- 您现在的位置：买卖IC网 > PDF目录299525 > MW005BK-SLP (LINEAGE POWER LLC) DC-DC REG PWR SUPPLY MODULE PDF资料下载
参数资料
| 型号： | MW005BK-SLP |
| 厂商： | LINEAGE POWER LLC |
| 元件分类： | 电源模块 |
| 英文描述： | DC-DC REG PWR SUPPLY MODULE |
| 文件页数： | 5/20页 |
| 文件大小： | 517K |
| 代理商： | MW005BK-SLP |
Data Sheet
MW005-Series Power Modules:
April 2008
36 Vdc to 75 Vdc Inputs; 5 W
Lineage Power
13
Safety Considerations
For safety-agency approval of the system in which the
power module is used, the power module must be
installed in compliance with the spacing and separation
requirements of the end-use safety agency standard,
i.e.,
UL 1950, CSA C22.2 No. 950-95, and VDE 0805
(EN60950, IEC950).
If the input source is non-SELV (ELV or a hazardous
voltage greater than 60 Vdc and less than or equal to
75 Vdc), for the module's output to be considered
meeting the requirements of safety extra-low voltage
(SELV), all of the following must be true:
s
The input source is to be provided with reinforced
insulation from any other hazardous voltages, includ-
ing the ac mains; and
s
One VI pin and one VO pin are to be grounded or both
the input and output pins are to be kept oating; and
s
The input pins of the module are not operator acces-
sible; and
s
Another SELV reliability test is conducted on the
whole system, as required by the safety agencies, on
the combination of supply source and the subject
module to verify that under a single fault, hazardous
voltages do not appear at the module's output.
Note: Do not ground either of the input pins of the
module without grounding one of the output
pins. This may allow a non-SELV voltage to
appear between the output pins and ground.
The power module has extra-low voltage (ELV) outputs
when all inputs are ELV.
The input to these units is to be provided with a maxi-
mum 5 A normal-blow fuse in the ungrounded lead.
Feature Descriptions
Overcurrent Protection
To provide protection in a fault (output overload) condi-
tion, the unit is equipped with internal current-limiting
and can endure current limiting for an unlimited dura-
tion. At the point of current-limit inception, the unit
shifts from voltage control to current control. If the out-
put voltage is pulled very low during a severe fault, the
current-limit circuit can exhibit either foldback or tailout
characteristics (output current decrease or increase).
The unit operates normally once the output current is
brought back into its specied range.
Output Overvoltage Protection
The output overvoltage clamp consists of control cir-
cuitry, independent of the primary regulation loop, that
monitors the voltage on the output terminals. The con-
trol loop of the clamp has a higher voltage set point
than the primary loop (see Feature Specications
table). This provides a redundant voltage control that
reduces the risk of output overvoltage.
Thermal Considerations
To maintain the full power rating at ambient tempera-
tures above 70 °C (TA > 70 °C), add an external capac-
itor across the input close to the power module input
leads. Use an 80 V capacitor with a minimum ripple
current rating of 160 mArms and maximum impedance
of 1.0
at 105 °C and 100 kHz. Otherwise, derate the
output power as shown in Figure 28.
8-548(C)
Figure 28. Thermal Derating Curve
AMBIENT TEMPERATURE, TA (
°C)
OUTPUT
POWER,
P
O
(W)
5.0
4.5
4.0
0.0
–40
1.0
3.5
3.0
2.5
2.0
1.5
0.5
–20
0
20
40
85
70
WITH EXTERNAL
CAPACITOR
WITHOUT EXTERNAL
CAPACITOR
相关PDF资料 |
PDF描述 |
|---|---|
| MW005C6 | DC-DC REG PWR SUPPLY MODULE |
| MWDM2L-100PBSPT-.190 | 100 CONTACT(S), MALE, D MICROMINIATURE CONNECTOR, SOLDER |
| MWDM2L-100SBSPT-.150 | 100 CONTACT(S), FEMALE, D MICROMINIATURE CONNECTOR, SOLDER |
| MWDM2L-100SBSPT-.190 | 100 CONTACT(S), FEMALE, D MICROMINIATURE CONNECTOR, SOLDER |
| MWDM2L-21PBSP-.190 | 21 CONTACT(S), MALE, D MICROMINIATURE CONNECTOR, SOLDER |
相关代理商/技术参数 |
参数描述 |
|---|---|
| MW005C | 功能描述:CONVERTER DC/DC 15V 5W OUT RoHS:否 类别:电源 - 板载 >> DC DC Converters 系列:MW005 设计资源:VI-200, VI-J00 Design Guide, Appl Manual 标准包装:1 系列:* 类型:隔离 输出数:1 电压 - 输入（最小）:42V 电压 - 输入（最大）:60V Voltage - Output 1:15V Voltage - Output 2:- Voltage - Output 3:- 电流 - 输出（最大）:* 电源（瓦） - 制造商系列:150W 电压 - 隔离:* 特点:* 安装类型:通孔 封装/外壳:9-SlimMod 尺寸/尺寸:4.60" L x 1.80" W x 0.52" H（116.8mm x 45.7mm x 13.2mm） 包装:散装 工作温度:-55°C ~ 85°C 效率:* 电源（瓦特）- 最大:* |
| MW005CL | 制造商:GE Energy (formerly Lineage Power) 功能描述:Module DC-DC 1-OUT 15V/-15V 0.17A 5W 5-Pin |
| MW010A | 功能描述:DC/DC转换器 5V 2A 10W 4-Pin RoHS:否 制造商:Murata 产品: 输出功率: 输入电压范围:3.6 V to 5.5 V 输入电压（标称）: 输出端数量:1 输出电压（通道 1）:3.3 V 输出电流（通道 1）:600 mA 输出电压（通道 2）: 输出电流（通道 2）: 安装风格:SMD/SMT 封装 / 箱体尺寸: |
| MW010A1 | 功能描述:DC/DC转换器 5V 2A 10W 5-Pin RoHS:否 制造商:Murata 产品: 输出功率: 输入电压范围:3.6 V to 5.5 V 输入电压（标称）: 输出端数量:1 输出电压（通道 1）:3.3 V 输出电流（通道 1）:600 mA 输出电压（通道 2）: 输出电流（通道 2）: 安装风格:SMD/SMT 封装 / 箱体尺寸: |
| MW010B | 功能描述:CONVERTER DC/DC 12V 10W OUT RoHS:否 类别:电源 - 板载 >> DC DC Converters 系列:MW010 设计资源:VI-200, VI-J00 Design Guide, Appl Manual 标准包装:1 系列:* 类型:隔离 输出数:1 电压 - 输入（最小）:42V 电压 - 输入（最大）:60V Voltage - Output 1:15V Voltage - Output 2:- Voltage - Output 3:- 电流 - 输出（最大）:* 电源（瓦） - 制造商系列:150W 电压 - 隔离:* 特点:* 安装类型:通孔 封装/外壳:9-SlimMod 尺寸/尺寸:4.60" L x 1.80" W x 0.52" H（116.8mm x 45.7mm x 13.2mm） 包装:散装 工作温度:-55°C ~ 85°C 效率:* 电源（瓦特）- 最大:* |
发布紧急采购，3分钟左右您将得到回复。