参数资料
型号: MIC3172YM TR
厂商: Micrel Inc
文件页数: 11/20页
文件大小: 0K
描述: IC REG MULTI CONFIG 1.25A 8SOIC
标准包装: 2,500
类型: 降压(降压),升压(升压),反相,Cuk
输出数: 1
输入电压: 3 V ~ 40 V
PWM 型: 电流模式
频率 - 开关: 100kHz
电流 - 输出: 1.25A
同步整流器:
工作温度: -40°C ~ 85°C
安装类型: 表面贴装
封装/外壳: 8-SOIC(0.154",3.90mm 宽)
包装: 带卷 (TR)
供应商设备封装: 8-SOIC
其它名称: MIC3172YMTR
MIC3172YMTR-ND
Micrel
Application Information
Using the MIC3172 Enable Control (New Designs)
For new designs requiring enable/shutdown control,
connect EN to a TTL or CMOS control signal (figure 3).
The very low driver current requirement ensures
compatibility regardless of the driver or gate used.
Figure 3. MIC3172 TTL Enable/Shutdown
Using the MIC3172 in LT1172 Applications
MIC2172/3172
By using the MIC3172, U1 and Q1 shown in figure 5 can
be eliminated, reducing the total components count.
Synchronizing the MIC2172
Using several unsynchronized switching regulators in the
same circuit will cause beat frequencies to appear on the
inputs and outputs. These beat frequencies can be very
low making them difficult to filter.
Micrel’s MIC2172 can be synchronized to a single
master frequency avoiding the possibility of undesirable
beat frequencies in multiple regulator circuits. The
master frequency can be an external oscillator or a
designated master MIC2172. The master frequency
should be 1.05 to 1.20 times the slave’s 100kHz nominal
frequency to guarantee synchronization.
The MIC3172 can be used in most original LT1172
applications by adapting the MIC3172’s
enable/shutdown feature to the existing LT1172 circuit.
Unlike the LT1172 which can be shutdown by reducing
the voltage on pin 2 (V C ) below 0.15V, the MIC3172 has
a dedicated enable/shutdown pin. To replace the
LT1172 with the MIC3172, determine if the LT1172’s
shutdown feature is used.
Circuits without Shutdown
If the shutdown feature is not being used, connect EN to
V IN to continuously enable the MIC3172 or use an
MIC2172 with SYNC open (figure 4).
Figure 6. Master/Slave Synchronization
Figure 6 shows a typical application where several
MIC2172s operate from the same supply voltage. U1’s
oscillator frequency is increased above U2’s and U3’s by
connecting a resistor from SYNC to ground. U2-SYNC
and U3-SYNC are capacitively coupled to the master’s
Figure 4. MIC2172/3172 Always Enabled
Circuits with Shutdown
output (V SW ). The slaves lock to the negative (falling
edge) of U1’s output waveform.
If shutdown was used in the original LT1172 application,
connect EN to a logic gate that produces a TTL logic-
level output signal that matches the shutdown signal.
The MIC3172 will be enabled by a logic-high input and
shutdown with a logic-low input (figure 5). The actual
components performing the functions of U1 and Q1 may
vary according to the original application.
Figure 7. External Synchronization
Care must be exercised to insure that the master
MIC2172 is always operating in continuous mode.
Figure 5. Adapting to the LT1172 Socket
Figure 7 shows how one or more MIC2172s can be
April 2006
11
M9999-041806
(408) 955-1690
相关PDF资料
PDF描述
HM66-10220LFTR7 INDUCTOR 22UH LOW PROFILE SMD
VI-JWB-CZ-F2 CONVERTER MOD DC/DC 95V 25W
VI-JWB-CZ-F1 CONVERTER MOD DC/DC 95V 25W
HM66-10150LFTR7 INDUCTOR 15UH LOW PROFILE SMD
HM66-10100LFTR7 INDUCTOR 10UH LOW PROFILE SMD
相关代理商/技术参数
参数描述
MIC3172YN 功能描述:直流/直流开关调节器 1.25A 100kHz Switching Regulator (Lead Free) RoHS:否 制造商:International Rectifier 最大输入电压:21 V 开关频率:1.5 MHz 输出电压:0.5 V to 0.86 V 输出电流:4 A 输出端数量: 最大工作温度: 安装风格:SMD/SMT 封装 / 箱体:PQFN 4 x 5
MIC3201 制造商:MICREL 制造商全称:Micrel Semiconductor 功能描述:High Brightness LED Driver with High-Side Current Sense
MIC3201_11 制造商:MICREL 制造商全称:Micrel Semiconductor 功能描述:High Brightness LED Driver with High-Side Current Sense
MIC3201YME 功能描述:LED照明驱动器 HBLED Driver with High-Side Current Sense RoHS:否 制造商:STMicroelectronics 输入电压:11.5 V to 23 V 工作频率: 最大电源电流:1.7 mA 输出电流: 最大工作温度: 安装风格:SMD/SMT 封装 / 箱体:SO-16N
MIC3201YME EV 制造商:Micrel Inc 功能描述: