- 您现在的位置：买卖IC网 > Datasheet目录62 > OPB804 (TT Electronics/Optek Technology)SENS OPTO SLOT 3.94MM TRANS THRU Datasheet资料下载
参数资料
| 型号： | OPB804 |
| 厂商： | TT Electronics/Optek Technology |
| 文件页数： | 2/3页 |
| 文件大小： | 147K |
| 描述： | SENS OPTO SLOT 3.94MM TRANS THRU |
| 产品培训模块： | Slotted Switches |
| 标准包装： | 1 |
| 检测距离： | 0.155"（3.94mm） |
| 检测方法： | 可传导的 |
| 输出配置： | 光电晶体管 |
| 电流 - DC 正向(If)： | 50mA |
| 电流 - 集电极 (Ic)（最大）： | 30mA |
| 电压 - 集电极发射极击穿（最大）： | 30V |
| 安装类型： | 通孔 |
| 封装/外壳： | PCB 安装 |
| 包装： | 散装 |
| 类型： | 无放大 |
| 工作温度： | -40°C ~ 85°C |
| 产品目录页面： | 2788 (CN2011-ZH PDF) |
| 其它名称： | 365-1017 |
OPTEK Technology Inc. 1645 Wallace Drive, Carrollton, Texas 75006
Phone: (972) 323-2200 or (800) 341-4747 FAX: (972) 323-2396 sensors@optekinc.com www.optekinc.com
Issue B 06/2012
Page 2 of 3
OPTEK reserves the right to make changes at any time in order to improve design and to supply the best product possible.
Slotted Optical Switch
OPB804
Electrical Characteristics ( T
A
= 25癈 )
SYMBOL
PARAMETER
MIN TYP MAX UNITS
TEST CONDITIONS
Input Diode (see OP140 or OP240 for additional information)
V
F
Forward Voltage
- 1.25 1.70 V I
F
= 20 mA
I
R
Reverse Current
- - - - Not designed for reverse operation
Output Phototransistor (see OP550 for additional information)
V
(BR)CEO
Collector-Emitter Breakdown Voltage 30 - - V I
C
= 1 mA, E
E
= 0 mw/cm
2
V
(BR)ECO
Emitter-Collector Breakdown Voltage 5.0 - - V I
E
= 100 礎, E
E
= 0 mw/cm
2
I
CEO
Collector Dark Current
- - 100 nA V
CE
= 10 V, I
F
= 0, E
E
= 0 mw/cm
2
Coupled
V
CE(SAT)
Collector-Emitter Saturation Voltage - - 0.40 V I
C
= 250 礎, I
F
= 20 mA
I
C(ON)
On-State Collector Current
0.5 5 - mA V
CE
= 10 V, I
F
= 20 mA
Absolute Maximum Ratings
Storage Temperature Range
-40癈 to +100?C
Operating Temperature Range
-40癈 to +85?C
Lead Soldering Temperature
260?C
( 5)
Input Diode
Input Diode Power Dissipation
75 mW
( 7)
Input Diode Forward D.C. Current, T
A
= 25癈
50 mA
( 7)
Input Diode Peak Forward Pulse Current, T
A
= 25癈 (1祍 pulse width, 300pps)
1 A
Phototransistor
Power Dissipation
100 mW
( 7)
Collector - Emitter Voltage
30V
Emitter - Collector Voltage
5.0V
Notes:
(1) Dot indicates # 3 collector lead side.
(2) Feature controlled at body.
(3) Cathode lead may be shorter.
(4) RMA flux recommended. Highly activated water soluble fluxes may attack plastic. Recommend trial to verify application.
(5) Maximum lead soldering temperature .060 [1.6mm] from case for 5 seconds with soldering iron.
(6) Plastic is soluble in chlorinated hydrocarbons and ketones. Methanol or isopropanol are recommended as cleaning agents.
(7) Derate linearly 1.67 mW/癈 above 25?C.
(8) All parameters tested using pulse techniques.
(9) Do not connect input diode directly to a voltage source without an external current limiting resistor.
(10) Do not apply reverse voltage to LED. LED will be a 0V in reverse voltage and draw current as if a short.
相关PDF资料 |
PDF描述 |
|---|---|
| OPB806 | SENS OPTO SLOT 3.18MM TRANS THRU |
| OPB815W | SENS OPTO SLOT 9.53MM TRANS C-MT |
| OPB821S5Z | SENS OPTO SLOT 2.03MM TRANS C-MT |
| OPB821TXV | SENS OPTO SLOT 2.03MM TRANS C-MT |
| OPB825B | SENS OPTO SLOT 4.06MM TRANS THRU |
相关代理商/技术参数 |
参数描述 |
|---|---|
| OPB804 | 制造商:TT Electronics / OPTEK Technology 功能描述:OPTO SWITCH SLOTTED |
| OPB806 | 功能描述:光学开关（透射型，光电晶体管输出） Slotted Opt Switch RoHS:否 制造商:Omron Electronics 输出设备:Phototransistor 槽宽:3.4 mm 光圈宽度:0.5 mm 集电极—发射极最大电压 VCEO:30 V 最大集电极电流:20 mA 正向电流: 安装风格:Through Hole 最大工作温度:+ 85 C 最小工作温度:- 25 C 封装: |
| OPB806_05 | 制造商:OPTEK 制造商全称:OPTEK 功能描述:Slotted Optical Switch |
| OPB810L | 制造商:OPTEK 制造商全称:OPTEK 功能描述:WIDE GAP SLOTTED OPTICAL SWITCHES |
| OPB810L51 | 功能描述:光学开关（透射型，光电晶体管输出） .375" WIDE GAP 890NM RoHS:否 制造商:Omron Electronics 输出设备:Phototransistor 槽宽:3.4 mm 光圈宽度:0.5 mm 集电极—发射极最大电压 VCEO:30 V 最大集电极电流:20 mA 正向电流: 安装风格:Through Hole 最大工作温度:+ 85 C 最小工作温度:- 25 C 封装: |
发布紧急采购，3分钟左右您将得到回复。