- 您现在的位置：买卖IC网 > PDF目录363704 > NTE7047 (NTE Electronics, Inc.) Integrated Circuit TV Color Small Signal Sub System PDF资料下载
参数资料
| 型号： | NTE7047 |
| 厂商： | NTE Electronics, Inc. |
| 英文描述： | Integrated Circuit TV Color Small Signal Sub System |
| 中文描述： | 集成电路彩色电视小信号子系统 |
| 文件页数： | 6/8页 |
| 文件大小： | 56K |
| 代理商： | NTE7047 |
Electrical Characteristics (Cont
’
d):
(T
A
= +25
°
C, V
P
= V
7
–
6
= 12V, carrier 38.9MHz, negative
modulation unless otherwise specified)
Parameter
Symbol
Test Conditions
Min
Typ
Max
Unit
Vertical Circuit (Cont
’
d)
(Vertical Guard, Note 24, Note 25)
Active Switching Level at a Deviation
with Respect to the DC Feedback
Level: Guard Level HIGH
V
4
V
27
= 2.5V
–
2.0
–
V
Notes:
Note 2. On set AGC.
Note 3. The input impedance has been chosen such that a SAW
–
filter can be applied.
Note 4. Measured with 0dB = 450
μ
V.
Note 5. Measured at 10mV (RMS value) top sync input signal.
Note 6. So
–
called projected zero point; i.e. with switched demodulator.
Note 7. White 10% of the top sync amplitude.
Note 8. The differential gain is expressed as a percentage of the difference in peak amplitude be-
tween the largest and smallest value relative to the subcarrier amplitude at blanking level.
The differential phase is defined as the difference in degrees between the largest and small-
est phase angle. The differential gain and phase are measured with a DSB signal.
Note 9. This figure is valid for the complete video signal amplitude (peak white
–
to
–
black). The non
–
linearity is expressed as a percentage of the maximum deviation of a luminance step from
the mean step, with respect to the mean step.
Note10. The figures are measured at an input signal of 10mV (RMS value).
Note11. Measured with a source impedance of 75
.
V
out black
–
to
–
white
V
n(rms)
at B = 5MHz
Note12. The AFC control voltage is obtained by multiplying the IF output signal (which is also used
to drive the synchronous demodulator) with a reference carrier. This reference carrier is ob-
tained from the demodulator tuned circuit via a 90 degree phase shift network. The IF output
signal has an asymmetrical frequency spectrum with respect to the carrier frequency. To
avoid problems due to this asymmeterical signal the AFC circuit is followed by a sample
–
and
–
hold circuit which samples during the sync level. As a result the AFC output voltage con-
tains no video information. The specified control steepness is without using an external load
resistor. The control steepness decreases when the AFC output is loaded with two resistors
between the voltage supply and GND.
Note13. At very weak input signals the drive signal for the AFC circuit will have a high noise content.
This noise input has an asymmetrical frequency spectrum which will cause an offset of the
AFC output voltage. To avoid problems due to this effect a notch filter can be built in to the
demodulator tuned circuit. The characteristics given for waek input signals are measured
without a notch circuit, with a SAW filter connected in front of the IC (input signal such that
the input signal of the IC is 150
μ
V (RMS value).
Note14. The sound circuit is measured (unless otherwise specified) with an input signal of V
15
of
50mV (RMS value), a carrier frequency of 5.5MHz at a
f of 27.5kHz and AF frequency of
1kHz. The QL of the demodulator tuned circuit is 16 and the volume control is connected to
the supply. The reference circuit must be tuned in such a way that the output is symmetrical
clipping at maximum volume.
Note15. The output signal is measured at a
f = 7.5kHz and maximum volume control.
Note16. The demodulator tuned circuit must be tuned at minimum distortion.
Note17. Weighted noise, measured according to: CCIR 468.
Note18. See also Note 1. The volume can be controlled by using a potentiometer connected to GND
(value 10k
) or by means of a variable direct voltage. In the latter case the relatively low input
impedance (Pin11) must be taken into account.
Signal
–
to
–
noise ratio = 20 log
相关PDF资料 |
PDF描述 |
|---|---|
| NTE7048 | Integrated Circuit NTSC Decoder w/Fast RGB Blanking |
| NTE7049 | Integrated Circuit CMOS-Sync Generator for TV & Video Processing Systems |
| NTE704 | Integrated Circuit TV Sound, IF Amp |
| NTE7050 | Integrated Circuit Phase Lock Loop (PLL) Stereo Decoder |
| NTE7051 | Integrated Circuit 1W BTL Mono Audio Amplifier |
相关代理商/技术参数 |
参数描述 |
|---|---|
| NTE7048 | 制造商:NTE Electronics 功能描述:IC - NTSC DECODER WITH FAST RGB BLANKING 20-LEAD DIP VCC = 9V TYPICAL 制造商:NTE Electronics 功能描述:IC-NTSC DECODER |
| NTE7049 | 制造商:NTE Electronics 功能描述:CMOS-Sync Generator for TV & Video Processing Systems 制造商:NTE Electronics 功能描述:LSI sync generator 24-Pin PDIP |
| NTE7050 | 制造商:NTE Electronics 功能描述:IC - PHASE LOCK LOOP STEREO DECODER 16-LEAD DIP VCC = 8.5V TYPICAL |
| NTE7051 | 制造商:NTE Electronics 功能描述:IC-1W BTL MONO AUDIO AMP 制造商:NTE Electronics 功能描述:IC, AUDIO POWER AMPLIFIER, 1W, DIP-8; No. of Channels:1; Output Power:1W; Supply Voltage Range:3V to 15V; Amplifier Case Style:DIP; No. of Pins:8; Load Impedance:8ohm; Input Bias Current:300nA; Input Offset Voltage Max:100mV ;RoHS Compliant: Yes 制造商:NTE Electronics 功能描述:Audio Amp Speaker 1-CH Mono 1.2W Class-AB 8-Pin PDIP |
| NTE7052 | 制造商:NTE Electronics 功能描述:IC - 3W MONO BTL AUDIO AMP 9-LEAD SIP VP = 11V TYPICAL 制造商:NTE Electronics 功能描述:IC-3WATT MONO BTL AUDIO 制造商:NTE Electronics 功能描述:Audio Amp Speaker 1-CH Mono 3W Class-AB 9-Pin(9+Tab) SIP |
发布紧急采购，3分钟左右您将得到回复。