参数资料
| 型号： | NCN1188MUTAG |
| 厂商： | ON Semiconductor |
| 文件页数： | 5/14页 |
| 文件大小： | 0K |
| 描述： | IC USB SWITCH 3:1 AUD/MHL 12UQFN |
| 标准包装： | 1 |
| 功能： | USB 开关 |
| 电路： | 1 x DP3T |
| 导通状态电阻： | 7.5 欧姆 |
| 电压电源： | 单电源 |
| 电压 - 电源，单路/双路(±)： | 2.7 V ~ 5.5 V |
| 电流 - 电源： | 23µA |
| 工作温度： | -40°C ~ 85°C |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 12-UFQFN |
| 供应商设备封装： | 12-UQFN |
| 包装： | 标准包装 |
| 其它名称： | NCN1188MUTAGOSDKR |
NCN1188
http://onsemi.com
13
PCB DESIGN PROCEDURE
Implementing a high speed device requires careful design
of signal traces to preserve signal integrity. The following
electrical layout guidelines are basic rules to follow when
designing boards capable of high speed transmission.
The bypass capacitor must be placed as close as
possible to the VCC input pin for noise immunity.
The PCB should be designed to comply with the
characteristic impedance requirements of MHL and
USB.
Make the signal traces as short as possible to reduce
losses through the PCB. Furthermore, all corresponding
D+ / D line segment pairs should be the same length.
The use of turns or bends to route these signals should
be avoided when possible. Use 45
° bends instead of 90°
bends where bends are needed. The use of vias to route
these signals should be avoided when possible.
相关PDF资料 |
PDF描述 |
|---|---|
| NCN2500MNR2G | IC TXRX 1CHAN USB 16-QFN |
| NCN2612MTTWG | IC TXRX 1CHAN USB 56WQFN |
| NCN4557MTG | IC SMART CARD/SIM DUAL 16-QFN |
| NCN6000DTBR2G | IC INTERFACE SMART CARD 20TSSOP |
| NCN6001DTBR2 | IC INTERFACE SMART CARD 20TSSOP |
相关代理商/技术参数 |
参数描述 |
|---|---|
| NCN15-30GM40-N0 | 制造商:PEPPERL+FUCHS 功能描述:Sensor, Proximity, Inductive, NAMUR |
| NCN15-30GM40-N0 10M | 制造商:PEPPERL+FUCHS 功能描述:Inductive NAMUR |
| NCN15-30GM40-N0-10M | 制造商:PEPPERL+FUCHS 功能描述:Sensor, Proximity, Inductive, NAMUR |
| NCN15-30GM40-N0-20M | 制造商:PEPPERL+FUCHS 功能描述:Sensor, Proximity, Inductive, NAMUR 制造商:PEPPERL+FUCHS 功能描述:Inductive NAMUR |
| NCN15-30GM40-N0-30M | 制造商:PEPPERL+FUCHS 功能描述:Sensor, Proximity, Inductive, NAMUR |
发布紧急采购，3分钟左右您将得到回复。