- 您现在的位置：买卖IC网 > PDF目录7285 > PC3SD21YXPEF (Sharp Microelectronics)PHOTOTRIAC COUPLER 600V GW 6-SMD PDF资料下载
参数资料
| 型号： | PC3SD21YXPEF |
| 厂商： | Sharp Microelectronics |
| 文件页数： | 10/17页 |
| 文件大小： | 0K |
| 描述： | PHOTOTRIAC COUPLER 600V GW 6-SMD |
| 产品目录绘图： | PC3S, PC4S Circuit |
| 标准包装： | 1 |
| 电压 - 隔离： | 5000Vrms |
| 通道数： | 1 |
| 电压 - 断路： | 600V |
| 输出类型： | 交流过零三端双向可控硅开关 |
| 电流 - 保持 (Ih)： | 100µA |
| 电流 - DC 正向(If)： | 50mA |
| 电流 - 输出 / 通道： | 100mA |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 6-SMD |
| 供应商设备封装： | 6-SMD |
| 包装： | 标准包装 |
| 产品目录页面： | 2768 (CN2011-ZH PDF) |
| 其它名称： | 425-2671-6 |
PC3SD21NTZ Series
■ Design Considerations
● Design guide
In order for the Phototriac to turn off, the triggering current (I F ) must be 0.1mA or less.
Please refrain from using these devices in a direct drive configuration. These Phototriac Coupler are
intended to be used as triggering device for main Triacs. Please ensure that the output rating of these
devices will be sufficient for triggering the main output Triac of your choice. Failure to do may result in
malfunctions.
For applications with inductive loads such as motors,please use caution in utilizing a zero crossing type
Phototraiac Coupler as this may cause undesired operations due to the phase difference between voltage
and current of load.
For designs that will experience excessive noise or sudden changes in load voltage, please include an
appropriate snubber circuit as shown in the below circuit. Please keep in mind the Sharp Phototriac Coupler
incorporate superrior dV/dt ratings which can eliminate the need for a snubber circuit.
For over voltage protection, a Varistor may be used.
● Degradation
In general, the emission of the IRED used in Phototriac Couplers will degrade over time.
In the case where long term operation and / or constant extreme temperature fluctuations will be applied to
the devices, please allow for a worst case scenario of 50% degradation over 5years.
Therefore in order to maintain proper operation, a design implementing these Phototriac Couplers should
provide at least twice the minimum required triggering current from initial operation.
● Recommended Foot Print (reference)
SMT Gullwing Lead-form
8.2
2.2
10
Wide SMT Gullwing Lead-form
10.2
2.2
(Unit : mm)
Sheet No.: D2-A07601EN
相关PDF资料 |
PDF描述 |
|---|---|
| 4306R-101-302 | RES ARRAY 3K OHM 5 RES 6-SIP |
| 4306R-101-301LF | RES ARRAY 300 OHM 5 RES 6-SIP |
| 325301-11-0 | TERM BARRIER 11CIRC SGL ROW .325 |
| 917485-2 | CONN TAB 14-16AWG CRIMP 15GOLD |
| OSTYK61411030 | CONN BARRIER STRIP 11CIRC 10MM |
相关代理商/技术参数 |
参数描述 |
|---|---|
| PC3SD21YXPKF | 制造商:Sharp Microelectronics Corporation 功能描述: 制造商:Sharp Microelectronics Corporation 功能描述:OPTO ISOLATOR |
| PC3SD21YXPLF | 功能描述:三极与 SCR 输出光电耦合器 Gull Wing SMT VDE Rev PC3SD21YTZCF RoHS:否 制造商:Vishay Semiconductors 输出设备:PhotoTriac 每芯片的通道数量: 绝缘电压:3750 Vrms 正向电流:10 mA 正向电压:1.2 V 最大触发电流:10 mA 关断状态下输出电压-VDRM:600 V 最大连续输出电流: 零交叉电路: 封装:Reel |
| PC3SD21YXZAF | 功能描述:三极与 SCR 输出光电耦合器 Phototriac Coupler w/ VDE Sleeves RoHS:否 制造商:Vishay Semiconductors 输出设备:PhotoTriac 每芯片的通道数量: 绝缘电压:3750 Vrms 正向电流:10 mA 正向电压:1.2 V 最大触发电流:10 mA 关断状态下输出电压-VDRM:600 V 最大连续输出电流: 零交叉电路: 封装:Reel |
| PC3SD21YXZC | 功能描述:PHOTOCOUPL VDE TRIAC ZC 6-SMD RoHS:否 类别:隔离器 >> 光隔离器 - 三端双向可控硅，SCR输出 系列:- 产品目录绘图:Zero Cross Circuit 标准包装:50 系列:- 电压 - 隔离:5000Vrms 通道数:1 电压 - 断路:600V 输出类型:交流过零三端双向可控硅开关 电流 - 栅极触发电流 (Igt)（最大）:10mA 电流 - 保持 (Ih):100µA 电流 - DC 正向(If):50mA 电流 - 输出 / 通道:100mA 安装类型:通孔 封装/外壳:4-DIP（0.300"，7.62mm） 供应商设备封装:4-DIP 包装:管件 产品目录页面:2767 (CN2011-ZH PDF) 其它名称:425-1283-5 |
| PC3SD21YXZCF | 功能描述:三极与 SCR 输出光电耦合器 PC3SD21NXZCF with VDE RoHS:否 制造商:Vishay Semiconductors 输出设备:PhotoTriac 每芯片的通道数量: 绝缘电压:3750 Vrms 正向电流:10 mA 正向电压:1.2 V 最大触发电流:10 mA 关断状态下输出电压-VDRM:600 V 最大连续输出电流: 零交叉电路: 封装:Reel |
发布紧急采购，3分钟左右您将得到回复。