参数资料
| 型号： | MIC5264-SPYML TR |
| 厂商： | Micrel Inc |
| 文件页数： | 9/11页 |
| 文件大小： | 0K |
| 描述： | IC REG LDO 3.3V/3V .15A 10-MLF |
| 标准包装： | 5,000 |
| 稳压器拓扑结构： | 正，固定式 |
| 输出电压： | 3.3V，3V |
| 输入电压： | 2.7 V ~ 5.5 V |
| 电压 - 压降（标准）： | 0.21V @ 150mA |
| 稳压器数量： | 2 |
| 电流 - 输出： | 150mA |
| 工作温度： | -40°C ~ 125°C |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 10-VFDFN 裸露焊盘，10-MLF? |
| 供应商设备封装： | 10-MLF?（3x3） |
| 包装： | 带卷 (TR) |
| 其它名称： | MIC5264-SPYMLTR MIC5264-SPYMLTR-ND |
Micrel, Inc.
Application Information
Enable/Shutdown
The MIC5264 comes with two independent active-high
enable pins that allow the regulator in each output to be
disabled separately. Forcing the enable pin low disables
the regulator and sends it into a “zero” off-mode current
state. In this state, current consumed by the regulator
goes nearly to zero. Forcing the enable pin high enables
the output voltage. This part is CMOS and the enable pin
cannot be left floating; a floating enable pin may cause
an indeterminate state on the output.
Input Capacitor
The MIC5264 is a high performance, high bandwidth
device. Therefore, it requires well-bypassed input
supplies for optimal performance. A 1uF capacitor is
required from the input to ground to provide stability.
Low-ESR ceramic capacitors provide optimal
performance at a minimum of space. Additional high-
frequency capacitors, such as small valued NPO
dielectric type capacitors, help filter out high-frequency
noise and are good practice in any RF-based circuit.
Output Capacitor
The MIC5264 requires capacitors at both outputs for
stability. The design requires 1uF or greater on each
output to maintain stability. The design is optimized for
use with low-ESR ceramic chip capacitors. High ESR
capacitors may cause high frequency oscillation. The
maximum recommended ESR is 300m ? . The output
capacitor can be increased, but performance has been
optimized for a 1uF ceramic output capacitor and does
not improve significantly with larger capacitance.
X7R/X5R dielectric-type ceramic capacitors are
recommended because of their temperature
performance. X7R type capacitors change capacitance
by 15% over their operating temperature range and are
the most stable type of ceramic capacitors. Z5U and
Y5V dielectric capacitors change value by as much as
50% and 60%, respectively, over their operating
temperature ranges. To use a ceramic chip capacitor
MIC5264
increases slightly with respect to bypass capacitance. A
unique quick-start circuit allows the MIC5264 to drive a
large capacitor on the bypass pin without significantly
slowing turn-on time.
Active Shutdown
The MIC5264 also features an active shutdown clamp,
which is an N-channel MOSFET that turns on when the
device is disabled. This allows the output capacitor and
load to discharge, de-energizing the load.
No-Load Stability
The MIC5264 will remain stable and in regulation with no
load unlike many other voltage regulators. This is
especially important in CMOS RAM keep-alive
applications.
Thermal Considerations
The MIC5264 is designed to provide 150mA of
continuous current per output in a very small package.
Maximum ambient operating temperature can be
calculated based on the output current and the voltage
drop across the part. Given that the input voltage is
5.0V, the V OUT1 output voltage is 3.0V at 150mA; V OUT2
output voltage is 2.8V at 100mA.
The actual power dissipation of the regulator circuit can
be determined using the equation:
P D = (V IN – V OUT ) I OUT + V IN I GND
Because this device is CMOS and the ground current is
typically <100uA over the load range, the power
dissipation contributed by the ground current is < 1%
and can be ignored for this calculation.
P D = (5.0V-3.0V) x 150mA + (5.0V-2.8V) x 100mA
P D = 0.52W
To determine the maximum ambient operating
temperature of the package, use the junction-to-ambient
thermal resistance of the device and the following basic
equation:
P D (max) = ? ?
