参数资料
型号: P89C58X2BA
厂商: NXP SEMICONDUCTORS
元件分类: 微控制器/微处理器
英文描述: 80C51 8-bit Flash microcontroller family
中文描述: 8-BIT, FLASH, 33 MHz, MICROCONTROLLER, PQCC44
封装: PLASTIC, LCC-44
文件页数: 12/32页
文件大小: 212K
代理商: P89C58X2BA
Philips Semiconductors
Product specification
89C51/89C52/89C54/89C58
80C51 8-bit microcontroller family
4K/8K/16K/32K Flash
1999 Oct 27
12
OSC
÷
2
C/T2 = 0
C/T2 = 1
TR2
Control
TL2
(8-bits)
TH2
(8-bits)
÷
16
RCAP2L
RCAP2H
EXEN2
Control
EXF2
Timer 2
Interrupt
T2EX Pin
Transition
Detector
T2 Pin
Reload
NOTE: OSC. Freq. is divided by 2, not 12.
÷
2
“0”
“1”
RX Clock
÷
16
TX Clock
“0”
“1”
“0”
“1”
Timer 1
Overflow
Note availability of additional external interrupt.
SMOD
RCLK
TCLK
SU00068
Figure 6. Timer 2 in Baud Rate Generator Mode
Table 4.
Timer 2 Generated Commonly Used
Baud Rates
Ba d Rate
Baud Rate
Osc Freq
Timer 2
RCAP2H
RCAP2L
375 k
9.6 k
2.8 k
2.4 k
1.2 k
300
110
300
110
12 MHz
12 MHz
12 MHz
12 MHz
12 MHz
12 MHz
12 MHz
6 MHz
6 MHz
FF
FF
FF
FF
FE
FB
F2
FD
F9
FF
D9
B2
64
C8
1E
AF
8F
57
Baud Rate Generator Mode
Bits TCLK and/or RCLK in T2CON (Table 4) allow the serial port
transmit and receive baud rates to be derived from either Timer 1 or
Timer 2. When TCLK= 0, Timer 1 is used as the serial port transmit
baud rate generator. When TCLK= 1, Timer 2 is used as the serial
port transmit baud rate generator. RCLK has the same effect for the
serial port receive baud rate. With these two bits, the serial port can
have different receive and transmit baud rates – one generated by
Timer 1, the other by Timer 2.
Figure 6 shows the Timer 2 in baud rate generation mode. The baud
rate generation mode is like the auto-reload mode, in that a rollover in
TH2 causes the Timer 2 registers to be reloaded with the 16-bit value
in registers RCAP2H and RCAP2L, which are preset by software.
The baud rates in modes 1 and 3 are determined by Timer 2’s
overflow rate given below:
Modes 1 and 3 Baud Rates
Timer 2 Overflow Rate
16
The timer can be configured for either “timer” or “counter” operation.
In many applications, it is configured for “timer” operation (C/T2*=0).
Timer operation is different for Timer 2 when it is being used as a
baud rate generator.
Usually, as a timer it would increment every machine cycle (i.e., 1/12
the oscillator frequency). As a baud rate generator, it increments
every state time (i.e., 1/2 the oscillator frequency). Thus the baud
rate formula is as follows:
Oscillator Frequency
[65536
(RCAP2H,RCAP2L)]]
[32
Modes 1 and 3 Baud Rates =
Where:
RCAP2L taken as a 16-bit unsigned integer.
(RCAP2H, RCAP2L) = The content of RCAP2H and
The Timer 2 as a baud rate generator mode shown in Figure 6, is
valid only if RCLK and/or TCLK = 1 in T2CON register. Note that a
rollover in TH2 does not set TF2, and will not generate an interrupt.
Thus, the Timer 2 interrupt does not have to be disabled when
Timer 2 is in the baud rate generator mode. Also if the EXEN2
(T2 external enable flag) is set, a 1-to-0 transition in T2EX
(Timer/counter 2 trigger input) will set EXF2 (T2 external flag) but
will not cause a reload from (RCAP2H, RCAP2L) to (TH2,TL2).
Therefore when Timer 2 is in use as a baud rate generator, T2EX
can be used as an additional external interrupt, if needed.
相关PDF资料
PDF描述
P89C58X2BBD 80C51 8-bit Flash microcontroller family
P89C58X2BN 80C51 8-bit Flash microcontroller family
P89C58X2FA 80C51 8-bit Flash microcontroller family
P89C54UBAA 80C51 8-bit microcontroller family 4K/8K/16K/32K Flash
P89C58UBAA 80C51 8-bit microcontroller family 4K/8K/16K/32K Flash
相关代理商/技术参数
参数描述
P89C58X2BA/00,512 功能描述:8位微控制器 -MCU 32K/256 FL 12/6 CLK COMM PLCC RoHS:否 制造商:Silicon Labs 核心:8051 处理器系列:C8051F39x 数据总线宽度:8 bit 最大时钟频率:50 MHz 程序存储器大小:16 KB 数据 RAM 大小:1 KB 片上 ADC:Yes 工作电源电压:1.8 V to 3.6 V 工作温度范围:- 40 C to + 105 C 封装 / 箱体:QFN-20 安装风格:SMD/SMT
P89C58X2BBD 制造商:PHILIPS 制造商全称:NXP Semiconductors 功能描述:80C51 8-bit Flash microcontroller family
P89C58X2BN 制造商:PHILIPS 制造商全称:NXP Semiconductors 功能描述:80C51 8-bit Flash microcontroller family
P89C58X2BN/00,112 制造商:NXP Semiconductors 功能描述:
P89C58X2FA 制造商:PHILIPS 制造商全称:NXP Semiconductors 功能描述:80C51 8-bit Flash microcontroller family