- 您现在的位置：买卖IC网 > PDF目录14696 > NCP6334BMTAATBG (ON Semiconductor)IC REG BUCK SYNC ADJ 2A 8-WDFN PDF资料下载
参数资料
| 型号： | NCP6334BMTAATBG |
| 厂商： | ON Semiconductor |
| 文件页数： | 9/14页 |
| 文件大小： | 0K |
| 描述： | IC REG BUCK SYNC ADJ 2A 8-WDFN |
| 标准包装： | 1 |
| 类型： | 降压（降压） |
| 输出类型： | 可调式 |
| 输出数： | 1 |
| 输出电压： | 0.6 V ~ 5.5 V |
| 输入电压： | 2.3 V ~ 5.5 V |
| PWM 型： | 电压模式 |
| 频率 - 开关： | 3MHz |
| 电流 - 输出： | 2A |
| 同步整流器： | 是 |
| 工作温度： | -40°C ~ 85°C |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 8-WFDFN 裸露焊盘 |
| 包装： | 标准包装 |
| 供应商设备封装： | 8-WDFN（2x2） |
| 其它名称： | NCP6334BMTAATBGOSDKR |
NCP6334B, NCP6334C
DETAILED DESCRIPTION
General
The NCP6334B/C, a family of voltage ? mode
synchronous buck converters, which is optimized to supply
different sub ? systems of portable applications powered by
one cell Li ? ion or three cell Alkaline/NiCd/NiMH batteries.
The devices are able to deliver up to 2 A on an external
adjustable voltage. Operation with 3 MHz switching
frequency allows employing small size inductor and
capacitors. Input supply voltage feedforward control is
employed to deal with wide input voltage range.
Synchronous rectification and automatic PWM/PFM power
save mode offer improved system efficiency.
Operation Mode Selection (NCP6334C)
For NCP6334C with an external mode selection option,
high level (above 1.1 V) at MODE pin forces the device to
operate in forced PWM mode. Low level (below 0.4 V) at
this pin enables the device to operate in automatic
PFM/PWM mode for power saving function.
PWM Mode Operation
In medium and heavy load range, the inductor current is
continuous and the device operates in PWM mode with fixed
switching frequency, which has a typical value of 3 MHz. In
this mode, the output voltage is regulated by on ? time pulse
width modulation of an internal P ? MOSFET. An internal
N ? MOSFET operates as synchronous rectifier and its
turn ? on signal is complimentary to that of the P ? MOSFET.
PFM Mode Operation
In light load range, the inductor current becomes
discontinuous and the device automatically operates in PFM
mode with an adaptive fixed on time and variable switching
frequency. In this mode, the output voltage is regulated by
pulse frequency modulation of the internal P ? MOSFET, and
the switching frequency is almost proportional to the
loading current. The internal N ? MOSFET operates as
synchronous rectifier after each on pulse of the P ? MOSFET
with a very small negative current limit. When the load
increases and the inductor current becomes continuous, the
controller automatically turns back to the fixed ? frequency
PWM mode operation.
Undervoltage Lockout
The input voltage VIN must reach or exceed 2.4 V
(typical) before the NCP6334B/C enables the converter
output to begin the start up sequence. The UVLO threshold
hysteresis is typically 100 mV.
Enable
The NCP6334B/C has an enable logic input pin EN. A
high level (above 1.1 V) on this pin enables the device to
active mode. A low level (below 0.4 V) on this pin disables
the device and makes the device in shutdown mode. There
is an internal filter with 5 m s time constant. The EN pin is
pulled down by an internal 10 nA sink current source. In
most of applications, the EN signal can be programmed
independently to VIN power sequence.
EN
1.1V
0.4V
100us
95%
Vout
300us
90%
1.15ms
8us
5us
8us
PG
8us
Active
Discharge
Figure 19. Power Good and Active Discharge Timing Diagram
Power Good Output (NCP6334B)
For NCP6334B with a power good output, the device
monitors the output voltage and provides a power good
output signal at the PG pin. This pin is an open ? drain output
pin. To indicate the output of the converter is established, a
power good signal is available. The power good signal is low
when EN is high but the output voltage has not been
established. Once the output voltage of the converter drops
out below 90% of its regulation during operation, the power
good signal is pulled low and indicates a power failure. A 5%
http://onsemi.com
9
相关PDF资料 |
PDF描述 |
|---|---|
| EBC35DRYN-S93 | CONN EDGECARD 70POS DIP .100 SLD |
| EBC35DRYH-S93 | CONN EDGECARD 70POS DIP .100 SLD |
| VI-J12-EW | CONVERTER MOD DC/DC 15V 100W |
| RYM18DRSN-S288 | CONN EDGECARD 36POS .156 EXTEND |
| VE-212-EW | CONVERTER MOD DC/DC 15V 100W |
相关代理商/技术参数 |
参数描述 |
|---|---|
| NCP6334BMTBBTBG | 功能描述:DC/DC 开关控制器 RoHS:否 制造商:Texas Instruments 输入电压:6 V to 100 V 开关频率: 输出电压:1.215 V to 80 V 输出电流:3.5 A 输出端数量:1 最大工作温度:+ 125 C 安装风格: 封装 / 箱体:CPAK |
| NCP6334B-V3 | 制造商:ONSEMI 制造商全称:ON Semiconductor 功能描述:3MHz, 2A Synchronous Buck Converter |
| NCP6334C | 制造商:ONSEMI 制造商全称:ON Semiconductor 功能描述:3MHz, 2A Synchronous Buck Converter |
| NCP6334CMTAATBG | 功能描述:直流/直流开关转换器 RoHS:否 制造商:STMicroelectronics 最大输入电压:4.5 V 开关频率:1.5 MHz 输出电压:4.6 V 输出电流:250 mA 输出端数量:2 最大工作温度:+ 85 C 安装风格:SMD/SMT |
| NCP6334FMT26TBG | 制造商:ON Semiconductor 功能描述:BUCK CONVERTER - Tape and Reel |
发布紧急采购，3分钟左右您将得到回复。