-6 MCP4725A2T-E/CHCT-ND - IC DAC 12BIT EE W/I2C SOT23-6 MCP4725A1T-E/CHCT-ND - IC DAC 12BIT EE W/I2C SOT23-6 MCP4725A3T-E/CHTR-ND - IC DAC 12BIT EE W/I2C SOT23-6 MCP4725A2T-E/CHTR-ND - IC DAC 12BIT EE W/I2C SOT23-6 MCP4725A1T-E/CHTR-ND - IC DAC 12BIT EE W/I2C SOT23-6 MCP4725A0T-E/CHTR-ND - IC DAC 12BIT W/I2C SOT23A-6 更多... |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页第12页当前第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页第29页第30页第31页第32页第33页第34页第35页第36页第37页第38页第39页第40页第41页第42页第43页第44页第45页第46页第47页第48页第49页第50页
MCP4725
DS22039D-page 20
2009 Microchip Technology Inc.
5.4.2
VDD RAMP RATE AND EEPROM
The MCP4725 uploads the EEPROM data to the DAC
register during power-up sequence. However, if the
VDD ramp rate is too slow ( <1 V/ms), the device may
not be able to load the EEPROM data to the DAC
register. Therefore, the DAC output that is correspond-
ing to the current EEPROM data may not available to
the output pin. It is highly recommended to send a Gen-
eral Call Reset Command (see Section 7.3.1 “Gen-
eral call reset”) after power-up. This command will
reset the device at a stable VDD and make the DAC out-
put available immediately using the EEPROM data.
5.5
Normal and Power-Down Modes
The device has two modes of operation: Normal mode
and power-down mode. The mode is selected by
programming the power-down bits (PD1 and PD0) in
the Configuration register. The user can also program
the two power-down bits in non-volatile EEPROM
memory.
When the normal mode is selected, the device
operates a normal digital-to-analog conversion. If the
power-down mode is selected, the device enters a
power saving condition by shutting down most of the
internal circuits. During the power-down mode, all
internal circuits except the I2C interface are disabled
and there is no data conversion event, and no VOUT is
available. The device also switches the output stage
from the output of the amplifier to a known resistive
load. The value of the resistive load is determined by
the state of the power-down bits (PD1 and PD0).
Table 5-2 shows the outcome of the power-down bit
and the resistive load.
During the power-down mode, the device draws about
60 nA (typical). Although most of internal circuits are
shutdown, the serial interface remains active in order
to receive the I2C command.
The device exits the power-down mode immediately
when (a) it receives a new write command for normal
mode or (b) it receives an I2C General Call Wake-Up
Command.
When the DAC operation mode is changed from
power-down to normal mode, the output settling time
takes less than 10 s, but greater than the standard
Active mode settling time (6 s, typical).
TABLE 5-2:
POWER-DOWN BITS
FIGURE 5-1:
Output Stage for Power-
Down Mode.
PD1
PD0
Function
00
Normal Mode
01
1k resistor to ground (1)
10
100 k resistor to ground (1)
11
500 k resistor to ground (1)
Note 1: In the power-down mode: VOUT is off and
most of internal circuits are disabled.
1k
100 k 500 k
Power-Down
Control Circuit
Resistive
Load
VOUT
OP
Amp
Resistive String DAC
相关PDF资料 |
PDF描述 |
|---|---|
| EEM36DTBD-S189 | CONN EDGECARD 72POS R/A .156 SLD |
| 9410990001 | HEAT SHRINK SLEEVE |
| EEM36DSEI | CONN EDGECARD 72POS .156 EYELET |
| SCRH4D18-4R7 | INDUCTOR SMD 4.7UH 0.84A 100KHZ |
| EEM36DTAN-S189 | CONN EDGECARD 72POS R/A .156 SLD |
相关代理商/技术参数 |
参数描述 |
|---|---|
| MCP4725EV | 功能描述:数据转换 IC 开发工具 MCP4725 Eval Brd RoHS:否 制造商:Texas Instruments 产品:Demonstration Kits 类型:ADC 工具用于评估:ADS130E08 接口类型:SPI 工作电源电压:- 6 V to + 6 V |
| MCP4725T-E/CH | 功能描述:数模转换器- DAC SNGL 12B NV DAC with I2C interface RoHS:否 制造商:Texas Instruments 转换器数量:1 DAC 输出端数量:1 转换速率:2 MSPs 分辨率:16 bit 接口类型:QSPI, SPI, Serial (3-Wire, Microwire) 稳定时间:1 us 最大工作温度:+ 85 C 安装风格:SMD/SMT 封装 / 箱体:SOIC-14 封装:Tube |
| MCP4726A0T-E/CH | 功能描述:数模转换器- DAC Sngl 12B NV DAC w/Ex Vref & I2C interface RoHS:否 制造商:Texas Instruments 转换器数量:1 DAC 输出端数量:1 转换速率:2 MSPs 分辨率:16 bit 接口类型:QSPI, SPI, Serial (3-Wire, Microwire) 稳定时间:1 us 最大工作温度:+ 85 C 安装风格:SMD/SMT 封装 / 箱体:SOIC-14 封装:Tube |
| MCP4726A0T-E/MAY | 功能描述:数模转换器- DAC Sngl 12B NV DAC w/Ex Vref & I2C interface RoHS:否 制造商:Texas Instruments 转换器数量:1 DAC 输出端数量:1 转换速率:2 MSPs 分辨率:16 bit 接口类型:QSPI, SPI, Serial (3-Wire, Microwire) 稳定时间:1 us 最大工作温度:+ 85 C 安装风格:SMD/SMT 封装 / 箱体:SOIC-14 封装:Tube |
| MCP4726A1T-E/CH | 功能描述:数模转换器- DAC Sngl 12B NV DAC w/Ex Vref & I2C interface RoHS:否 制造商:Texas Instruments 转换器数量:1 DAC 输出端数量:1 转换速率:2 MSPs 分辨率:16 bit 接口类型:QSPI, SPI, Serial (3-Wire, Microwire) 稳定时间:1 us 最大工作温度:+ 85 C 安装风格:SMD/SMT 封装 / 箱体:SOIC-14 封装:Tube |
发布紧急采购，3分钟左右您将得到回复。