- 您现在的位置：买卖IC网 > PDF目录8126 > OKY2-T/10-W5P-C (Murata Power Solutions Inc)CONV DC/DC 33W 5V IN 10A OUT SMD PDF资料下载
参数资料
| 型号： | OKY2-T/10-W5P-C |
| 厂商： | Murata Power Solutions Inc |
| 文件页数： | 7/16页 |
| 文件大小： | 0K |
| 描述： | CONV DC/DC 33W 5V IN 10A OUT SMD |
| 标准包装： | 250 |
| 系列： | Okami™ OKY-T/10-W5 |
| 类型： | 非隔离（POL） |
| 输出数： | 1 |
| 电压 - 输入（最小）： | 2.4V |
| 电压 - 输入（最大）： | 5.5V |
| Voltage - Output 1： | 0.75 ~ 3.63 V |
| 电流 - 输出（最大）： | 10A |
| 电源（瓦） - 制造商系列： | 33W |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 7-DIP SMD 模块 |
| 尺寸/尺寸： | 1.30" L x 0.53" W x 0.33" H（33.0mm x 13.5mm x 8.4mm） |
| 包装： | 带卷 (TR) |
| 工作温度： | -40°C ~ 85°C |
| 效率： | 95.5% |
| 电源（瓦特）- 最大： | 33W |
OKY -T/10 & T/16-W5 Series
Programmable DOSA-SMT 10/16-Amp DC/DC Converters
CAUTION : If you routinely or accidentally exceed these Derating guidelines,
+OUTPUT
COPPER STRIP
the converter may have an unplanned Over Temperature shut down. Also, these
graphs are all collected at slightly above Sea Level altitude. Be sure to reduce
the derating for higher density altitude.
C1
C2
SCOPE
R LOAD
Output Fusing
The converter is extensively protected against current, voltage and temperature
extremes. However your output application circuit may need additional protec-
-OUTPUT
COPPER STRIP
C1 = 0.1μF CERAMIC
C2 = 10μF TANTALUM
LOAD 2-3 INCHES (51-76mm) FROM MODULE
Figure 3. Measuring Output Ripple and Noise (PARD)
Minimum Output Loading Requirements
All models regulate within speci?cation and are stable under no load to full
load conditions. Operation under no load might however slightly increase
output ripple and noise.
Thermal Shutdown
To prevent many over temperature problems and damage, these converters
include thermal shutdown circuitry. If environmental conditions cause the
temperature of the DC/DC’s to rise above the Operating Temperature Range
up to the shutdown temperature, an on-board electronic temperature sensor
will power down the unit. When the temperature decreases below the turn-on
threshold, the converter will automatically restart. There is a small amount of
hysteresis to prevent rapid on/off cycling.
CAUTION: If you operate too close to the thermal limits, the converter may
shut down suddenly without warning. Be sure to thoroughly test your applica-
tion to avoid unplanned thermal shutdown.
Temperature Derating Curves
The graphs in this data sheet illustrate typical operation under a variety of
conditions. The Derating curves show the maximum continuous ambient air
temperature and decreasing maximum output current which is acceptable
under increasing forced air?ow measured in Linear Feet per Minute (“LFM”).
Note that these are AVERAGE measurements. The converter will accept brief
increases in current or reduced air?ow as long as the average is not exceeded.
Note that the temperatures are of the ambient air?ow, not the converter
itself which is obviously running at higher temperature than the outside air.
Also note that very low ?ow rates (below about 25 LFM) are similar to “natural
convection”, that is, not using fan-forced air?ow.
Murata Power Solutions makes Characterization measurements in a closed
cycle wind tunnel with calibrated air?ow. We use both thermocouples and an
tion. In the extremely unlikely event of output circuit failure, excessive voltage
could be applied to your circuit. Consider using an appropriate fuse in series
with the output.
Output Current Limiting
Current limiting inception is de?ned as the point at which full power falls below
the rated tolerance. See the Performance/Functional Speci?cations. Note par-
ticularly that the output current may brie?y rise above its rated value in normal
operation as long as the average output power is not exceeded. This enhances
reliability and continued operation of your application. If the output current is
too high, the converter will enter the short circuit condition.
