参数资料
| 型号： | PC457L0NIT0F |
| 厂商： | Sharp Microelectronics |
| 文件页数： | 8/12页 |
| 文件大小： | 0K |
| 描述： | PHOTOCOUPLER OPIC 5-SOP |
| 标准包装： | 750 |
| 系列： | OPIC™ |
| 通道数： | 1 |
| 输入类型： | DC |
| 电压 - 隔离： | 3750Vrms |
| 电流传输比（最小值）： | 15% @ 16mA |
| 电流传输比（最大）： | 50% @ 16mA |
| 输出电压： | 20V |
| 电流 - 输出 / 通道： | 8mA |
| 电流 - DC 正向(If)： | 25mA |
| 输出类型： | 有 Vcc 的晶体管 |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 6-SOIC（0.173"，4.40mm 宽，5 引线） |
| 包装： | 带卷 (TR) |
PC457L0NIP0F Series
■ Design Considerations
● Recommended operating conditions
Parameter
Input current
Supply voltage
Fan out (TTL load)
Operating temperature
Symbol
I F
V CC
N
T opr
MIN.
7
?
?
0
TYP.
?
5
?
?
MAX.
16
?
5
+ 70
Unit
mA
V
?
?C
● Notes about static electricity
Transistor of detector side in bipolar configuration may be damaged by static electricity due to its minute de-
sign.
When handling these devices, general countermeasure against static electricity should be taken to avoid
breakdown of devices or degradation of characteristics.
● Design guide
In order to stabilize power supply line, we should certainly recommend to connect a by-pass capacitor of
0.01 μ F or more between V CC and GND near the device.
In case that some sudden big noise caused by voltage variation is provided between primary and secondary
terminals of photocoupler some current caused by it is floating capacitance may be generated and result in
false operation since current may go through LED or current may change.
If the photocoupler may be used under the circumstances where noise will be generated we recommend to
use the bypass capacitors at the both ends of LED.
The detector which is used in this device, has parasitic diode between each pins and GND.
There are cases that miss operation or destruction possibly may be occurred if electric potential of any pin
becomes below GND level even for instant.
Therefore it shall be recommended to design the circuit that electric potential of any pin does not become
below GND level.
This product is not designed against irradiation and incorporates non-coherent LED.
● Degradation
In general, the emission of the LED used in photocouplers will degrade over time.
In the case of long term operation, please take the general LED degradation (50% degradation over 5 years)
into the design consideration.
● Recommended Foot Print (reference)
6.3
1.5
(Unit : mm)
? For additional design assistance, please review our corresponding Optoelectronic Application Notes.
Sheet No.: D2-A05102EN
8
相关PDF资料 |
PDF描述 |
|---|---|
| 2-87456-3 | CONN HOUSING 28POS .100 DUAL ROW |
| 4308R-102-683LF | RES ARRAY 68K OHM 4 RES 8-SIP |
| 4308R-102-473LF | RES ARRAY 47K OHM 4 RES 8-SIP |
| 1-104257-8 | 19 MTE RCPT HSG SR LATCH .100 |
| AXE170224 | CONN SOCKET 70POS 1.0/1.5MM H |
相关代理商/技术参数 |
参数描述 |
|---|---|
| PC457L0YIP | 功能描述:PHOTOCOUPLER OPIC 6-SMD VDE RoHS:否 类别:隔离器 >> 光隔离器 - 逻辑输出 系列:- 标准包装:1,000 系列:- 电压 - 隔离:7500Vrms 通道数:1，单向 电流 - 输出 / 通道:50mA 数据速率:5MHz 传输延迟高 - 低 @ 如果:100ns 电流 - DC 正向(If):5mA 输入类型:DC 输出类型:开路集电极 安装类型:表面贴装 封装/外壳:6-SMD 供应商设备封装:6-SMD 包装:管件 |
| PC457L0YIP0F | 功能描述:高速光耦合器 PC457L0NiP0F w/ VDE RoHS:否 制造商:Avago Technologies 电流传递比: 最大波特率: 最大正向二极管电压:1.75 V 最大反向二极管电压:5 V 最大功率耗散:40 mW 最大工作温度:+125 C 最小工作温度:- 40 C 封装 / 箱体:SOIC-5 封装:Tube |
| PC457L0YIT0F | 功能描述:高速光耦合器 PC457L0NiT0F w/ VDE RoHS:否 制造商:Avago Technologies 电流传递比: 最大波特率: 最大正向二极管电压:1.75 V 最大反向二极管电压:5 V 最大功率耗散:40 mW 最大工作温度:+125 C 最小工作温度:- 40 C 封装 / 箱体:SOIC-5 封装:Tube |
| PC457LRNIP0F | 制造商:Sharp Microelectronics Corporation 功能描述: |
| PC457LTYIP0F | 功能描述:高速光耦合器 Reverse TCP mounting PC457L0YiP0F RoHS:否 制造商:Avago Technologies 电流传递比: 最大波特率: 最大正向二极管电压:1.75 V 最大反向二极管电压:5 V 最大功率耗散:40 mW 最大工作温度:+125 C 最小工作温度:- 40 C 封装 / 箱体:SOIC-5 封装:Tube |
发布紧急采购，3分钟左右您将得到回复。