参数资料
型号: NCP3520DMR2G
厂商: ON Semiconductor
文件页数: 8/10页
文件大小: 0K
描述: IC REG LDO 1.2V 3A MICRO8
产品变化通告: LTB Notification
标准包装: 1
稳压器拓扑结构: 正,固定式
输出电压: 1.2V
输入电压: 最高 7V
稳压器数量: 1
电流 - 输出: 3A
工作温度: 0°C ~ 100°C
安装类型: 表面贴装
封装/外壳: 8-TSSOP,8-MSOP(0.118",3.00mm 宽)
供应商设备封装: Micro8?
包装: 标准包装
产品目录页面: 1120 (CN2011-ZH PDF)
其它名称: NCP3520DMR2GOSDKR
NCP3520/NCP3521
Short Circuit Protection (SCP)
The IC enters normal mode after the NRCS has gone
through powerup. The NRCS capacitor has reached a 1 V
(typ) threshold and fully discharged (50 mV (max)).
When a short circuit event occurs it is detected when the
voltage on V FB goes below (35% of V OUT ). This triggers the
NRCS current source to start charging the NRCS capacitor
at the same 20 m A rate as during powerup. When the voltage
on the capacitor reaches 1.3 V a short circuit event is
confirmed, V G goes low turning off the external FET. V S
Standby Current pulldown is enabled.
Clearing a Short Circuit Latch Condition
A short circuit latch condition can be cleared by toggling
the EN from its high condition to a low condition, and then
back to a high condition.
3V
EN
3V
EN
1.2 V
VS / VFB
1.3 V
1.0 V
NRCS
0V
50 m s
50 m s
1.2 V
VS / VFB
V O * 0.35
Shirt Circuit
is Detected
1.3 V
NRCS
Shirt Circuit Decision Timer
Figure 15. Starting Up Into a Short Circuit (NCP3520
(1.2 V) Version Shown)
Undervoltage Lockout
V CC and V D detection is provided in conjunction with the
EN input pin. When all three conditions are met (V CC is up,
V D is up, and EN is high), the Non Rush Current on Startup
(NRCS) circuitry is allowed to start. Any one of the three
conditions failing will not allow the device to turn on.
The V CC undervoltage threshold is 4.35 V and the V D
threshold is V O * 0.7.
Enable
The Enable function is controlled by the logic pin EN. The
threshold of this pin is set to TTL logic levels. TTL logic
levels are 0.8 V (low) and 2.0 V (high). A low on the EN pin
puts the device is a low current sleep mode consuming less
Output Falls Out
Output Turns Off
than 10 m A (I VCC ). A device going from normal operation
to sleep will 1 st go through a discharge mode maintaining a
of Regulation
Figure 14. Short Circuit (NCP3520 (1.2 V)
Version Shown)
Starting Up Into a Short Circuit
If the NCP3520/NCP3521 turns on and has not gone into
a normal mode of operation, additional time has been added
to the NRCS to ignore potential false short circuit
confirmation during in-rush current events. This time is
independent of the external capacitor value and is typically
50 m s. The voltage on NRCS operates as a normal condition
until it reaches 1 V. The current source charging NRCS turns
off for 50 m s disallowing the voltage to rise on NRCS. After
50 m s the current source turns back on and continues to
charge the NRCS capacitor. Once 1.3 V is reached, the
circuit operates as during a typical short circuit event.
discharge current of 220 mA on V S (measured @ V S = 1 V).
This pin has 60 mV (typ) of hysteresis to guarantee a clean
switching threshold.
External Components
A capacitor between V O and ground is required for
stability. A 220 m F value capacitor such as the
SANYO 2R5TPE220MF is recommended. The
SANYO 2R5TPE220MF capacitor has a 15 m W maximum
specification. Contact resistance and board trace resistance
are the significant contributors to output capacitor ESR
below 10 m W .
As ON Semiconductor's NCP352X family of LDO
controllers may be considered as an alternative to
Rohm's family of LDO controllers, alternative FETs such as
industry compatible parts like the Si4866DY may also be
used in conjunction with ON Semiconductor's controller.
http://onsemi.com
8
相关PDF资料
PDF描述
NCP362CMUTBG IC OCP TVS ESD USB POS 10-UDFN
NCP367OPMUEOTBG IC VOLT PROTECTION OCP OVP 8DFN
NCP372MUAITXG IC CTLR OVP POS & NEG 12-LLGA
NCP373MU04TXG IC CTLR OVP POS & NEG 12-LLGA
NCP3985SN28T1G IC REG LDO 2.8V .15A 5TSOP
相关代理商/技术参数
参数描述
NCP3520DMR2GEVB 功能描述:电源管理IC开发工具 P520GEVB RoHS:否 制造商:Maxim Integrated 产品:Evaluation Kits 类型:Battery Management 工具用于评估:MAX17710GB 输入电压: 输出电压:1.8 V
NCP3521DMR2G 功能描述:低压差控制器 - LDO LDO REG CONTROLLER 1.5 FIXED VOLTAGE RoHS:否 制造商:Micrel 最大输入电压:5.5 V 输出电压:Adjustable 输出电流:10 mA 负载调节: 输出类型:Adjustable, Fixed 输出端数量:1 最大工作温度:+ 125 C 安装风格:SMD/SMT 封装 / 箱体:SOT-23-6
NCP3521DMR2GEVB 功能描述:电源管理IC开发工具 NCP3521 DEMO BRD RoHS:否 制造商:Maxim Integrated 产品:Evaluation Kits 类型:Battery Management 工具用于评估:MAX17710GB 输入电压: 输出电压:1.8 V
NCP360 AW52A WAF 制造商:ON Semiconductor 功能描述:
NCP360GEVB 功能描述:电源管理IC开发工具 RoHS:否 制造商:Maxim Integrated 产品:Evaluation Kits 类型:Battery Management 工具用于评估:MAX17710GB 输入电压: 输出电压:1.8 V