参数资料
型号: OP291C
厂商: TT Electronics/Optek Technology
文件页数: 3/8页
文件大小: 0K
描述: DIODE IR PLASTIC GAAIAS T-1 3/4
产品培训模块: LED Thermal Management
标准包装: 1
系列: OP290
电流 - DC 正向(If): 150mA
波长: 890nm
正向电压: 5.0V
视角: 50°
方向: 顶视图
安装类型: 通孔
封装/外壳: T 1 3/4
包装: 散装
Plastic Infrared Emitting Diode
OP290 Series
Absolute Maximum Ratings (T A =25°C unless otherwise noted)
Storage and Operating Temperature Range
Reverse Voltage
OP290, OP292, OP294, OP295, OP297, OP299
OP291, OP293, OP296, OP298
Continuous Forward Current
OP290, OP291, OP292
OP294, OP295, OP299
OP295, OP296, OP297
Continuous Forward Current, OP293, OP298
Free Air
Board Mounted
Full Heat Sink
Peak Forward Current
OP290, OP295 (25 μs pulse width)
OP291, OP296 (100 μs pulse width)
OP292, OP297 (100 μs pulse width)
OP293, OP298 (25 μs pulse width)
OP294, OP299
-40 o C to +100 o C
5.0 V
2.0 V
150 mA (1)
100 mA (1)
150 mA (1)
100 mA
133 mA
200 mA
5.0 A
2.0 A
1.00 A
2.0 A
750 mA
Notes:
1. For OP290, OP291, OP292, OP295, OP296 and OP297, derate linearly 1.67 mA/° C above 25° C (free-air). When used with heat
sink (see note 5), derate linearly 2.07 mA/° C above 65° C (normal use). For OP293 and OP298, when measured in free-air, derate
power dissipation linearly 1.43 mW/° C above 25° C. For OP294 and OP299, derate linearly 1.80 mW/° C above 25° C.
Absolute Maximum Ratings (T A =25°C unless otherwise noted)
Maximum Duty Cycle
OP290 (25 μs pulse width @ 5 A)
Lead Soldering Temperature [1/16 inch (1.6 mm) from case for 5 seconds with soldering iron]
Power Dissipation, Free Air
OP290, OP291, OP292, OP295, OP296, OP297
OP293, OP298
Power Dissipation, Board Mounted
OP290, OP291, OP292, op295, OP296, OP297
OP293, OP298
Power Dissipation, Full Heat Sink
OP290, OP291, OP292, OP295, OP296, OP297
OP293, OP298
Power Dissipation
OP294, OP299
1.25% (1)
260° C (2)
333 mW (3)
142 mW (3)
533 mW (4)
200 mW (4)
1.11 W (5)
400 mW (5)
180 mW
Notes:
1. For OP290, OP291, OP292, OP295, OP296 and OP297, refer to graph of Maximum Peak Pulse Current vs Pulse Width.
2. For all OPs in this series, RMA flux is recommended. Duration can be extended to 10 second maximum when soldering. A
maximum of 20 grams force may be applied to the leads when flow soldering.
3. For OP290, OP291, OP292, OP295, OP296 and OP297, measured in free-air. Derate linearly 3.33 mW/° C above 25° C.
4. For OP290, OP291and OP292, mounted on 1/16” (1.6 mm) thick PCBoard with each lead soldered through 80 mil square lands
0.250” (6.35 mm) below flange of device. Derate linearly 5.33 mW/°C above 62.5°. For OP293 and OP298, mounted on 1/16” (1.60
mm) thick PCBoard with each lead soldered through 80 mil square lands 0.250” (6.35 mm) below flange of device. Derate power
dissipation linearly 2.00 mW/°C above 25° C (normal use). For OP295, OP296 and OP297, mounted on 1/16” (1.6 mm) thick
PCBoard with each lead soldered through 80 mil square lands 0.250” (6.35 mm) below flange of device. Derate linearly 5.33 mW/°C
above 25° C.
