参数资料
| 型号： | NCV47701PDAJR2G |
| 厂商： | ON Semiconductor |
| 文件页数： | 8/12页 |
| 文件大小： | 0K |
| 描述： | IC REG LDO ADJ .35A 8-SOIC |
| 标准包装： | 2,500 |
| 稳压器拓扑结构： | 正，可调式 |
| 输出电压： | 5 V ~ 20 V |
| 输入电压： | 5.5 V ~ 40 V |
| 电压 - 压降（标准）： | 0.25V @ 150mA |
| 稳压器数量： | 1 |
| 电流 - 输出： | 350mA（最小值） |
| 电流 - 限制（最小）： | 400mA |
| 工作温度： | -40°C ~ 150°C |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 8-SOIC（0.154"，3.90mm Width）裸露焊盘 |
| 供应商设备封装： | 8-SO 裸露焊盘 |
| 包装： | 带卷 (TR) |
NCV47701
DEFINITIONS
General
All measurements are performed using short pulse low duty
cycle techniques to maintain junction temperature as close
as possible to ambient temperature.
Output Voltage
The output voltage parameter is defined for specific
temperature, input voltage and output current values or
specified over Line, Load and Temperature ranges.
Line Regulation
The change in output voltage for a change in input voltage
measured for specific output current over operating ambient
temperature range.
Load Regulation
The change in output voltage for a change in output current
measured for specific input voltage over operating ambient
temperature range.
Dropout Voltage
The input to output differential at which the regulator output
no longer maintains regulation against further reductions in
input voltage. It is measured when the output voltage V out
has dropped ? 2% from the nominal value obtained at V in =
V out_nom + 8.5 V. The junction temperature, load current,
and minimum input supply requirements affect the dropout
level.
Quiescent and Disable Currents
Quiescent Current (I q ) is the difference between the input
current (measured through the LDO input pin) and the
output load current. If Enable pin is set to LOW the regulator
reduces its internal bias and shuts off the output, this term is
called the disable current (I DIS ).
Current Limit
Current Limit is value of output current by which output
voltage drops below 90% of its nominal value.
PSRR
Power Supply Rejection Ratio is defined as ratio of output
voltage and input voltage ripple. It is measured in decibels
(dB).
Line Transient Response
Typical output voltage overshoot and undershoot response
when the input voltage is excited with a given slope.
Load Transient Response
Typical output voltage overshoot and undershoot response
when the output current is excited with a given slope
between low ? load and high ? load conditions.
Thermal Protection
Internal thermal shutdown circuitry is provided to protect
the integrated circuit in the event that the maximum junction
temperature is exceeded. When activated at typically 175 ° C,
the regulator turns off. This feature is provided to prevent
failures from accidental overheating.
Maximum Package Power Dissipation
The power dissipation level is maximum allowed power
dissipation for particular package or power dissipation at
which the junction temperature reaches its maximum
operating value, whichever is lower.
http://onsemi.com
8
相关PDF资料 |
PDF描述 |
|---|---|
| NCV47710PDAJR2G | IC REG LDO ADJ .35A 8SOIC |
| NCV47711PDAJR2G | IC REG LDO ADJ .35A |
| NCV51411PWR2 | IC REG BUCK 1.5A 16SOIC |
| NCV5173EDR2G | IC REG MULTI CONFIG 1.5A 8SOIC |
| NCV565ST12T3G | IC REG LDO 1.2V 1.5A SOT-223 |
相关代理商/技术参数 |
参数描述 |
|---|---|
| NCV47710 | 制造商:ONSEMI 制造商全称:ON Semiconductor 功能描述:5 V to 20 V Adjustable LDO with Adjustable Current Limit and 3.3 V Logic Compatible Enable Input |
| NCV47710DAJR2G | 制造商:ON Semiconductor 功能描述:ADJ V / 350MA LDO - Tape and Reel |
| NCV47710PDAJR2G | 功能描述:低压差稳压器 - LDO ADJ V / 350MA LDO RoHS:否 制造商:Texas Instruments 最大输入电压:36 V 输出电压:1.4 V to 20.5 V 回动电压（最大值）:307 mV 输出电流:1 A 负载调节:0.3 % 输出端数量: 输出类型:Fixed 最大工作温度:+ 125 C 安装风格:SMD/SMT 封装 / 箱体:VQFN-20 |
| NCV47711 | 制造商:ONSEMI 制造商全称:ON Semiconductor 功能描述:5 V to 20 V Adjustable LDO with Adjustable Current Limit and 3.3 V Logic Compatible Enable Input |
| NCV47711DAJR2G | 制造商:ON Semiconductor 功能描述:ADJ V / 350MA LDO - Tape and Reel 制造商:ON Semiconductor 功能描述:REEL / ADJ V / 350MA LDO 制造商:ON Semiconductor 功能描述:5V~20V,Adjustable LDO |
发布紧急采购，3分钟左右您将得到回复。