- 您现在的位置：买卖IC网 > PDF目录19612 > MIC5249-1.8BMM TR (Micrel Inc)IC REG LDO 1.8V .3A 8-MSOP PDF资料下载
参数资料
| 型号： | MIC5249-1.8BMM TR |
| 厂商： | Micrel Inc |
| 文件页数： | 5/7页 |
| 文件大小： | 0K |
| 描述： | IC REG LDO 1.8V .3A 8-MSOP |
| 标准包装： | 2,500 |
| 稳压器拓扑结构： | 正，固定式 |
| 输出电压： | 1.8V |
| 输入电压： | 2.7 V ~ 6 V |
| 电压 - 压降（标准）： | 0.34V @ 300mA |
| 稳压器数量： | 1 |
| 电流 - 输出： | 300mA |
| 电流 - 限制（最小）： | 300mA |
| 工作温度： | -40°C ~ 125°C |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 8-TSSOP，8-MSOP（0.118"，3.00mm 宽） |
| 供应商设备封装： | 8-MSOP |
| 包装： | 带卷 (TR) |
| 其它名称： | MIC5249-1.8BMMTR MIC5249-1.8BMMTR-ND |
Micrel, Inc.
Application Information
Enable/Shutdown
MIC5249
The capacitor value required can be easily calculated
using the formula:
C DELAY = ? ? DELAY
? ?
The MIC5249 comes with an active-high enable pin that
allows the regulator to be disabled. Forcing the enable
pin low disables the regulator and sends it into a “zero”
off-mode-current state. In this state, current consumed
? T × I DELAY
? V DELAY
?
?
by the regulator goes nearly to zero. Forcing the enable
pin high enables the output voltage. This part is CMOS
and the enable pin cannot be left floating; a floating
enable pin may cause an indeterminate state on the
output.
Input Capacitor
The MIC5249 is a high-performance, high-bandwidth
device. Therefore, it requires a well-bypassed input
supply for optimal performance. A 1.0μF capacitor is
required from the input to ground to provide stability.
Low-ESR ceramic capacitors provide optimal
performance at a minimum of space. Additional high-
frequency capacitors such as small valued NPO
dielectric type capacitors help to filter out high frequency
noise and are good practice in any RF-based circuit.
Output Capacitor
The MIC5249 requires an output capacitor of 2.2μF or
greater to maintain stability. The design is optimized for
use with low-ESR ceramic chip capacitors. High-ESR
capacitors may cause high frequency oscillation. The
maximum recommended ESR is 300m ? . The output
capacitor can be increased, but performance has been
optimized for a 2.2μF ceramic output capacitor and does
not improve significantly with larger capacitance.
X7R/X5R dielectric-type ceramic capacitors are
recommended because of their temperature
performance. X7R-type capacitors change capacitance
by 15% over their operating temperature range and are
the most stable type of ceramic capacitors. Z5U and
Y5V dielectric capacitors change value by as much as
50% and 60%, respectively, over their operating
temperature ranges. To use a ceramic chip capacitor
with Y5V dielectric, the value must be much higher than
anX7R ceramic capacitor to ensure the same minimum
capacitance over the equivalent operating temperature
range.
DELAY Pin Input
The power-on-reset (POR) function can be implemented
on the MIC5249 by adding an external capacitor from
the DELAY pin to ground. This external capacitor sets
the delay time (T DELAY ) of the RESET output.
where I DELAY is 0.55μA and the V DELAY is 1.4V. When no
capacitor is used, there will be no delay and the POR
output acts like a standard error FLAG output.
RESET Output
The RESET output of the MIC5249 provides the power-
on reset signal based on the capacitor from the DELAY
pin to ground when input power is applied to the
regulator. The reset signal stays low for a preset time
period after power is applied to the regulator, and then
goes high.
The reset output is an active-low, open-drain output that
drives low when a fault condition AND an undervoltage
detection occurs. Internal circuitry intelligently monitors
overcurrent, overtemperature and dropout conditions
and ORs these outputs together to indicate some fault
condition. The output of that OR gate is ANDed with an
output voltage monitor that detects an undervoltage
condition. The output drives an open-drain transistor to
indicate a fault. This prevents chattering or inadvertent
triggering of the reset. There set must be pulled up using
a resistor form the RESET pin to either the input or the
output.
