参数资料
型号: P89LPC9221FDH,518
厂商: NXP Semiconductors
文件页数: 7/46页
文件大小: 0K
描述: IC 80C51 MCU 8KB FLASH 20TSSOP
标准包装: 2,500
系列: LPC900
核心处理器: 8051
芯体尺寸: 8-位
速度: 18MHz
连通性: I²C,UART/USART
外围设备: 欠压检测/复位,LED,POR,PWM,WDT
输入/输出数: 18
程序存储器容量: 8KB(8K x 8)
程序存储器类型: 闪存
RAM 容量: 256 x 8
电压 - 电源 (Vcc/Vdd): 2.4 V ~ 3.6 V
振荡器型: 内部
工作温度: -40°C ~ 85°C
封装/外壳: 20-TSSOP(0.173",4.40mm 宽)
包装: 带卷 (TR)
Philips Semiconductors
P89LPC920/921/922/9221
8-bit microcontrollers with two-clock 80C51 core
Product data
Rev. 08 — 15 December 2004
15 of 46
9397 750 14469
Koninklijke Philips Electronics N.V. 2004. All rights reserved.
the minimum specied operating voltage. When using an oscillator frequency
above 12 MHz, in some applications, an external brownout detect circuit may
be required to hold the device in reset when VDD falls below the minimum
specied operating voltage.
8.2.6
Clock output
The P89LPC920/921/922/9221 supports a user-selectable clock output function on
the XTAL2/CLKOUT pin when crystal oscillator is not being used. This condition
occurs if another clock source has been selected (on-chip RC oscillator, watchdog
oscillator, external clock input on X1) and if the Real-Time clock is not using the
crystal oscillator as its clock source. This allows external devices to synchronize to
the P89LPC920/921/922/9221. This output is enabled by the ENCLK bit in the TRIM
register. The frequency of this clock output is 1
2 that of the CCLK. If the clock output
is not needed in Idle mode, it may be turned off prior to entering Idle, saving
additional power.
8.3 On-chip RC oscillator option
The P89LPC920/921/922/9221 has a 6-bit TRIM register that can be used to tune the
frequency of the RC oscillator. During reset, the TRIM value is initialized to a factory
pre-programmed value to adjust the oscillator frequency to 7.373 MHz,
±1% at room
temperature. End-user applications can write to the Trim register to adjust the on-chip
RC oscillator to other frequencies.
8.4 Watchdog oscillator option
The watchdog has a separate oscillator which has a frequency of 400 kHz. This
oscillator can be used to save power when a high clock frequency is not needed.
8.5 External clock input option
In this conguration, the processor clock is derived from an external source driving
the XTAL1/P3.1 pin. The rate may be from 0 Hz up to 12 MHz. The XTAL2/P3.0 pin
may be used as a standard port pin or a clock output. When using an oscillator
frequency above 12 MHz, the reset input function of P1.5 must be enabled. An
external circuit is required to hold the device in reset at power-up until VDD has
reached its specied level. When system power is removed VDD will fall below
the minimum specied operating voltage. When using an oscillator frequency
above 12 MHz, in some applications, an external brownout detect circuit may
be required to hold the device in reset when VDD falls below the minimum
specied operating voltage.
相关PDF资料
PDF描述
VE-BWX-IW CONVERTER MOD DC/DC 5.2V 100W
VE-BWW-IW CONVERTER MOD DC/DC 5.5V 100W
FSUSB31L8X_F113 IC USB SWITCH DPST 8MICROPAK
VE-BW0-IW CONVERTER MOD DC/DC 5V 100W
PI3A4626TEX IC SWITCH SPST SOT23-5
相关代理商/技术参数
参数描述
P89LPC9221FN 功能描述:8位微控制器 -MCU 80C51 8K FL 256B RAM RoHS:否 制造商:Silicon Labs 核心:8051 处理器系列:C8051F39x 数据总线宽度:8 bit 最大时钟频率:50 MHz 程序存储器大小:16 KB 数据 RAM 大小:1 KB 片上 ADC:Yes 工作电源电压:1.8 V to 3.6 V 工作温度范围:- 40 C to + 105 C 封装 / 箱体:QFN-20 安装风格:SMD/SMT
P89LPC9221FN,112 功能描述:8位微控制器 -MCU 8K FL/256B RAM/I2C/UART/DIP20 RoHS:否 制造商:Silicon Labs 核心:8051 处理器系列:C8051F39x 数据总线宽度:8 bit 最大时钟频率:50 MHz 程序存储器大小:16 KB 数据 RAM 大小:1 KB 片上 ADC:Yes 工作电源电压:1.8 V to 3.6 V 工作温度范围:- 40 C to + 105 C 封装 / 箱体:QFN-20 安装风格:SMD/SMT
P89LPC9222A1 制造商:PHILIPS 制造商全称:NXP Semiconductors 功能描述:8-bit microcontroller with accelerated two-clock 80C51 core 2 kB/4 kB/8 kB 3 V byte-erasable flash with 8-bit ADC
P89LPC922A1 制造商:PHILIPS 制造商全称:NXP Semiconductors 功能描述:8-bit microcontroller with accelerated two-clock 80C51 core 2 kB/4 kB/8 kB 3 V byte-erasable flash with 8-bit ADC
P89LPC922A1FDH 制造商:PHILIPS 制造商全称:NXP Semiconductors 功能描述:8-bit microcontroller with accelerated two-clock 80C51 core 2 kB/4 kB/8 kB 3 V byte-erasable flash with 8-bit ADC