- 您现在的位置：买卖IC网 > Datasheet目录870 > NGA10S15050SEC (Murata Power Solutions Inc)CONV DC/DC 2A 5.0V SIP NON-ISO Datasheet资料下载
参数资料
| 型号： | NGA10S15050SEC |
| 厂商： | Murata Power Solutions Inc |
| 文件页数： | 3/6页 |
| 文件大小： | 0K |
| 描述： | CONV DC/DC 2A 5.0V SIP NON-ISO |
| 标准包装： | 25 |
| 系列： | NGA |
| 类型： | 非隔离（POL） |
| 输出数： | 1 |
| 电压 - 输入（最小）： | 4.75V |
| 电压 - 输入（最大）： | 28V |
| Voltage - Output 1： | 5V |
| 电流 - 输出（最大）： | 2A |
| 电源（瓦） - 制造商系列： | 10W |
| 安装类型： | 通孔 |
| 封装/外壳： | 5-SIP 模块 |
| 尺寸/尺寸： | 0.83" L x 0.22" W x 0.88" H（21.1mm x 5.6mm x 22.4mm） |
| 包装： | 托盘 |
| 工作温度： | -40°C ~ 85°C |
| 效率： | 95% |
| 电源（瓦特）- 最大： | 10W |
| 产品目录页面： | 2716 (CN2011-ZH PDF) |
| 其它名称： | 811-1414 |
NGA Series
Non-Isolated Wide Input DC/DC Converters
APPLICATION NOTES
External Capacitance
External capacitors are necessary in order to guarantee stability and full paramet-
ric performance over the full line and load range. All parts have been tested and
characterised using the following values and test circuit.
Value
Test Circuit
C IN
100μF, 50V
C OUT
100μF, 10V
Voltage trimming
The trimming (adjust) input on the device allows output voltage adjustment to
within ±5% 1 of the desired V OUT using a resistor with a value determined by the
following equations.
When open circuit, the output will be +5V.
A resistor (R D ) between the trim pin and the output pin will adjust the output volt-
age between +5V to +1.8V.
Shutdown
When the shutdown pin is shorted to Common, the device’s output will be dis-
abled. To shutdown the device the pin should be taken below 0.8V using either an
1
R D
= (22 [1.028V O -1]) -1 -0.011
open collector pull down or by using isolated delay contacts. To enable the device
output the shutdown pin should be left ?oating or taken no lower than +1.5V to a
maximum of (+28V).
If the shutdown pin is to be connected to a long wire, it is recommended that a
capacitor (10nF) decouples the shutdown pin to Common in order to avoid the risk
of injecting noise into the device circuit.
A resistor (R U ) between the trim pin and the Common pin will adjust the device
output from +5V to +5.5V.
1
R U
91
= ( (1.02V O )-1 ) -0.0455
All speci?cations typical at T A =25°C, nominal input voltage and rated output current unless otherwise speci?ed.
1. Accuracy of adjustment is subject to tolerance of resistors and initial output accuracy.
www.murata-ps.com
Technical enquiries email: mk@murata-ps.com, tel: +44 (0)1908 615232
2013-01-24
KDC_NGAC.F03 Page 3 of 6
相关PDF资料 |
PDF描述 |
|---|---|
| NH12 | BATT NIMH AAA 1.2V 700MAH BULK |
| NH15 | BATT NIMH AA 1.2V 2300MAH W/TAB |
| NH22 | BATT NIMH 9V 175MAH BULK |
| NH35BP | BATT NIMH C 1.2V 2500MAH W/TAB |
| NH50BP | BATT NIMH D 1.2V 2500MAH W/TAB |
相关代理商/技术参数 |
参数描述 |
|---|---|
| NGA-1101443-0202A_A | 功能描述:能量采集模块 HV14 eTEG PWR GEN 33mW 1.8X1.5MM RoHS:否 制造商:Nextreme Thermal Solutions 转换能源:Thermal 能量输出类型:DC 输出电压:3.3 V 输出功率:50 mW 输入电压: 输入电流:15 mA 最大热源:100 C 最大工作温度: 尺寸:38.65 mm x 35 mm |
| NGA130 | 制造商:未知厂家 制造商全称:未知厂家 功能描述:Optoelectronic |
| NGA136 | 制造商:未知厂家 制造商全称:未知厂家 功能描述:Optoelectronic |
| NGA140 | 制造商:未知厂家 制造商全称:未知厂家 功能描述:Optoelectronic |
| NGA143 | 制造商:未知厂家 制造商全称:未知厂家 功能描述:Optoelectronic |
发布紧急采购，3分钟左右您将得到回复。