- 您现在的位置：买卖IC网 > PDF目录45388 > MSC8144VT800B (FREESCALE SEMICONDUCTOR INC) 133 MHz, OTHER DSP, PBGA783 PDF资料下载
参数资料
| 型号： | MSC8144VT800B |
| 厂商： | FREESCALE SEMICONDUCTOR INC |
| 元件分类： | 数字信号处理 |
| 英文描述： | 133 MHz, OTHER DSP, PBGA783 |
| 封装： | 29 X 29 MM, LEAD FREE, PLASTIC, FCPBGA-783 |
| 文件页数： | 1/80页 |
| 文件大小： | 1250K |
| 代理商： | MSC8144VT800B |
当前第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页第29页第30页第31页第32页第33页第34页第35页第36页第37页第38页第39页第40页第41页第42页第43页第44页第45页第46页第47页第48页第49页第50页第51页第52页第53页第54页第55页第56页第57页第58页第59页第60页第61页第62页第63页第64页第65页第66页第67页第68页第69页第70页第71页第72页第73页第74页第75页第76页第77页第78页第79页第80页
Freescale Semiconductor
Data Sheet
Document Number: MSC8144
Rev. 16, 5/2010
2007–2010 Freescale Semiconductor, Inc.
MSC8144
FC-PBGA–783
29 mm
× 29 mm
Four StarCore SC3400 DSP subsystems, each with an SC3400
DSP core, 16 Kbyte L1 instruction cache, 32 Kbyte L1 data cache,
memory management unit (MMU), extended programmable
interrupt controller (EPIC), two general-purpose 32-bit timers,
debug and profiling support, and low-power Wait and Stop
processing modes.
Chip-level arbitration and system (CLASS) that provides full
fabric non-blocking arbitration between the processing elements
and other initiators and the M2 memory, DDR SRAM controller,
device configuration control and status registers, and other
targets.
128 Kbyte L2 shared instruction cache.
512 Kbyte M2 memory for critical data and temporary data
buffering.
10 Mbyte 128-bit wide M3 memory.
96 Kbyte boot ROM.
Three input clocks (shared, global, and differential).
Four PLLs (system, core, global, and serial RapidIO).
DDR controller with up to a 200 MHz clock (400 MHz data rate),
16/32 bit data bus, supporting up to 1 Gbyte in up to two banks
and support for DDR1 and DDR2.
DMA controller with 16 bidirectional channels with up to 1024
buffer descriptors, and programmable priority, buffer, and
multiplexing configuration.
Up to eight independent TDM modules with programmable word
size (2, 4, 8, or 16-bit), hardware-base A-law/
μ-law conversion,
up to 128 Mbps data rate for all channels, with glueless interface
to E1 or T1 framers, and can interface with H-MVIP/H.110
devices, TSI, and codecs such as AC-97.
QUICC Engine technology subsystem with dual RISC
processors, 48 Kbyte multi-master RAM, 48 Kbyte instruction
RAM, supporting three communication controllers with one ATM
and two Gigabit Ethernet interfaces, to offload scheduling tasks
from the DSP cores.
– The two Ethernet controllers support 10/100/1000 Mbps
operations via MII/RMII/SMII/RGMII/SGMII and the SGMII
protocol using a 4-pin SerDes interface at 1000 Mbps data rate
only.
– The ATM controller supports UTOPIA level II 8/16 bits at
25/50 MHz in UTOPIA/POS mode with adaptation layer
support AAL0, AAL2, and AAL5.
PCI designed to comply with the PCI specification revision 2.2 at
33 MHz or 66 MHz with access to all PCI address spaces.
Serial RapidIO 1x/4x endpoint corresponds to Specification 1.2
of the RapidIO trade association, and supports read, write,
messages, doorbells, and maintenance accesses in inbound mode,
and messages and doorbells in outbound mode.
I/O interrupt concentrator consolidates all chip maskable interrupt
and non-maskable interrupt sources and routes them to
INT_OUT, NMI_OUT, and the cores.
UART that permits full-duplex operation with a bit rate of up to
6.25 Mbps.
Serial peripheral interface (SPI).
Four timer modules, each with four configurable16-bit timers.
Four software watchdog timer (SWT) modules.
Up to 32 general-purpose input/output (GPIO) ports, 16 of which
can be configured as maskable interrupt inputs.
I2C interface that allows booting from EEPROM devices.
Eight programmable hardware semaphores.
Thirty two virtual maskable interrupts and one virtual NMI that
can be generated by a simple write access.
Optional booting via serial RapidIO port, PCI, I2C, SPI, or
Ethernet interfaces.
Note:
This document supports mask set M31H.
Quad Core Digital Signal
Processor
相关PDF资料 |
PDF描述 |
|---|---|
| MSC8144SVT1000A | 133 MHz, OTHER DSP, PBGA783 |
| MSC8144TVT1000A | 133 MHz, OTHER DSP, PBGA783 |
| MSC8144SVT1000B | 133 MHz, OTHER DSP, PBGA783 |
| MSC8144VT1000A | 133 MHz, OTHER DSP, PBGA783 |
| MSC8144SVT800A | 133 MHz, OTHER DSP, PBGA783 |
相关代理商/技术参数 |
参数描述 |
|---|---|
| MSC81450M | 制造商:STMICROELECTRONICS 制造商全称:STMicroelectronics 功能描述:RF & MICROWAVE TRANSISTORS AVIONICS APPLICATIONS |
| MSC8151 | 制造商:FREESCALE 制造商全称:Freescale Semiconductor, Inc 功能描述:Single-Core Digital Signal Processor |
| MSC8151SAG1000B | 制造商:Freescale Semiconductor 功能描述:STARCORE DSP, 1X 1GHZ SC3850 CORES, MAPLE-B ACCELERATOR, DDR - Bulk 制造商:Freescale Semiconductor 功能描述:STARCORE DSP, 1X 1GHZ SC3850 CORES, MAPLE-B ACCELERATOR, DDR - Trays 制造商:Freescale Semiconductor 功能描述:IC DSP 1X 1GHZ SC3850 783FCBGA |
| MSC8151SVT1000B | 功能描述:数字信号处理器和控制器 - DSP, DSC Darwin RoHS:否 制造商:Microchip Technology 核心:dsPIC 数据总线宽度:16 bit 程序存储器大小:16 KB 数据 RAM 大小:2 KB 最大时钟频率:40 MHz 可编程输入/输出端数量:35 定时器数量:3 设备每秒兆指令数:50 MIPs 工作电源电压:3.3 V 最大工作温度:+ 85 C 封装 / 箱体:TQFP-44 安装风格:SMD/SMT |
| MSC8151TVT1000B | 功能描述:数字信号处理器和控制器 - DSP, DSC Darwin RoHS:否 制造商:Microchip Technology 核心:dsPIC 数据总线宽度:16 bit 程序存储器大小:16 KB 数据 RAM 大小:2 KB 最大时钟频率:40 MHz 可编程输入/输出端数量:35 定时器数量:3 设备每秒兆指令数:50 MIPs 工作电源电压:3.3 V 最大工作温度:+ 85 C 封装 / 箱体:TQFP-44 安装风格:SMD/SMT |
发布紧急采购，3分钟左右您将得到回复。