参数资料
型号: MK2059-01SILF
元件分类: 时钟产生/分配
英文描述: 25.92 MHz, OTHER CLOCK GENERATOR, PDSO20
封装: 0.300 INCH, ROHS COMPLIANT, SOIC-20
文件页数: 6/10页
文件大小: 184K
代理商: MK2059-01SILF
VCXO-Based Frame Clock Frequency Translator
MDS 2059-01 F
5
Revision 030106
Integrated Circuit Systems, Inc.
525 Race Street, San Jose, CA 95126 tel (408) 295-9800 www.icst.com
MK2059-01
A “normalized” PLL loop bandwidth may be calculated
as follows:
The “normalized” bandwidth equation above does not
take into account the effects of damping factor or the
second pole. However, it does provide a useful
approximation of filter performance.
The loop damping factor is calculated as follows:
Where:
RZ = Value of resistor in loop filter (Ohms)
ICP = Charge pump current (amps)
(refer to Charge Pump Current Table, below)
N = Crystal multiplier shown in the above table
C1 = Value of capacitor C1 in loop filter (Farads)
As a general rule, the following relationship should be
maintained between components C1 and C2 in the loop
filter:
Charge Pump Current Table
components CS and CP. These recommendations can
be found on the ICS web site.
Series Termination Resistor
Clock output traces over one inch should use series
termination. To series terminate a 50
trace (a
commonly used trace impedance), place a 33
resistor
in series with the clock line, as close to the clock output
pin as possible. The nominal impedance of the clock
output is 20
. (The optional series termination resistor
is not shown in the External Component Schematic.)
Decoupling Capacitors
As with any high performance mixed-signal IC, the
MK2059-01 must be isolated from system power
supply noise to perform optimally.
Decoupling capacitors of 0.01F must be connected
between each VDD and the PCB ground plane. To
further guard against interfering system supply noise,
the MK2059-01 should use one common connection to
the PCB power plane as shown in the diagram on the
next page. The ferrite bead and bulk capacitor help
reduce lower frequency noise in the supply that can
lead to output clock phase modulation.
Recommended Power Supply Connection
for Optimal Device Performance
Crystal Load Capacitors
The device crystal connections should include pads for
small capacitors from X1 to ground and from X2 to
ground, shown as CL in the External Component
Schematic. These capacitors are used to adjust the
stray capacitance of the board to match the nominally
required crystal load capacitance. Because load
RSET
Charge Pump Current
(ICP)
1.4 M
10
A
680 k
20
A
540 k
25
A
120 k
100
A
NBW
RS ICP
×
575
×
N
---------------------------------------
=
Damping Factor
RS
625
I
CP
×
CS
×
N
-----------------------------------------
×
=
CP
CS
20
------
=
C onnec tion to 3.3V
Pow er Plane
Ferrite
B ead
B ulk D ec oupling C apac itor
(suc h as 1
F Tantalum )
VD D Pin
0.01
F D ecoupling C apacitors
相关PDF资料
PDF描述
MK2702STR 27 MHz, OTHER CLOCK GENERATOR, PDSO8
MK2702SLF 27 MHz, OTHER CLOCK GENERATOR, PDSO8
MK2702SLF 27 MHz, OTHER CLOCK GENERATOR, PDSO8
MK2702S 27 MHz, OTHER CLOCK GENERATOR, PDSO8
MK2702STRLF 27 MHz, OTHER CLOCK GENERATOR, PDSO8
相关代理商/技术参数
参数描述
MK2059-01SILFTR 功能描述:时钟发生器及支持产品 VCXO-BASED FRAME CLK FREQUENCY TRANSLATOR RoHS:否 制造商:Silicon Labs 类型:Clock Generators 最大输入频率:14.318 MHz 最大输出频率:166 MHz 输出端数量:16 占空比 - 最大:55 % 工作电源电压:3.3 V 工作电源电流:1 mA 最大工作温度:+ 85 C 安装风格:SMD/SMT 封装 / 箱体:QFN-56
MK2059-01SITR 功能描述:IC VCXO CLK JITTER ATTEN 20-SOIC RoHS:否 类别:集成电路 (IC) >> 时钟/计时 - 时钟发生器,PLL,频率合成器 系列:- 标准包装:39 系列:- 类型:* PLL:带旁路 输入:时钟 输出:时钟 电路数:1 比率 - 输入:输出:1:10 差分 - 输入:输出:是/是 频率 - 最大:170MHz 除法器/乘法器:无/无 电源电压:2.375 V ~ 3.465 V 工作温度:0°C ~ 70°C 安装类型:* 封装/外壳:* 供应商设备封装:* 包装:*
MK2069-01 制造商:ICS 制造商全称:ICS 功能描述:VCXO-Based Line Card Clock Synchronizer
MK2069-01GI 功能描述:IC VCXO CLK SYNCHRONIZER 56TSSOP RoHS:否 类别:集成电路 (IC) >> 时钟/计时 - 时钟发生器,PLL,频率合成器 系列:- 标准包装:39 系列:- 类型:* PLL:带旁路 输入:时钟 输出:时钟 电路数:1 比率 - 输入:输出:1:10 差分 - 输入:输出:是/是 频率 - 最大:170MHz 除法器/乘法器:无/无 电源电压:2.375 V ~ 3.465 V 工作温度:0°C ~ 70°C 安装类型:* 封装/外壳:* 供应商设备封装:* 包装:*
MK2069-01GILF 功能描述:时钟合成器/抖动清除器 VCXO-BASED LINE CARD CLOCK SYNCHRONIZER RoHS:否 制造商:Skyworks Solutions, Inc. 输出端数量: 输出电平: 最大输出频率: 输入电平: 最大输入频率:6.1 GHz 电源电压-最大:3.3 V 电源电压-最小:2.7 V 封装 / 箱体:TSSOP-28 封装:Reel