参数资料
型号: PC3SG11YIZ0F
厂商: Sharp Microelectronics
文件页数: 8/13页
文件大小: 0K
描述: PHOTOCOUPLER TRIAC OUT 4-SMD
产品目录绘图: PC3SG, PC4SD Circuit
标准包装: 50
电压 - 隔离: 3750Vrms
通道数: 1
电压 - 断路: 600V
输出类型: 交流标准三端双向可控硅开关
电流 - 栅极触发电流 (Igt)(最大): 10mA
电流 - 保持 (Ih): 100µA
电流 - DC 正向(If): 50mA
电流 - 输出 / 通道: 50mA
安装类型: 表面贴装
封装/外壳: 4-SMD
供应商设备封装: 4-SMD
包装: 管件
其它名称: 425-2137-5
PC3SG11YIZ Series
■ Design Considerations
● Design guide
In order for the Phototriac to turn off, the triggering current (I F ) must be 0.1mA or less.
Please refrain from using these devices in a direct drive configuration.
These Phototriac Coupler are intended to be used as triggering device for main Triacs.
Please ensure that the output rating of these devices will be sufficient for triggering the main output Triac of
your choice. Failure to do may result in malfunctions.
In phase control applications or where the Phototriac Coupler is being by a pulse signal, please ensure that
the pulse width is a minimum of 1ms.
For designs that will experience excessive noise or sudden changes in load voltage, please include an
appropriate snubber circuit as shown in the below circuit.
Please keep in mind that Sharp Phototriac Couplers incorporate superor dV/dt ratings which can often
eliminate the need for a snubber circuit.
● Degradation
In general, the emission of the IRED used in Phototriac Couplers will degrade over time.
In the case where long term operation and / or constant extreme temperature fluctuations will be applied to
the devices, please allow for a worst case scenario of 50% degradation over 5years.
Therefore in order to maintain proper operation, a design implementing these Phototriac Couplers should
provide at least twice the minimum required triggering current from initial operation.
● Recommended Foot Print (reference)
6.3
1.5
8
(Unit : mm)
Sheet No.: D2-A06801EN
相关PDF资料
PDF描述
PC3SG21YIZ0F PHOTOCOUPLER TRIAC OUT ZC 4-SMD
PC3ST21NSZCF PHOTOCOUPLER TRIAC OUT ZC 4-DIP
PC400J00000F PHOTOCOUPLER OPIC 5-SOP
PC401TJ0000F PHOTOCOUPLER OPIC 5-SOP
PC410L0YIP0F PHOTOCOUPLER OPIC VDE 5-SOP
相关代理商/技术参数
参数描述
PC3SG21YIZ 功能描述:PHOTOCOUPLER TRIAC OUT ZC 4-SMD RoHS:否 类别:隔离器 >> 光隔离器 - 三端双向可控硅,SCR输出 系列:- 产品目录绘图:Zero Cross Circuit 标准包装:50 系列:- 电压 - 隔离:5000Vrms 通道数:1 电压 - 断路:600V 输出类型:交流过零三端双向可控硅开关 电流 - 栅极触发电流 (Igt)(最大):10mA 电流 - 保持 (Ih):100µA 电流 - DC 正向(If):50mA 电流 - 输出 / 通道:100mA 安装类型:通孔 封装/外壳:4-DIP(0.300",7.62mm) 供应商设备封装:4-DIP 包装:管件 产品目录页面:2767 (CN2011-ZH PDF) 其它名称:425-1283-5
PC3SG21YIZ0F 功能描述:三极与 SCR 输出光电耦合器 Phototriac ZC RoHS:否 制造商:Vishay Semiconductors 输出设备:PhotoTriac 每芯片的通道数量: 绝缘电压:3750 Vrms 正向电流:10 mA 正向电压:1.2 V 最大触发电流:10 mA 关断状态下输出电压-VDRM:600 V 最大连续输出电流: 零交叉电路: 封装:Reel
PC3SH11YFZ 制造商:SHARP 制造商全称:Sharp Electrionic Components 功能描述:VDRM : 600V, Reinforced insulation type Non-zero cross type DIP 4 pin Phototriac Coupler for triggering
PC3SH11YFZA 制造商:未知厂家 制造商全称:未知厂家 功能描述:PHOTOTRIAC COUPLER
PC3SH11YFZAF 功能描述:三极与 SCR 输出光电耦合器 Wide PTC Non ZC 600V 10mA RoHS:否 制造商:Vishay Semiconductors 输出设备:PhotoTriac 每芯片的通道数量: 绝缘电压:3750 Vrms 正向电流:10 mA 正向电压:1.2 V 最大触发电流:10 mA 关断状态下输出电压-VDRM:600 V 最大连续输出电流: 零交叉电路: 封装:Reel