参数资料
| 型号： | MIC2077-2BWM TR |
| 厂商： | Micrel Inc |
| 文件页数： | 15/17页 |
| 文件大小： | 0K |
| 描述： | IC USB DISTRIB SW QUAD 16-SOIC |
| 标准包装： | 1,000 |
| 类型： | 高端开关 |
| 输出数： | 4 |
| Rds（开）： | 150 毫欧 |
| 内部开关： | 是 |
| 电流限制： | 900mA |
| 输入电压： | 2.7 V ~ 5.5 V |
| 工作温度： | -40°C ~ 85°C |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 16-SOIC（0.295"，7.50mm 宽） |
| 供应商设备封装： | 16-SOIC |
| 包装： | 带卷 (TR) |
| 其它名称： | MIC2077-2BWMTR MIC2077-2BWMTR-ND |
Micrel, Inc.
Application Information
Supply Filtering
A 0.1μF to 1μF bypass capacitor positioned close to V IN
and GND of the device is strongly recommended to
control supply transients. Without a bypass capacitor, an
output short may cause sufficient ringing on the input
(from supply lead inductance) to damage internal control
circuitry.
Printed Circuit Board Hot-Plug
The MIC2027/77 are ideal inrush current-limiters for hot-
plug applications. Due to the integrated charge pump,
the MIC2027/77 present a high impedance when off and
slowly becomes a low impedance as it turns on. This
“soft-start” feature effectively isolates power supplies
from highly capacitive loads by reducing inrush current.
In cases of extremely large capacitive loads (>400μF),
the length of the transient due to inrush current may
exceed the delay provided by the integrated filter. Since
this inrush current exceeds the current-limit flag delay
specification, FLG will be asserted during this time. To
MIC2027/2077
being asserted, an external RC filter, as shown in Figure
3, can be used to filter out transient FLG assertion. The
value of the RC time constant should be selected to
match the length of the transient, less t D(min) of the
MIC2027/77.
Universal Serial Bus (USB) Power Distribution
The MIC2027/77 is ideally suited for USB (Universal
Serial Bus) power distribution applications. The USB
specification defines power distribution for USB host
systems such as PCs and USB hubs. Hubs can either
be self-powered or bus-powered (that is, powered from
the bus). The requirement for USB self-powered hubs is
that the port must supply a minimum of 500mA at an
output voltage of 5V ±5%. In addition, the output power
delivered must be limited to below 25VA. Upon an
overcurrent condition, the host must also be notified. To
support hot-plug events, the hub must have a minimum
of 120μF of bulk capacitance, preferably low ESR
electrolytic or tantulum. Please refer to Application Note
17 for more details on designing compliant USB hub and
host systems.
prevent the logic controller from responding to FLG
Figure 3. Transient Filter
September 2006
15
M9999-091506
相关PDF资料 |
PDF描述 |
|---|---|
| MIC2091-1YM5 TR | IC DISTRIBUTION SW 100MA SOT23-5 |
| MIC2097-2YMT TR | IC DISTRIBUTION SWITCH |
| MIC2124YMM TR | IC REG CTRLR BUCK PWM CM 10-MSOP |
| MIC2131-1YTSE | IC REG CTRLR BUCK PWM VM 16TSSOP |
| MIC2141BM5 TR | IC REG BOOST ADJ 10MA SOT23-5 |
相关代理商/技术参数 |
参数描述 |
|---|---|
| MIC2077-2YM | 功能描述:电源开关 IC - USB Quad USB High-Side Power Switch - Lead Free RoHS:否 制造商:Micrel 电源电压-最小:2.7 V 电源电压-最大:5.5 V 最大工作温度:+ 85 C 最小工作温度:- 40 C 封装 / 箱体:SOIC-8 封装:Tube |
| MIC2077-2YM TR | 功能描述:电源开关 IC - USB Quad USB High-Side Power Switch - Lead Free RoHS:否 制造商:Micrel 电源电压-最小:2.7 V 电源电压-最大:5.5 V 最大工作温度:+ 85 C 最小工作温度:- 40 C 封装 / 箱体:SOIC-8 封装:Tube |
| MIC2077-2YWM | 功能描述:电源开关 IC - USB Quad USB High-Side Power Switch - Lead Free RoHS:否 制造商:Micrel 电源电压-最小:2.7 V 电源电压-最大:5.5 V 最大工作温度:+ 85 C 最小工作温度:- 40 C 封装 / 箱体:SOIC-8 封装:Tube |
| MIC2077-2YWM TR | 功能描述:电源开关 IC - USB Quad USB High-Side Power Switch - Lead Free RoHS:否 制造商:Micrel 电源电压-最小:2.7 V 电源电压-最大:5.5 V 最大工作温度:+ 85 C 最小工作温度:- 40 C 封装 / 箱体:SOIC-8 封装:Tube |
| MIC2085 | 制造商:MICREL 制造商全称:Micrel Semiconductor 功能描述:Single Channel Hot Swap Controllers |
发布紧急采购，3分钟左右您将得到回复。