参数资料
型号: MIC2555-1BML TR
厂商: Micrel Inc
文件页数: 4/29页
文件大小: 0K
描述: IC TXRX UTG USB BUS UNIV 24MLF
标准包装: 1,000
类型: 收发器
驱动器/接收器数: 1/0
规程: USB 2.0
电源电压: 3 V ~ 4.5 V
安装类型: 表面贴装
封装/外壳: 24-VFQFN 裸露焊盘,24-MLF?
供应商设备封装: 24-MLF?(4x4)
包装: 带卷 (TR)
其它名称: MIC2555-1BMLTR
Micrel, Inc.
MIC2555
December 2006
12
M9999-121406
Serial Controller Block
The Serial Controller manages MIC2555 operations.
Turning ON/OFF features, changing operating modes,
setting and selecting interrupts are all handled by the
Serial
Controller.
MIC2555’s
Serial
Controller
communicates with the OTG Controller as an I2C slave
using the SCL and SDA pins.
The Serial Controller includes the following functions:
Control registers
Status registers
Interrupt latches
Interrupt enable registers
Interrupt clear registers
Interrupt generator
VBUS Charge Pump and 5V regulator
The charge pump draws power from VBAT and boosts
the voltage to the requisite 5V to power VBUS. This
subsystem is actually a combination of a charge pump
circuit and a control loop that gates the charge pump’s
oscillator. If the output voltage is below 5V, then the
oscillator is ON; otherwise, the oscillator is gated OFF.
The charge pump’s maximum output is controlled by the
magnitude of VBAT. When VBAT is at 3.0V, the charge
pump is designed to support loads of at least 8 mA on
VBUS. As VBAT increases, the maximum charge pump
output current also increases. For proper operation the
charge pump circuit requires 2 capacitors; one for the
voltage doubler, connected between C- and C+, and a
reservoir/filter capacitor between C++ and ground. The
charge pump’s nominal operating frequency is 200 kHz,
which is set by an on-chip oscillator. A special feature of
MIC2555 is that an external oscillator can drive the
charge pump as well, allowing the designer to shift
radiated noise away from sensitive frequencies when
necessary. Also, when 5V power is not required from
VBUS, the charge pump can be shut down to conserve
power.
Charge Pump
and Regulator
VTRM
3.3V
Cap+
VBUS
Output
Enable
Charge
VBUS
2.3k
VBUS
4.4V
1.4V
0.5V
VBUS
Valid
Session
Valid
Session
End
Cap-
Cap++
2.3k
68k
Discharge
VBUS
VBAT
VBUS Circuitry
VBUS Resistors and Switches
MIC2555 is able to:
charge up VBUS through a resistor
initiate SRP
pull down VBUS through a resistor to ground
discharge VBUS before initiating SRP
switch VBUS power from the charge pump ON/OFF
Dedicated bits in the control registers control all of these
functions. Because these bits act independently, it is
possible to have VBUS both charging and discharging at
the same time. This situation will not harm the MIC2555.
To prevent system leakage currents from biasing VBUS
to a voltage that would mimic a session valid condition,
the MIC2555 maintains a 68K resistor between VBUS
and ground to insure that at no time will VBUS assume a
floating condition.
相关PDF资料
PDF描述
MIC3000BML TR IC TXRX OPTICAL MANAGEMENT 24MLF
MIC3001BML TR IC FOM MANAGEMENT W/CALIBR 24MLF
MIC74BQS TR IC I/O EXPANDER I2C 8B 16QSOP
MICRF302YML TR IC ENCODER PAR QWIKRADIO 10-MLF
MK10DN512ZVLL10 IC ARM CORTEX MCU 512KB 100LQFP
相关代理商/技术参数
参数描述
MIC2555-1YML 制造商:Rochester Electronics LLC 功能描述: 制造商:RF Micro Devices Inc 功能描述:
MIC2555-1YML TR 功能描述:USB 接口集成电路 USB Transceiver - Lead Free RoHS:否 制造商:Cypress Semiconductor 产品:USB 2.0 数据速率: 接口类型:SPI 工作电源电压:3.15 V to 3.45 V 工作电源电流: 最大工作温度:+ 85 C 安装风格:SMD/SMT 封装 / 箱体:WLCSP-20
MIC2555-1YML-TR 功能描述:1/1 Transceiver Half USB 2.0 24-MLF? (4x4) 制造商:microchip technology 系列:- 包装:剪切带(CT) 零件状态:有效 类型:收发器 协议:USB 2.0 驱动器/接收器数:1/1 双工:半 接收器滞后:200mV 数据速率:400kbps 电压 - 电源:3 V ~ 4.5 V 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:24-VFQFN 裸露焊盘,24-MLF? 供应商器件封装:24-MLF?(4x4) 标准包装:1
MIC2557BM 制造商:Micrel Inc 功能描述: 制造商:Micron Technology Inc 功能描述: 制造商:Micrel Inc 功能描述:IC PCMCIA SOCKET SWITCHING MATRIX, SOIC8, IC Interface Type:-, Interface Applica
MIC2558BM 制造商:Micrel Inc 功能描述:PCMCIA Card Socket 14-Pin SOIC 制造商:Rochester Electronics LLC 功能描述:- Bulk