参数资料
| 型号： | MIC29151-3.3WU TR |
| 厂商： | Micrel Inc |
| 文件页数： | 20/25页 |
| 文件大小： | 0K |
| 描述： | IC REG LDO 3.3V 1.5A TO-263-5 |
| 标准包装： | 750 |
| 稳压器拓扑结构： | 正，固定式 |
| 输出电压： | 3.3V |
| 输入电压： | 最高 26V |
| 电压 - 压降（标准）： | 0.35V @ 1.5A |
| 稳压器数量： | 1 |
| 电流 - 输出： | 1.5A |
| 工作温度： | -40°C ~ 125°C |
| 安装类型： | 表面贴装 |
| 封装/外壳： | TO-263-6，D²Pak（5 引线+接片），TO-263BA |
| 供应商设备封装： | TO-263-5 |
| 包装： | 带卷 (TR) |
| 其它名称： | MIC29151-3.3WUTR MIC29151-3.3WUTR-ND |
Micrel, Inc.
For example, given an expected maximum ambient
temperature (T A ) of 75 ° C with V IN = 3.3V, V OUT = 2.5V,
and I OUT = 1.5A, first calculate the expected P D using
Equation 3:
P D =(3.3V–2.5V)1.5A–(3.3V)(0.016A)=1.1472W
Eq. 3
Next, calcualte the junction temperature for the expected
power dissipation.
MIC29150/29300/29500/29750
Where the regulator is powered from a source with high
AC impedance, a 0.1μF capacitor connected between
Input and GND is recommended. This capacitor should
have good characteristics to above 250kHz.
Minimum Load Current
The MIC29150–29750 regulators are specified between
finite loads. If the output current is too small, leakage
currents dominate and the output voltage rises. The
following minimum load current swamps any expected
leakage current across the operating temperature range,
as shown in Table 2:
T J =( θ JA ×P D )+T A =(56 ° C/W×1.1472W)+75 ° C
=139.24 ° C
Eq. 4
Device
MIC29150
MIC29300
Minimum Load
5mA
7mA
Now determine the maximum power dissipation allowed
that would not exceed the IC’s maximum junction
MIC29500
MIC29750
10mA
10mA
temperature (125 ° C) without the useof a heat sink by:
Table 2. Minimum Load Currents
P D(MAX) = (T J(MAX) –T A )/ θ JA
= (125 ° C–75 ° C)/(56 ° C/W) = 0.893W
Capacitor Requirements
Eq. 5
Adjustable Regulator Design
The adjustable regulator versions, MIC29xx2 and
MIC29xx3, allow programming the output voltage
anywhere between 1.25V and the 25V. Two resistors are
used. The resistor values are calculated by Equation 6:
R 1 = R 2 × ? ? OUT ? 1 ? ?
For stability and minimum output noise, a capacitor on
the regulator output is necessary. The value of this
capacitor is dependent upon the output current; lower
currents allow smaller capacitors. The
? V ?
? 1.240 ?
Eq. 6
MIC29150/29300/29500/29750 regulators are stable
with the following minimum capacitor values at full load,
as noted in Table 1:
where V OUT is the desired output voltage. Figure 4 shows
component definition. Applications with widely varying
load currents may scale the resistors to draw the
Device
MIC29150
MIC29300
MIC29500
MIC29750
Full Load Capacitor
10μF
10μF
10μF
22μF
minimum load current required for proper operation (see
“Minimum Load Current” sub-section).
Table 1. Minimum Capacitor Values at Full Load
This capacitor need not be an expensive low ESR type:
aluminum electrolytics are adequate. In fact, extremely
low ESR capacitors may contribute to instability.
Tantalum capacitors are recommended for systems
where fast load transient response is important.
December 2012
20
M9999-122012-B
相关PDF资料 |
PDF描述 |
|---|---|
| GMM28DTBT-S189 | CONN EDGECARD 56POS R/A .156 SLD |
| GSM28DTAT-S189 | CONN EDGECARD 56POS R/A .156 SLD |
| LT3050EDDB#TRPBF | IC REG LDO ADJ .1A 12DFN |
| HCC36DRYS-S734 | CONN EDGECARD 72POS DIP .100 SLD |
| GMM28DTAT-S189 | CONN EDGECARD 56POS R/A .156 SLD |
相关代理商/技术参数 |
参数描述 |
|---|---|
| MIC29151-4.2BT | 功能描述:IC REG LDO 4.2V 1.5A TO-220-5 RoHS:否 类别:集成电路 (IC) >> PMIC - 稳压器 - 线性 系列:- 标准包装:3,000 系列:- 稳压器拓扑结构:正，固定式 输出电压:3.8V 输入电压:最高 16V 电压 - 压降（标准）:0.3V @ 80mA 稳压器数量:1 电流 - 输出:80mA 电流 - 限制（最小）:- 工作温度:-40°C ~ 125°C 安装类型:表面贴装 封装/外壳:SC-74A，SOT-753 供应商设备封装:SOT-23-5 包装:带卷 (TR) 其它名称:MIC5203-3.8BM5TRMIC5203-3.8BM5TR-ND |
| MIC29151-4.2BU | 功能描述:IC REG LDO 4.2V 1.5A TO-263-5 RoHS:否 类别:集成电路 (IC) >> PMIC - 稳压器 - 线性 系列:- 标准包装:3,000 系列:- 稳压器拓扑结构:正，固定式 输出电压:3.8V 输入电压:最高 16V 电压 - 压降（标准）:0.3V @ 80mA 稳压器数量:1 电流 - 输出:80mA 电流 - 限制（最小）:- 工作温度:-40°C ~ 125°C 安装类型:表面贴装 封装/外壳:SC-74A，SOT-753 供应商设备封装:SOT-23-5 包装:带卷 (TR) 其它名称:MIC5203-3.8BM5TRMIC5203-3.8BM5TR-ND |
| MIC29151-5.0BT | 功能描述:IC REG LDO 5V 1.5A TO220-5 RoHS:否 类别:集成电路 (IC) >> PMIC - 稳压器 - 线性 系列:- 标准包装:3,000 系列:- 稳压器拓扑结构:正，固定式 输出电压:3.8V 输入电压:最高 16V 电压 - 压降（标准）:0.3V @ 80mA 稳压器数量:1 电流 - 输出:80mA 电流 - 限制（最小）:- 工作温度:-40°C ~ 125°C 安装类型:表面贴装 封装/外壳:SC-74A，SOT-753 供应商设备封装:SOT-23-5 包装:带卷 (TR) 其它名称:MIC5203-3.8BM5TRMIC5203-3.8BM5TR-ND |
| MIC29151-5.0BT L3 | 制造商:Micrel Inc 功能描述:LDO Regulator Pos 5V 1.5A 5-Pin(5+Tab) TO-220 T/R |
| MIC29151-5.0BU | 功能描述:IC REG LDO 5V 1.5A TO263-5 RoHS:否 类别:集成电路 (IC) >> PMIC - 稳压器 - 线性 系列:- 标准包装:3,000 系列:- 稳压器拓扑结构:正，固定式 输出电压:3.8V 输入电压:最高 16V 电压 - 压降（标准）:0.3V @ 80mA 稳压器数量:1 电流 - 输出:80mA 电流 - 限制（最小）:- 工作温度:-40°C ~ 125°C 安装类型:表面贴装 封装/外壳:SC-74A，SOT-753 供应商设备封装:SOT-23-5 包装:带卷 (TR) 其它名称:MIC5203-3.8BM5TRMIC5203-3.8BM5TR-ND |
发布紧急采购，3分钟左右您将得到回复。