- 您现在的位置：买卖IC网 > PDF目录14143 > MIC2172YM (Micrel Inc)IC REG MULTI CONFIG 1.25A 8SOIC PDF资料下载
参数资料
| 型号： | MIC2172YM |
| 厂商： | Micrel Inc |
| 文件页数： | 12/20页 |
| 文件大小： | 0K |
| 描述： | IC REG MULTI CONFIG 1.25A 8SOIC |
| 标准包装： | 95 |
| 类型： | 降压（降压），升压（升压），反相，Cuk |
| 输出数： | 1 |
| 输入电压： | 3 V ~ 40 V |
| PWM 型： | 电流模式 |
| 频率 - 开关： | 100kHz |
| 电流 - 输出： | 1.25A |
| 同步整流器： | 无 |
| 工作温度： | -40°C ~ 85°C |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 8-SOIC（0.154"，3.90mm 宽） |
| 包装： | 管件 |
| 供应商设备封装： | 8-SOIC |
Micrel
MIC2172/3172
locked to an external reference frequency. The slaves
lock to the negative (falling edge) of the external
reference waveform.
Soft Start
A diode-coupled capacitor from COMP to circuit ground
slows the output voltage rise at turn on (figure 8).
Figure 8b. Without Soft Start
Figure 8. Soft Start
The additional time it takes for the error amplifier to
charge the capacitor corresponds to the time it takes the
output to reach regulation. Diode D1 discharges C1
when V IN is removed.
Another soft start circuit is shown in figure 8A. The
circuit uses capacitor C1 to control the output risetime by
providing feedback from the output to the FB pin. The
output voltage starts to rise when the MIC3172 regulator
starts switching. This is the dv/dt of the output will force
a current through capacitor C1, which flows through the
lower feedback resistor, R2, increasing the voltage on
the FB pin. This increased voltage on the FB pin
reduces the duty cycle at the V SW pin, limiting the turn-on
time of the output. Increasing the value of C1 causes
the output voltage to rise more slowly. Diode D1 is
reverse biased in normal operation and prevents C1
from appearing in parallel with the upper voltage divider
resistor, which would affect stability and transient
response. Zener diode D2 clamps the voltage seen by
the feedback pin and provides a discharge path for C1
when the power supply is turned off.
Figure 8c. With Soft Start
Current Limit
For designs demanding less output current than the
MIC2172/3172 is capable of delivering, P GND 1 can be
left open reducing the current capability of Q1 by one-
half.
Figure 8a. Additional Soft Start Circuit
This circuit only limits the dv/dt of the output when the
boost converter is running. It will not decrease the dv/dt
or the initial inrush caused by applying the input voltage.
Figure 8B shows the turn-on without a soft start circuit
and Figure 8C shows how the soft start circuit reduces
inrush and prevents output voltage overshoot.
Figure 9. Current Limit
Alternatively, the maximum current limit of the
MIC2172/3172 can be reduced by adding a voltage
April 2006
12
M9999-041806
(408) 955-1690
相关PDF资料 |
PDF描述 |
|---|---|
| VE-BNP-EX-F3 | CONVERTER MOD DC/DC 13.8V 75W |
| GBC60DRYI-S13 | CONN EDGECARD 120POS .100 EXTEND |
| RBB45DHRT | CONN CARD EXTEND 90POS .050" |
| AP1506-K5L-U | IC REG BUCK ADJ 3A TO263-5 |
| VE-BNP-EW-F1 | CONVERTER MOD DC/DC 13.8V 100W |
相关代理商/技术参数 |
参数描述 |
|---|---|
| MIC2172YM TR | 功能描述:直流/直流开关调节器 1.25A 100kHz Switching Regulator (Lead Free) RoHS:否 制造商:International Rectifier 最大输入电压:21 V 开关频率:1.5 MHz 输出电压:0.5 V to 0.86 V 输出电流:4 A 输出端数量: 最大工作温度: 安装风格:SMD/SMT 封装 / 箱体:PQFN 4 x 5 |
| MIC2172YMTR | 制造商:Micrel 功能描述:Current Mode PWM Controller 65V 1.25A |
| MIC2172YM-TR | 制造商:Micrel Inc 功能描述: |
| MIC2172YN | 功能描述:直流/直流开关调节器 2.5A 100kHz Switching Regulator (Lead Free) RoHS:否 制造商:International Rectifier 最大输入电压:21 V 开关频率:1.5 MHz 输出电压:0.5 V to 0.86 V 输出电流:4 A 输出端数量: 最大工作温度: 安装风格:SMD/SMT 封装 / 箱体:PQFN 4 x 5 |
| MIC2174 | 制造商:MICREL 制造商全称:Micrel Semiconductor 功能描述:300kHz, Synchronous Buck Controller 300kHz, Synchronous Buck Controller |
发布紧急采购，3分钟左右您将得到回复。