参数资料
| 型号： | NCP699SN50T1G |
| 厂商： | ON Semiconductor |
| 文件页数： | 6/8页 |
| 文件大小： | 0K |
| 描述： | IC REG LDO 5V 240MA 5TSOP |
| 标准包装： | 1 |
| 稳压器拓扑结构： | 正，固定式 |
| 输出电压： | 5V |
| 输入电压： | 最高 6V |
| 电压 - 压降（标准）： | 0.24V @ 150mA |
| 稳压器数量： | 1 |
| 电流 - 输出： | 240mA |
| 工作温度： | -40°C ~ 85°C |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 6-TSOP（0.059"，1.50mm 宽）5 引线 |
| 供应商设备封装： | 5-TSOP |
| 包装： | 标准包装 |
| 产品目录页面： | 1120 (CN2011-ZH PDF) |
| 其它名称： | NCP699SN50T1GOSDKR |
NCP699
DEFINITIONS
Load Regulation
The change in output voltage for a change in output
current at a constant temperature.
Dropout Voltage
The input/output differential at which the regulator output
no longer maintains regulation against further reductions in
input voltage. Measured when the output drops 3.0% below
its nominal. The junction temperature, load current, and
minimum input supply requirements affect the dropout level.
Maximum Power Dissipation
The maximum total dissipation for which the regulator
will operate within its specifications.
Quiescent and Ground Current
The quiescent current is the current which flows through
the ground when the LDO operates without a load on its
output: internal IC operation, bias, etc. When the LDO
becomes loaded, this term is called the Ground current. It is
actually the difference between the input current (measured
through the LDO input pin) and the output current.
Line Regulation
The change in output voltage for a change in input voltage.
The measurement is made under conditions of low
dissipation or by using pulse technique such that the average
chip temperature is not significantly affected.
Line Transient Response
Typical over and undershoot response when input voltage
is excited with a given slope.
Thermal Protection
Internal thermal shutdown circuitry is provided to protect
the integrated circuit in the event that the maximum junction
temperature is exceeded. When activated at typically 160 ° C,
the regulator turns off. This feature is provided to prevent
failures from accidental overheating.
Maximum Package Power Dissipation
The maximum power package dissipation is the power
dissipation level at which the junction temperature reaches
its maximum operating value, i.e. 125 ° C. Depending on the
ambient power dissipation and thus the maximum available
output current.
http://onsemi.com
6
相关PDF资料 |
PDF描述 |
|---|---|
| MCP1727T-ADJE/MF | IC REG LDO ADJ 1.5A 8DFN |
| NCP698SQ33T1G | IC REG LDO 3.3V .28A SC-82AB |
| NCP699SN33T1G | IC REG LDO 3.3V 240MA 5TSOP |
| RBC65DRES-S13 | CONN EDGECARD 130PS .100 EXTEND |
| GSC40DRES-S13 | CONN EDGECARD 80POS .100 EXTEND |
相关代理商/技术参数 |
参数描述 |
|---|---|
| NCP700 | 制造商:ONSEMI 制造商全称:ON Semiconductor 功能描述:Ultra Low Noise, High PSSR,BiCMOS RF LDO Regulator |
| NCP700B | 制造商:ONSEMI 制造商全称:ON Semiconductor 功能描述:200 mA, Ultra Low Noise, High PSRR, BiCMOS RF LDO Regulator |
| NCP700BMT18TBG | 功能描述:低压差稳压器 - LDO 200MA ULN RF LDO REG1.8V RoHS:否 制造商:Texas Instruments 最大输入电压:36 V 输出电压:1.4 V to 20.5 V 回动电压（最大值）:307 mV 输出电流:1 A 负载调节:0.3 % 输出端数量: 输出类型:Fixed 最大工作温度:+ 125 C 安装风格:SMD/SMT 封装 / 箱体:VQFN-20 |
| NCP700BMT28TBG | 功能描述:低压差稳压器 - LDO 200MA ULN RF LDO REG2.8V RoHS:否 制造商:Texas Instruments 最大输入电压:36 V 输出电压:1.4 V to 20.5 V 回动电压（最大值）:307 mV 输出电流:1 A 负载调节:0.3 % 输出端数量: 输出类型:Fixed 最大工作温度:+ 125 C 安装风格:SMD/SMT 封装 / 箱体:VQFN-20 |
| NCP700BMT30TBG | 功能描述:低压差稳压器 - LDO 200MA ULN RF LDO REG 3V RoHS:否 制造商:Texas Instruments 最大输入电压:36 V 输出电压:1.4 V to 20.5 V 回动电压（最大值）:307 mV 输出电流:1 A 负载调节:0.3 % 输出端数量: 输出类型:Fixed 最大工作温度:+ 125 C 安装风格:SMD/SMT 封装 / 箱体:VQFN-20 |
发布紧急采购，3分钟左右您将得到回复。