Output Short Circuit Condition
When a converter is in current-limit mode, the output voltage will drop as the
output current demand increases. If the output voltage drops too low (approxi-
mately 98% of nominal output voltage for most models), the magnetically
coupled voltage used to develop primary side voltages will also drop, thereby
shutting down the PWM controller. Following a time-out period, the PWM will
restart, causing the output voltage to begin ramping up to its appropriate value.
If the short-circuit condition persists, another shutdown cycle will initiate. This
rapid on/off cycling is called “hiccup mode”. The hiccup cycling reduces the
average output current, thereby preventing excessive internal temperatures
and/or component damage. A short circuit can be tolerated inde?nitely.
The “hiccup” system differs from older latching short circuit systems
because you do not have to power down the converter to make it restart. The
system will automatically restore operation as soon as the short circuit condi-
tion is removed.
Remote On/Off Control
On the input side, a remote On/Off Control can be ordered with either polarity.
Please refer to the Connection Diagram on page 1 for On/Off connections.
Positive polarity models are enabled when the On/Off pin is left open or is
pulled high to +Vin with respect to –Vin. Positive-polarity devices are disabled
when the On/Off is grounded or brought to within a low voltage (see Speci?ca-
tions) with respect to –Vin.
Negative polarity devices are on (enabled) when the On/Off pin is left open
or brought to within a low voltage (see Speci?cations) with respect to –Vin. The
device is off (disabled) when the On/Off is pulled high (see Speci?cations) with
respect to –Vin.
infrared camera system to observe thermal performance.
www.murata-ps.com/support
MDC_OKY_T10T16.W5.A05 Page 7 of 16
相关PDF资料 |
PDF描述 |
|---|---|
| OKY-T/16-W5P-C | CONV DC/DC 52.8W 5VIN 16AOUT SMD |
| OKY2-T/10-D12P-C | CONV DC/DC 50W 12VIN 10AOUT SMD |
| OKY-T/16-D12P-C | CONV DC/DC 80W 12VIN 16AOUT SMD |
| MC74LCX573DW | IC LATCH TRANSP OCT LV 20-SOICW |
| OSTTJ0611520 | CONN TERM BLK PLUG 6POS 3.5MM |
相关代理商/技术参数 |
参数描述 |
|---|---|
| OKY-T | 制造商:MURATA 制造商全称:Murata Manufacturing Co., Ltd. 功能描述:Adjustable Output 3 and 5-Amp DOSA-SMT PoLs |
| OKY-T/10 | 制造商:MURATA-PS 制造商全称:Murata Power Solutions Inc. 功能描述:Programmable DOSA-SMT 10/16-Amp DC/DC Converters |
| OKY-T/10-D12N-C | 功能描述:DC/DC转换器 12Vin 0.7525-5.5Vout 10A 50W Neg Polarity RoHS:否 制造商:Murata 产品: 输出功率: 输入电压范围:3.6 V to 5.5 V 输入电压（标称）: 输出端数量:1 输出电压（通道 1）:3.3 V 输出电流（通道 1）:600 mA 输出电压（通道 2）: 输出电流（通道 2）: 安装风格:SMD/SMT 封装 / 箱体尺寸: |
| OKY-T/10-D12P-C | 功能描述:DC/DC转换器 12Vin 0.7525-5.5Vout 10A 50W Pos Polarity RoHS:否 制造商:Murata 产品: 输出功率: 输入电压范围:3.6 V to 5.5 V 输入电压（标称）: 输出端数量:1 输出电压（通道 1）:3.3 V 输出电流（通道 1）:600 mA 输出电压（通道 2）: 输出电流（通道 2）: 安装风格:SMD/SMT 封装 / 箱体尺寸: |
| OKY-T/10-W5 | 制造商:Murata Power Solutions 功能描述:- Rail/Tube |
发布紧急采购，3分钟左右您将得到回复。