- 您现在的位置：买卖IC网 > PDF目录22289 > MIC5190BMM (Micrel Inc)IC REG CTRLR SGL POS ADJ 10MSOP PDF资料下载
参数资料
| 型号： | MIC5190BMM |
| 厂商： | Micrel Inc |
| 文件页数： | 11/13页 |
| 文件大小： | 463K |
| 描述： | IC REG CTRLR SGL POS ADJ 10MSOP |
| 标准包装： | 100 |
| 类型： | 正，可调式 |
| 输出数： | 1 |
| 输出电压： | 可调 |
| 电流 - 电源： | 15mA |
| 输入电压： | 0.9 V ~ 5.5 V |
| 工作温度： | -40°C ~ 125°C |
| 封装/外壳： | 10-TFSOP，10-MSOP（0.118"，3.00mm 宽） |
| 供应商设备封装： | 10-MSOP |
| 包装： | 管件 |
MIC5190
Micrel
Feedback Resistors
IR3716S
R1
COUT
R2
FB
GND
MIC5190
V
OUT
Figure 10. Adjustable Output
The feedback resistors adjust the output to the desired
voltage and can be calculated as follows:
V V
R1
R2
OUT
REF
=
+
?/DIV>
?/DIV>
?/DIV>
?/DIV>
?/DIV>
?/DIV>
1
V
REF
is equal to 0.5V for the MIC5190. The minimum output
voltage (R1=0) is 0.5V. For output voltages greater than 1V,
use the MIC5191.
The resistor tolerance adds error to the output voltage. These
errors are accumulative for both R1 and R2. For example, our
resistors selected have a ?% tolerance. This will contribute
to a ?% additional error on the output voltage.
The feedback resistors must also be small enough to allow
enough current to the feedback node. Large feedback resis-
tors will contribute to output voltage error.
V
R1 I
V
1k 1 A
V
mV
ERROR
FB
ERROR
ERROR
= ?/DIV>
=
?nbsp ?/DIV>
=
& 2
12
For our example application, this will cause an increase in
output voltage of 12mV. For the percentage increase,
V
V
V
V
12mV
1.5V
V
ERROR
ERROR
OUT
ERROR
ERROR
%
%
% . %
=
?/DIV>
=
?/DIV>
=
100
100
0 8
By reducing R1 to 100&, the error contribution by the feed-
back resistors and feedback current is reduced to less than
0.1%. This is the reason R1 should not be greater than 100&.
Applying the MIC5190
Linear Regulator
The primary purpose of the MIC5190 is as a linear regulator,
which enables an input supply voltage to drop down through
the resistance of the pass element to a regulated output
voltage.
Active Filter
Another application for the MIC5190 is as an active filter on
the output of a switching regulator. This improves the power
supply in several ways.
First, using the MIC5190 as a filter on the output can signifi-
cantly reduce high frequency noise. Switching power sup-
plies tends to create noise at the switching frequency in the
form of a triangular voltage ripple. High frequency noise is
also created by the high-speed switching transitions. A lot of
time, effort , and money are thrown into the design of
switching regulators to minimize these effects as much as
possible. Figure 9 shows the MIC5190 as a post regulator.
Figure 11. Ripple Reduction
Figure 11 shows the amount of ripple reduction for a 500 kHz
switching regulator. The fundamental switching frequency is
reduced from greater than 100mV to less than 10mV.
Figure 12. 10A Load Transient
The transient response also contributes to the overall AC
output voltage deviation. Figure 12 shows a 1A to 10A load
transient. The top trace is the output of the switching regulator
(same circuit as Figure10). The output voltage undershoots
by 100mV. Just by their topology, linear regulators have the
ability to respond at much higher speeds than a switching
regulator. Linear regulators do not have the limitation or
restrictions of switching regulators which must reduce their
bandwidth to less than their switching frequency.
TIME (100祍/div)
TIME (1祍/div)
V
OUT
= 1V
I
LOAD
= 10A
December 2005
11 M9999-120105
相关PDF资料 |
PDF描述 |
|---|---|
| R12P209D/P/R8 | CONV DC/DC 2W 12VIN +/-09VOUT |
| TH3C476M6R3E0800 | CAP TANT 47UF 6.3V 20% 2312 |
| LT1577CS-ADJ/ADJ#TR | IC REG CTRLR DUAL POS ADJ 16SOIC |
| H7MMH-1506G | CABLE D-SUB-HMP15H/AE15G/HMP15H |
| RPR50-11005S-F | CONV DC/DC 50W 40-160VIN 05VOUT |
相关代理商/技术参数 |
参数描述 |
|---|---|
| MIC5190BMM TR | 功能描述:IC REG CTRLR SGL POS ADJ 10-MSOP RoHS:否 类别:集成电路 (IC) >> PMIC - 稳压器 - 线性晶体管驱动器 系列:- 产品培训模块:More Information on LDOs 标准包装:2,500 系列:- 类型:正，固定式 输出数:2 输出电压:2.8V，3.3V 电流 - 电源:12mA 输入电压:5 V ~ 22 V 工作温度:0°C ~ 70°C 封装/外壳:16-SOIC（0.154"，3.90mm 宽） 供应商设备封装:16-SOIC 包装:带卷 (TR) |
| MIC5190YML | 制造商:MICREL 制造商全称:Micrel Semiconductor 功能描述:Ultra High-Speed, High-Current Active Filter/LDO Controller |
| MIC5190YML TR | 功能描述:低压差控制器 - LDO Ultra Hi-Speed Hi-Current Active Filter/LDO Controller(Lead Free) RoHS:否 制造商:Micrel 最大输入电压:5.5 V 输出电压:Adjustable 输出电流:10 mA 负载调节: 输出类型:Adjustable, Fixed 输出端数量:1 最大工作温度:+ 125 C 安装风格:SMD/SMT 封装 / 箱体:SOT-23-6 |
| MIC5190YMM | 功能描述:低压差控制器 - LDO Ultra Hi-Speed Hi-Current Active Filter/LDO Controller(Lead Free) RoHS:否 制造商:Micrel 最大输入电压:5.5 V 输出电压:Adjustable 输出电流:10 mA 负载调节: 输出类型:Adjustable, Fixed 输出端数量:1 最大工作温度:+ 125 C 安装风格:SMD/SMT 封装 / 箱体:SOT-23-6 |
| MIC5190YMM TR | 功能描述:低压差控制器 - LDO Ultra Hi-Speed Hi-Current Active Filter/LDO Controller(Lead Free) RoHS:否 制造商:Micrel 最大输入电压:5.5 V 输出电压:Adjustable 输出电流:10 mA 负载调节: 输出类型:Adjustable, Fixed 输出端数量:1 最大工作温度:+ 125 C 安装风格:SMD/SMT 封装 / 箱体:SOT-23-6 |
发布紧急采购，3分钟左右您将得到回复。