Bypass Pin Input
A bypass capacitor is required from the noise bypass pin
to ground to reduce output voltage noise. The capacitor
bypasses the internal reference. A 0.01μF capacitor is
recommended for applications that require low-noise
outputs. The bypass capacitor can be increased, further
reducing noise and improving PSRR. Turn-on time
increases slightly with respect to bypass capacitance. A
unique quick-start circuit allows the MIC5249 to drive a
large capacitor on the bypass pin without significantly
slowing the turn-on time.
Active Shutdown
The MIC5249 also features an active shutdown clamp,
which is a N-Channel MOSFET that turns on when the
device is disabled. This allows the output capacitor and
load to discharge, de-energizing the load.
No-Load Stability
The MIC5249 will remain stable and in regulation with no
load unlike many other voltage regulators. This is
especially important in CMOS RAM keep-alive
application.
March 2012
5
M9999-030812
相关PDF资料 |
PDF描述 |
|---|---|
| GCM10DTAN-S189 | CONN EDGECARD 20POS R/A .156 SLD |
| ISPLSI 5512VE-125LF388 | IC PLD ISP 256I/O 7.5NS 388FPBGA |
| UM-4NPA/2SK | BATT SUPER HEAVY DUTY AAA SIZE |
| ABC36DRYN | CONN EDGECARD 72POS .100 DIP SLD |
| GEM06DRXS | CONN EDGECARD 12POS DIP .156 SLD |
相关代理商/技术参数 |
参数描述 |
|---|---|
| MIC5249-2.5BMM | 功能描述:IC REG LDO 2.5V .3A 8-MSOP RoHS:否 类别:集成电路 (IC) >> PMIC - 稳压器 - 线性 系列:- 标准包装:500 系列:- 稳压器拓扑结构:正，固定式 输出电压:12V 输入电压:14.5 V ~ 35 V 电压 - 压降（标准）:- 稳压器数量:1 电流 - 输出:500mA 电流 - 限制（最小）:- 工作温度:-40°C ~ 125°C 安装类型:通孔 封装/外壳:TO-205AD，TO-39-3 金属罐 供应商设备封装:TO-39 包装:散装 其它名称:*LM78M12CH*LM78M12CH/NOPBLM78M12CH |
| MIC5249-2.5BMM TR | 功能描述:IC REG LDO 2.5V .3A 8-MSOP RoHS:否 类别:集成电路 (IC) >> PMIC - 稳压器 - 线性 系列:- 标准包装:500 系列:- 稳压器拓扑结构:正，固定式 输出电压:12V 输入电压:14.5 V ~ 35 V 电压 - 压降（标准）:- 稳压器数量:1 电流 - 输出:500mA 电流 - 限制（最小）:- 工作温度:-40°C ~ 125°C 安装类型:通孔 封装/外壳:TO-205AD，TO-39-3 金属罐 供应商设备封装:TO-39 包装:散装 其它名称:*LM78M12CH*LM78M12CH/NOPBLM78M12CH |
| MIC5249-2.5YMM | 功能描述:低压差稳压器 - LDO 300mA uCapl LDO with Reset(Lead Free) RoHS:否 制造商:Texas Instruments 最大输入电压:36 V 输出电压:1.4 V to 20.5 V 回动电压（最大值）:307 mV 输出电流:1 A 负载调节:0.3 % 输出端数量: 输出类型:Fixed 最大工作温度:+ 125 C 安装风格:SMD/SMT 封装 / 箱体:VQFN-20 |
| MIC5249-2.5YMM TR | 功能描述:低压差稳压器 - LDO 300mA uCapl LDO with Reset(Lead Free) RoHS:否 制造商:Texas Instruments 最大输入电压:36 V 输出电压:1.4 V to 20.5 V 回动电压（最大值）:307 mV 输出电流:1 A 负载调节:0.3 % 输出端数量: 输出类型:Fixed 最大工作温度:+ 125 C 安装风格:SMD/SMT 封装 / 箱体:VQFN-20 |
| MIC5249-2.6BMM | 功能描述:IC REG LDO 2.6V .3A 8-MSOP RoHS:否 类别:集成电路 (IC) >> PMIC - 稳压器 - 线性 系列:- 标准包装:500 系列:- 稳压器拓扑结构:正，固定式 输出电压:12V 输入电压:14.5 V ~ 35 V 电压 - 压降（标准）:- 稳压器数量:1 电流 - 输出:500mA 电流 - 限制（最小）:- 工作温度:-40°C ~ 125°C 安装类型:通孔 封装/外壳:TO-205AD，TO-39-3 金属罐 供应商设备封装:TO-39 包装:散装 其它名称:*LM78M12CH*LM78M12CH/NOPBLM78M12CH |
发布紧急采购，3分钟左右您将得到回复。