参数资料
| 型号： | NCV87725D7S50R4G |
| 厂商： | ON Semiconductor |
| 文件页数： | 12/17页 |
| 文件大小： | 0K |
| 描述： | IC REG LDO 5V .35A D2PAK-7 |
| 标准包装： | 1 |
| 稳压器拓扑结构： | 正，固定式 |
| 输出电压： | 5V |
| 输入电压： | 5.5 V ~ 40 V |
| 电压 - 压降（标准）： | 0.44V @ 350mA |
| 稳压器数量： | 1 |
| 电流 - 输出： | 350mA |
| 电流 - 限制（最小）： | 400mA |
| 工作温度： | -40°C ~ 150°C |
| 安装类型： | 表面贴装 |
| 封装/外壳： | TO-263-8，D²Pak（7 引线+接片），TO-263CA |
| 供应商设备封装： | D2PAK-7 |
| 包装： | 标准包装 |
| 其它名称： | NCV87725D7S50R4GOSDKR |
NCV8772
DEFINITIONS
General
All measurements are performed using short pulse low
duty cycle techniques to maintain junction temperature as
close as possible to ambient temperature.
Output voltage
The output voltage parameter is defined for specific
temperature, input voltage and output current values or
specified over Line, Load and Temperature ranges.
Line Regulation
The change in output voltage for a change in input voltage
measured for specific output current over operating ambient
temperature range.
Load Regulation
The change in output voltage for a change in output
current measured for specific input voltage over operating
ambient temperature range.
Dropout Voltage
The input to output differential at which the regulator
output no longer maintains regulation against further
reductions in input voltage. It is measured when the output
drops 100 mV below its nominal value. The junction
temperature, load current, and minimum input supply
requirements affect the dropout level.
Quiescent and Disable Currents
Quiescent Current (I q ) is the difference between the input
current (measured through the LDO input pin) and the
output load current. If Enable pin is set to LOW the regulator
reduces its internal bias and shuts off the output, this term is
Current Limit and Short Circuit Current Limit
Current Limit is value of output current by which output
voltage drops below 96% of its nominal value. Short Circuit
Current Limit is output current value measured with output
of the regulator shorted to ground.
PSRR
Power Supply Rejection Ratio is defined as ratio of output
voltage and input voltage ripple. It is measured in decibels
(dB).
Line Transient Response
Typical output voltage overshoot and undershoot
response when the input voltage is excited with a given
slope.
Load Transient Response
Typical output voltage overshoot and undershoot
response when the output current is excited with a given
slope between low ? load and high ? load conditions.
Thermal Protection
Internal thermal shutdown circuitry is provided to protect
the integrated circuit in the event that the maximum junction
temperature is exceeded. When activated at typically 175 ° C,
the regulator turns off. This feature is provided to prevent
failures from accidental overheating.
Maximum Package Power Dissipation
The power dissipation level is maximum allowed power
dissipation for particular package or power dissipation at
which the junction temperature reaches its maximum
operating value, whichever is lower.
called the disable current (I DIS ).
http://onsemi.com
12
相关PDF资料 |
PDF描述 |
|---|---|
| NCV8800SDW33R2G | IC REG BUCK SYNC 3.3V 1A 16SOIC |
| NCV8842DG | IC REG BUCK 1.5A 8SOIC |
| NCV8843DG | IC REG BUCK 1.5A 8SOIC |
| NCV8852DR2G | IC REG CTRLR BUCK PWM CM 8-SOIC |
| NCV885300D1R2G | IC REG CTRLR BUCK PWM CM 8SOIC |
相关代理商/技术参数 |
参数描述 |
|---|---|
| NCV8772AD7S | 制造商:ONSEMI 制造商全称:ON Semiconductor 功能描述:Ultra Low Iq 350 mA LDO Regulator with Enable and |
| NCV8772BD7S | 制造商:ONSEMI 制造商全称:ON Semiconductor 功能描述:Ultra Low Iq 350 mA LDO Regulator with Enable and |
| NCV8772CD7S | 制造商:ONSEMI 制造商全称:ON Semiconductor 功能描述:Ultra Low Iq 350 mA LDO Regulator with Enable and |
| NCV8772DD7S | 制造商:ONSEMI 制造商全称:ON Semiconductor 功能描述:Ultra Low Iq 350 mA LDO Regulator with Enable and |
| NCV8772ED7S | 制造商:ONSEMI 制造商全称:ON Semiconductor 功能描述:Ultra Low Iq 350 mA LDO Regulator with Enable and |
发布紧急采购，3分钟左右您将得到回复。