?
?
with Y5V dielectric, the value must be much higher than
an X7R ceramic capacitor to ensure the same minimum
capacitance over the equivalent operating temperature
range.
? T J (max) ? T A
? θ JA
?
?
Bypass Capacitor
A capacitor can be placed from the noise bypass pin to
ground to reduce output voltage noise. The capacitor
bypasses the internal reference. A 0.01uF capacitor is
recommended for applications that require low-noise
outputs. The bypass capacitor can be increased, further
reducing noise and improving PSRR. Turn-on time
T J(max) = 125°C, the max. junction temperature of the die
θ JA thermal resistance = 63°C/W
May 2006
9
M9999-052406
(408) 955-1690
相关PDF资料 |
PDF描述 |
|---|---|
| LM317BD2TG | IC REG LDO ADJ .5A D2PAK |
| GMC44DREN | CONN EDGECARD 88POS .100 EYELET |
| GSC44DREH | CONN EDGECARD 88POS .100 EYELET |
| MIC5264-OKYML TR | IC REG LDO 2.9V/2.6V .15A 10-MLF |
| GMC44DREH | CONN EDGECARD 88POS .100 EYELET |
相关代理商/技术参数 |
参数描述 |
|---|---|
| MIC5264-SSYML TR | 功能描述:低压差稳压器 - LDO Dual uCap LDO in 2.5mm x 2.5mm MLF (Lead Free) RoHS:否 制造商:Texas Instruments 最大输入电压:36 V 输出电压:1.4 V to 20.5 V 回动电压（最大值）:307 mV 输出电流:1 A 负载调节:0.3 % 输出端数量: 输出类型:Fixed 最大工作温度:+ 125 C 安装风格:SMD/SMT 封装 / 箱体:VQFN-20 |
| MIC5265-1.5YC5 | 制造商:Rochester Electronics LLC 功能描述: 制造商:RF Micro Devices Inc 功能描述: 制造商:Micrel Inc 功能描述: |
| MIC5265-1.5YD5 | 功能描述:IC REG LDO 1.5V .15A TSOT23-5 RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - 线性 系列:- 标准包装:500 系列:- 稳压器拓扑结构:正，固定式 输出电压:12V 输入电压:14.5 V ~ 35 V 电压 - 压降（标准）:- 稳压器数量:1 电流 - 输出:500mA 电流 - 限制（最小）:- 工作温度:-40°C ~ 125°C 安装类型:通孔 封装/外壳:TO-205AD，TO-39-3 金属罐 供应商设备封装:TO-39 包装:散装 其它名称:*LM78M12CH*LM78M12CH/NOPBLM78M12CH |
| MIC5265-1.5YD5 TR | 功能描述:低压差稳压器 - LDO 150mA uCap LDO Regulator in Thin SOT(Lead Free) RoHS:否 制造商:Texas Instruments 最大输入电压:36 V 输出电压:1.4 V to 20.5 V 回动电压（最大值）:307 mV 输出电流:1 A 负载调节:0.3 % 输出端数量: 输出类型:Fixed 最大工作温度:+ 125 C 安装风格:SMD/SMT 封装 / 箱体:VQFN-20 |
| MIC5265-1.5YD5-TR | 功能描述:Linear Voltage Regulator IC Positive Fixed 1 Output 1.5V 150mA TSOT-23-5 制造商:microchip technology 系列:- 包装:剪切带（CT） 零件状态:停产 稳压器拓扑:正，固定式 电压 - 输出:1.5V 电流 - 输出:150mA 电压 - 跌落（典型值）:0.21V @ 150mA 稳压器数:1 电压 - 输入:2.7 V ~ 5.5 V 电流 - 限制（最小值）:- 工作温度:-40°C ~ 125°C 安装类型:表面贴装 封装/外壳:SOT-23-5 细型，TSOT-23-5 供应商器件封装:TSOT-23-5 标准包装:1 |
发布紧急采购，3分钟左右您将得到回复。