参数资料
| 型号： | MIC5205-2.8YM5 TR |
| 厂商： | Micrel Inc |
| 文件页数： | 9/10页 |
| 文件大小： | 0K |
| 描述： | IC REG LDO 2.8V .15A SOT23-5 |
| 标准包装： | 1 |
| 稳压器拓扑结构： | 正，固定式 |
| 输出电压： | 2.8V |
| 输入电压： | 最高 16V |
| 电压 - 压降（标准）： | 0.165V @ 150mA |
| 稳压器数量： | 1 |
| 电流 - 输出： | 150mA |
| 工作温度： | -40°C ~ 125°C |
| 安装类型： | 表面贴装 |
| 封装/外壳： | SC-74A，SOT-753 |
| 供应商设备封装： | SOT-23-5 |
| 包装： | 标准包装 |
| 产品目录页面： | 1097 (CN2011-ZH PDF) |
| 其它名称： | 576-2736-6 |
V OUT = 1.242V × ?
+ 1 ?
Micrel
V IN(max) = 6.23V
Therefore, a 3.3V application at 150mA of output current
can accept a maximum input voltage of 6.2V in a SOT-
23-5 package. For a full discussion of heat sinking and
thermal effects on voltage regulators, refer to the
Regulator Thermals section of Micrel’s Designing with
Low-Dropout Voltage Regulators handbook.
Fixed Regulator Applications
MIC5205
resistors set the output voltage based on the following
equation:
? R2 ?
? R1 ?
This equation is correct due to the configuration of the
bandgap reference. The bandgap voltage is relative to
the output, as seen in the block diagram. Traditional
regulators normally have the reference voltage relative
to ground and have a different V OUT equation.
Resistor values are not critical because ADJ (adjust) has
a high input impedance, but for best results use resistors
of 470k ? or less. A capacitor from ADJ to ground
provides greatly improved noise performance.
Figure 1. Ultra-Low-Noise Fixed Voltage Application
Figure 1 includes a 470pF capacitor for low-noise
operation and shows EN (pin 3) connected to IN (pin 1)
for an application where enable/shutdown is not
required. C OUT = 2.2μF minimum.
Figure 3. Ultra-Low-Noise
Adjustable Voltage Application
Figure 3 includes the optional 470pF noise bypass
capacitor from ADJ to GND to reduce output noise.
Figure 2. Low-Noise Fixed Voltage Application
Figure 2 is an example of a low-noise configuration
where C BYP is not required. C OUT = 1μF minimum.
Adjustable Regulator Applications
The MIC5205BM5 can be adjusted to a specific output
voltage by using two external resistors (Figure 3). The
Dual-Supply Operation
When used in dual supply systems where the regulator
load is returned to a negative supply, the output voltage
must be diode clamped to ground.
February 2006
9
M9999-020806
(408) 955-1690
相关PDF资料 |
PDF描述 |
|---|---|
| MIC5205-3.2YM5 TR | IC REG LDO 3.2V .15A SOT23-5 |
| FSM10DSEF-S243 | CONN EDGECARD 20POS .156 EYELET |
| NCP512SQ50T2G | IC REG LDO 5V .2A SC88A |
| LT3008ETS8-5#TRPBF | IC REG LDO 5V 20MA TSOT23-8 |
| RYM40DTBS-S189 | CONN EDGECARD 80POS R/A .156 SLD |
相关代理商/技术参数 |
参数描述 |
|---|---|
| MIC5205-3.0BM5 | 制造商:Rochester Electronics LLC 功能描述:- Bulk |
| MIC5205-3.0BM5 TR | 功能描述:IC REG LDO 3V .15A SOT23-5 RoHS:否 类别:集成电路 (IC) >> PMIC - 稳压器 - 线性 系列:- 标准包装:3,000 系列:- 稳压器拓扑结构:正，固定式 输出电压:3.8V 输入电压:最高 16V 电压 - 压降（标准）:0.3V @ 80mA 稳压器数量:1 电流 - 输出:80mA 电流 - 限制（最小）:- 工作温度:-40°C ~ 125°C 安装类型:表面贴装 封装/外壳:SC-74A，SOT-753 供应商设备封装:SOT-23-5 包装:带卷 (TR) 其它名称:MIC5203-3.8BM5TRMIC5203-3.8BM5TR-ND |
| MIC5205-3.0YM5 | 制造商:Rochester Electronics LLC 功能描述: 制造商:RF Micro Devices Inc 功能描述: 制造商:Micrel Inc 功能描述: |
| MIC5205-3.0YM5 TR | 功能描述:低压差稳压器 - LDO 150mA 1% Low Noise LDO (Lead Free) RoHS:否 制造商:Texas Instruments 最大输入电压:36 V 输出电压:1.4 V to 20.5 V 回动电压（最大值）:307 mV 输出电流:1 A 负载调节:0.3 % 输出端数量: 输出类型:Fixed 最大工作温度:+ 125 C 安装风格:SMD/SMT 封装 / 箱体:VQFN-20 |
| MIC5205-3.0YM5G11 | 制造商:Micrel 功能描述:The Micrel MIC5205-3.0YM5G11 is a 150mA Low Dropout Voltage Regulator. |
发布紧急采购，3分钟左右您将得到回复。