- 您现在的位置：买卖IC网 > PDF目录1231 > MM232R (FTDI, Future Technology Devices International Ltd)MOD USB UART MINI DEV FT232R PDF资料下载
参数资料
| 型号： | MM232R |
| 厂商： | FTDI, Future Technology Devices International Ltd |
| 文件页数： | 14/24页 |
| 文件大小： | 0K |
| 描述： | MOD USB UART MINI DEV FT232R |
| 产品培训模块： | USB Introduction USB-UART Interface Solutions |
| 产品目录绘图： | MM232R |
| 标准包装： | 5 |
| 主要目的： | 接口，USB 2.0 至 UART（RS232/RS422/RS485）电桥 |
| 嵌入式： | 否 |
| 已用 IC / 零件： | FT232R |
| 主要属性： | 全速，300 ~ 3 MB 速率，安全识别号 |
| 次要属性： | 6 ~ 48MHz 时钟发生器输出，免版税驱动器 |
| 已供物品： | 板，连接器 |
| 产品目录页面： | 633 (CN2011-ZH PDF) |
| 相关产品： | 768-1008-6-ND - IC USB FS SERIAL UART 32-QFN 768-1007-6-ND - IC USB FS SERIAL UART 28-SSOP 768-1008-1-ND - IC USB FS SERIAL UART 32-QFN 768-1007-1-ND - IC USB FS SERIAL UART 28-SSOP 768-1008-2-ND - IC USB FS SERIAL UART 32-QFN 768-1007-2-ND - IC USB FS SERIAL UART 28-SSOP |
| 其它名称： | 768-1021 |
Document Reference No.: FT_000214
MM232R USB - Serial UART Development Module Incorporating Clock Generator
Datasheet Version 1.1
Clearance No.: FTDI# 132
6
Module Configurations
6.1 BUS Powered Configuration
Figure 6.1 Bus Powered Configuration
Figure 7.1 illustrates the MM232R in a typical USB bus powered design configuration. This is done by
connecting pin 15 (USBPWR) to pin 14 (VCC50). Pin 3 (VCCIO), the supply to the FT232RQ?s UART and
CBUS IO pins, is connected to pin 2 (VCC). Doing this will make the UART and CBUS IO pins drive out at 5V
levels. A USB Bus Powered device gets its power from the USB bus. Basic rules for USB Bus power devices
are as follows –
i)
ii)
On plug-in to USB, the device must draw no more than 100mA.
On USB Suspend the device must draw no more than 500μA.
iii) A Bus Powered High Power USB Device (one that draws more than 100mA) should use PWREN# to
keep the current below 100mA on plug- in and 500μA on USB suspend.
iv) A device that consumes more than 100mA cannot be plugged into a USB Bus Powered Hub.
v) No device can draw more that 500mA from the USB Bus.
The Figure also illustrates interfacing the MM232R module to a microcontroller (MCU) UART interface.
This example uses TXD and RXD for transmission and reception of data, and RTS# / CTS# hardware
handshaking. Also in this example the 12MHz clock output on pin 9 is used to clock the MCU. If the
MCU is handling power management functions, then this can be done by connecting PWREN# to an I/O
pin on the MCU.
? Copyright 2010 Future Technology Devices International Ltd
13
相关PDF资料 |
PDF描述 |
|---|---|
| MM5829-2700RJ4 | CONN MW COAXIAL 12GHZ SMD |
| MM8430-2600RA1 | CONN MW COAXIAL WITH SWITCH SMD |
| MMCX-J-178B/U | CONN MMCX JACK STRAIGHT RG178 |
| MMCX-J-P-H-ST-EM1 | CONN MMCX JACK PCB |
| MMT05A310T3G | THYRIST TSPD BIDIR 50A 270V SMA |
相关代理商/技术参数 |
参数描述 |
|---|---|
| MM23FAN | 制造商:MTRONPTI 制造商全称:MTRONPTI 功能描述:5x7 mm, 5 Volt, HCMOS/TTL, Surface Mount Oscillator |
| MM23FCN | 制造商:MTRONPTI 制造商全称:MTRONPTI 功能描述:5x7 mm, 5 Volt, HCMOS/TTL, Surface Mount Oscillator |
| MM23FGN | 制造商:MTRONPTI 制造商全称:MTRONPTI 功能描述:5x7 mm, 5 Volt, HCMOS/TTL, Surface Mount Oscillator |
| MM23-T1T1T1T1SAHH | 制造商:Hirschmann Electronics GmbH & Co Kg 功能描述:Media Module, MICE, PTP Ver 2 Realtime Module, HNT000097 |
| MM23-T1T1T1T1SYHH | 制造商:HIRSCHMANN INDUSTRIAL 功能描述:Media Module, MICE, PTPv2 Realtime Module, 4x10/100 RJ45, cUL508 + CE |
发布紧急采购，3分钟左右您将得到回复。