- 您现在的位置：买卖IC网 > PDF目录20193 > NCV317BD2TG (ON Semiconductor)IC REG LDO ADJ .5A D2PAK PDF资料下载
参数资料
| 型号： | NCV317BD2TG |
| 厂商： | ON Semiconductor |
| 文件页数： | 7/12页 |
| 文件大小： | 0K |
| 描述： | IC REG LDO ADJ .5A D2PAK |
| 标准包装： | 50 |
| 稳压器拓扑结构： | 正，可调式 |
| 输出电压： | 1.2 V ~ 37 V |
| 输入电压： | 最高 40 V |
| 稳压器数量： | 1 |
| 电流 - 输出： | 500mA |
| 电流 - 限制（最小）： | 1.5A |
| 工作温度： | -55°C ~ 150°C |
| 安装类型： | 表面贴装 |
| 封装/外壳： | TO-263-3，D²Pak（2 引线+接片），TO-263AB |
| 供应商设备封装： | D2PAK |
| 包装： | 带卷 (TR) |
| 其它名称： | NCV317BD2TGOS |
LM317, NCV317
APPLICATIONS INFORMATION
1 ) 2
V out + V ) I
Adj 2
ref
Basic Circuit Operation
The LM317 is a 3 ? terminal floating regulator. In
operation, the LM317 develops and maintains a nominal
1.25 V reference (V ref ) between its output and adjustment
terminals. This reference voltage is converted to a
programming current (I PROG ) by R 1 (see Figure 17), and this
constant current flows through R 2 to ground.
The regulated output voltage is given by:
R
R
R1
Since the current from the adjustment terminal (I Adj )
represents an error term in the equation, the LM317 was
designed to control I Adj to less than 100 m A and keep it
constant. To do this, all quiescent operating current is
returned to the output terminal. This imposes the
requirement for a minimum load current. If the load current
is less than this minimum, the output voltage will rise.
Since the LM317 is a floating regulator, it is only the
voltage differential across the circuit which is important to
performance, and operation at high voltages with respect to
ground is possible.
External Capacitors
A 0.1 m F disc or 1.0 m F tantalum input bypass capacitor
(C in ) is recommended to reduce the sensitivity to input line
impedance.
The adjustment terminal may be bypassed to ground to
improve ripple rejection. This capacitor (C Adj ) prevents
ripple from being amplified as the output voltage is
increased. A 10 m F capacitor should improve ripple
rejection about 15 dB at 120 Hz in a 10 V application.
Although the LM317 is stable with no output capacitance,
like any feedback circuit, certain values of external
capacitance can cause excessive ringing. An output
capacitance (C O ) in the form of a 1.0 m F tantalum or 25 m F
aluminum electrolytic capacitor on the output swamps this
effect and insures stability.
Protection Diodes
When external capacitors are used with any IC regulator
it is sometimes necessary to add protection diodes to prevent
the capacitors from discharging through low current points
into the regulator.
Figure 18 shows the LM317 with the recommended
protection diodes for output voltages in excess of 25 V or
V in
LM317
Adjust
V out
V ref
+
R 1
I PROG
V out
high capacitance values (C O > 25 m F, C Adj > 10 m F). Diode
D 1 prevents C O from discharging thru the IC during an input
short circuit. Diode D 2 protects against capacitor C Adj
discharging through the IC during an output short circuit.
The combination of diodes D 1 and D 2 prevents C Adj from
discharging through the IC during an input short circuit.
I Adj
V ref = 1.25 V Typical
R 2
V out
D 1
1N4002
Figure 19. Basic Circuit Configuration
V in
LM317
V out
+
C O
Load Regulation
The LM317 is capable of providing extremely good load
regulation, but a few precautions are needed to obtain
maximum performance. For best performance, the
C in
Adjust
R 2
R 1
D 2
1N4002
C Adj
programming resistor (R 1 ) should be connected as close to
the regulator as possible to minimize line drops which
effectively appear in series with the reference, thereby
Figure 20. Voltage Regulator with Protection Diodes
degrading regulation. The ground end of R 2 can be returned
near the load ground to provide remote ground sensing and
improve load regulation.
http://onsemi.com
7
相关PDF资料 |
PDF描述 |
|---|---|
| TAJS156K006RNJ | CAP TANT 15UF 6.3V 10% 1206 |
| MR752RL | DIODE STD REC 6A 200V AXIAL |
| TAJR475M010RNJ | CAP TANT 4.7UF 10V 20% 0805 |
| T95R226M035HZAL | CAP TANT 22UF 35V 20% 2824 |
| TAJR335M010RNJ | CAP TANT 3.3UF 10V 20% 0805 |
相关代理商/技术参数 |
参数描述 |
|---|---|
| NCV317BD2TR4 | 功能描述:线性稳压器 - 标准 1.5A -1.2 to -37V RoHS:否 制造商:STMicroelectronics 输出类型: 极性: 输出电压:1.8 V 输出电流:150 mA 负载调节: 最大输入电压:5.5 V 线路调整率: 最大工作温度:+ 125 C 安装风格:SMD/SMT 封装 / 箱体:SOT-323-5L |
| NCV317BD2TR4G | 功能描述:线性稳压器 - 标准 1.5A -1.2 to -37V ADJ Positive RoHS:否 制造商:STMicroelectronics 输出类型: 极性: 输出电压:1.8 V 输出电流:150 mA 负载调节: 最大输入电压:5.5 V 线路调整率: 最大工作温度:+ 125 C 安装风格:SMD/SMT 封装 / 箱体:SOT-323-5L |
| NCV317BT | 功能描述:线性稳压器 - 标准 1.5A -1.2 to -37V RoHS:否 制造商:STMicroelectronics 输出类型: 极性: 输出电压:1.8 V 输出电流:150 mA 负载调节: 最大输入电压:5.5 V 线路调整率: 最大工作温度:+ 125 C 安装风格:SMD/SMT 封装 / 箱体:SOT-323-5L |
| NCV317BTG | 功能描述:线性稳压器 - 标准 1.5A -1.2 to -37V ADJ Positive RoHS:否 制造商:STMicroelectronics 输出类型: 极性: 输出电压:1.8 V 输出电流:150 mA 负载调节: 最大输入电压:5.5 V 线路调整率: 最大工作温度:+ 125 C 安装风格:SMD/SMT 封装 / 箱体:SOT-323-5L |
| NCV317LB | 制造商:ONSEMI 制造商全称:ON Semiconductor 功能描述:100 mA Adjustable Output, Positive Voltage Regulator |
发布紧急采购，3分钟左右您将得到回复。