5. Immersed in silicone fluid to simulate infinite heat sink. For OP290, OP291 and OP292, derate linearly 11.1 mW/°C above 95°C. For
OP293 and OP298, derate power dissipation linearly 2.50 mW/° C above 25° C. For OP295, OP296 and OP297, derate linearly 11.1
mW/° C above 25° C.
OPTEK reserves the right to make changes at any time in order to improve design and to supply the best product possible.
OPTEK Technology Inc. — 1645 Wallace Drive, Carrollton, Texas 75006
Phone: (972) 323-2200 or (800) 341-4747 FAX: (972) 323-2396 sensors@optekinc.com www.optekinc.com
Issue C
03/2012
Page 3 of 8
相关PDF资料
PDF描述
P51-100-S-N-I12-4.5OV SENSOR 100PSI 1.2-20 UNF-2A 4.5V
OP291B DIODE IR PLASTIC GAAIAS T-1 3/4
P51-75-S-N-I12-4.5OV SENSOR 75PSI 1.2-20 UNF-2A 4.5V
OP290C DIODE IR PLASTIC GAAIAS T-1 3/4
P51-50-S-N-I12-4.5OV SENSOR 50PSI 1.2-20 UNF-2A 4.5V
相关代理商/技术参数
参数描述
OP291GBC 制造商:AD 制造商全称:Analog Devices 功能描述:Micropower Single-Supply Rail-to-Rail Input/Output Op Amps
OP291GP 制造商:Analog Devices 功能描述:OP AMP DUAL MICROPOWER RRI/O 291
OP291GS 功能描述:IC OPAMP GP R-R 3MHZ DUAL 8SOIC RoHS:否 类别:集成电路 (IC) >> Linear - Amplifiers - Instrumentation 系列:- 标准包装:50 系列:- 放大器类型:J-FET 电路数:2 输出类型:- 转换速率:13 V/µs 增益带宽积:3MHz -3db带宽:- 电流 - 输入偏压:65pA 电压 - 输入偏移:3000µV 电流 - 电源:1.4mA 电流 - 输出 / 通道:- 电压 - 电源,单路/双路(±):7 V ~ 36 V,±3.5 V ~ 18 V 工作温度:-40°C ~ 85°C 安装类型:通孔 封装/外壳:8-DIP(0.300",7.62mm) 供应商设备封装:8-PDIP 包装:管件
OP291GS-REEL 功能描述:IC OPAMP GP R-R 3MHZ DUAL 8SOIC RoHS:否 类别:集成电路 (IC) >> Linear - Amplifiers - Instrumentation 系列:- 标准包装:100 系列:- 放大器类型:通用 电路数:1 输出类型:- 转换速率:0.2 V/µs 增益带宽积:- -3db带宽:- 电流 - 输入偏压:100pA 电压 - 输入偏移:30µV 电流 - 电源:380µA 电流 - 输出 / 通道:- 电压 - 电源,单路/双路(±):±2 V ~ 18 V 工作温度:0°C ~ 70°C 安装类型:表面贴装 封装/外壳:8-SOIC(0.154",3.90mm 宽) 供应商设备封装:8-SO 包装:管件
OP291GS-REEL7 功能描述:IC OPAMP GP R-R 3MHZ DUAL 8SOIC RoHS:否 类别:集成电路 (IC) >> Linear - Amplifiers - Instrumentation 系列:- 标准包装:100 系列:- 放大器类型:通用 电路数:1 输出类型:- 转换速率:0.2 V/µs 增益带宽积:- -3db带宽:- 电流 - 输入偏压:100pA 电压 - 输入偏移:30µV 电流 - 电源:380µA 电流 - 输出 / 通道:- 电压 - 电源,单路/双路(±):±2 V ~ 18 V 工作温度:0°C ~ 70°C 安装类型:表面贴装 封装/外壳:8-SOIC(0.154",3.90mm 宽) 供应商设备封装:8-SO 包装:管件