- 您现在的位置：买卖IC网 > PDF目录13958 > MIC2171WU (Micrel Inc)IC REG MULTI CONFIG 2.5A TO263-5 PDF资料下载
参数资料
| 型号： | MIC2171WU |
| 厂商： | Micrel Inc |
| 文件页数： | 9/12页 |
| 文件大小： | 0K |
| 描述： | IC REG MULTI CONFIG 2.5A TO263-5 |
| 标准包装： | 50 |
| 类型： | 降压（降压），升压（升压），反相，Cuk |
| 输出数： | 1 |
| 输入电压： | 3 V ~ 40 V |
| PWM 型： | 电流模式 |
| 频率 - 开关： | 100kHz |
| 电流 - 输出： | 2.5A |
| 同步整流器： | 无 |
| 工作温度： | -40°C ~ 85°C |
| 安装类型： | 表面贴装 |
| 封装/外壳： | TO-263-6，D²Pak（5 引线+接片），TO-263BA |
| 包装： | 管件 |
| 供应商设备封装： | TO-263-5 |
| 产品目录页面： | 1092 (CN2011-ZH PDF) |
| 其它名称： | 576-1063 |
Micrel, Inc.
For the practical example:
then:
MIC2171
V CE = 65V max. for the MIC2171
F CE = 0.8
a ≤
11.4
7.9
= 1 . 20
then:
V SEC = 5.6V
This ratio is less than the ratio calculated in equation (9).
When specifying the transformer it is necessary to know
a ≤
I PEAK(pri) =
V IN(min) T ON
0.5f SW V IN(min) T ON
I PEAK(pri) =
65 × 0.8 ? 6.0
5.6
a ≤ 8.2 (N PRI /N SEC )
Next, calculate the maximum primary inductance
required to store the needed output energy with a power
switch duty cycle of 55%.
2 2
(10) L PRI ≥
P OUT
where:
L PRI = maximum primary inductance
the primary peak current which must be withstood
without saturating the transformer core.
(13)
L PRI
so:
3.22 × 7.6 × 10 ? 6
L PRI
I PEAK(pri) = 2.1A
Now find the minimum reverse voltage requirement for
the output rectifier. This rectifier must have an average
V IN(max) + (V OUT a)
then:
f SW = device switching frequency (100kHz)
V IN(min) = minimum input voltage
T ON = power switch on time
current rating greater than the maximum output current
of 0.5A.
(14) V BR ≥
F BR a
L PRI ≥
0.5f SW V SEC T OFF
V BR ≥
L SEC ≤
0.5 × 1 × 10 5 × (3.22) 2 × (7.4 × 10 ? 6 )2
2.5
L PRI ≥ 11.4μH
Use a 12μH primary inductance to overcome circuit
inefficiencies.
To complete the design the inductance value of the
secondary is found which will guarantee that the energy
stored in the transformer during the power switch on
time will be completed discharged into the output during
the off-time. This is necessary when operating in
discontinuous-mode.
2 2
(11) L SEC ≤
P OUT
where:
L SEC = maximum secondary inductance
T OFF = power switch off time
then:
0.5 × 1 × 10 5 × (5.41) 2 × (2.6 × 10 ? 6 ) 2
2.5
L SEC ≤ 7.9μH
Finally, recalculate the transformer turns ratio to insure
that it is less than the value earlier found in equation (9).
where:
V BR = output rectifier maximum peak reverse
voltage rating
a = transformer turns ratio (1.2)
F BR = reverse voltage safety derating factor (0.8)
then:
6.0 + (5.0 × 1.2)
0.8 × 1.2
V BR ≥ 12.5V
A 1N5817 will safely handle voltage and current require-
ments in this example.
Forward Converters
Micrel’s MIC2171 can be used in several circuit
configurations to generate an output voltage which is
less than the input voltage (buck or step-down topology).
Figure 6 shows the MIC2171 in a voltage step-down
application. Because of the internal architecture of these
devices, more external components are required to
implement a step-down regulator than with other devices
offered by Micrel (refer to the LM257x or MIC457x family
of buck switchers). However, for step-down conversion
requiring a transformer (forward), the MIC2171 is a good
choice.
A 12V to 5V step-down converter using transformer
(12)
a ≤
L PRI
L SEC
isolation (forward) is shown in Figure 6. Unlike the
isolated flyback converter which stores energy in the
primary inductance during the controller’s on-time and
releases it to the load during the off-time, the forward
converter transfers energy to the output during the on-
May 2007
9
M9999-051107
相关PDF资料 |
PDF描述 |
|---|---|
| EMA18DTKT | CONN EDGECARD 36POS DIP .125 SLD |
| LT1376IS8 | IC REG BUCK ADJ 1.5A 8SOIC |
| LT1572CS#TR | IC REG MULTI CONFIG 1.25A 16SOIC |
| MIC2179-5.0YSM TR | IC REG BUCK SYNC 5V 1.5A 20SSOP |
| MIC2179-3.3YSM TR | IC REG BUCK SYNC 3.3V 20SSOP |
相关代理商/技术参数 |
参数描述 |
|---|---|
| MIC2171WU TR | 功能描述:直流/直流开关调节器 2.5A 100kHz Switching Regulator (ROHS Compliant) RoHS:否 制造商:International Rectifier 最大输入电压:21 V 开关频率:1.5 MHz 输出电压:0.5 V to 0.86 V 输出电流:4 A 输出端数量: 最大工作温度: 安装风格:SMD/SMT 封装 / 箱体:PQFN 4 x 5 |
| MIC2171WU-TR | 功能描述:Buck, Boost, Cuk, Flyback, Forward Converter Switching Regulator IC Positive or Negative, Isolation Capable Adjustable 1 Output 2.5A (Switch) TO-263-6, D2Pak (5 Leads + Tab), TO-263BA 制造商:microchip technology 系列:- 包装:剪切带（CT） 零件状态:有效 功能:升压，降压，升压/降压 输出配置:正或负，可提供隔离 拓扑:降压，升压，Cuk，反激，正激转换器 输出类型:可调式 输出数:1 电压 - 输入（最小值）:3V 电压 - 输入（最大值）:40V 电压 - 输出（最小值/固定）:- 电压 - 输出（最大值）:65V（开关） 电流 - 输出:2.5A（开关） 频率 - 开关:100kHz 同步整流器:无 工作温度:-40°C ~ 85°C（TA） 安装类型:表面贴装 封装/外壳:TO-263-6，D2Pak（5 引线+接片），TO-263BA 供应商器件封装:TO-263-5 标准包装:1 |
| MIC2172 | 制造商:MICREL 制造商全称:Micrel Semiconductor 功能描述:100kHz 1.25A Switching Regulators |
| MIC2172_05 | 制造商:MICREL 制造商全称:Micrel Semiconductor 功能描述:100kHz 1.25A Switching Regulators |
| MIC2172_06 | 制造商:MICREL 制造商全称:Micrel Semiconductor 功能描述:100kHz 1.25A Switching Regulators |
发布紧急采购，3分钟左右您将得到回复。