参数资料
| 型号： | PCA2002TK/1,118 |
| 厂商： | NXP Semiconductors |
| 文件页数： | 27/30页 |
| 文件大小： | 0K |
| 描述： | IC WATCH CIRCUIT 10HVSON |
| 标准包装： | 6,000 |
| 类型： | 时钟/频率发生器 |
| PLL： | 无 |
| 主要目的： | 电池式腕表 |
| 输入： | 晶体 |
| 电路数： | 1 |
| 比率 - 输入:输出： | 1:2 |
| 差分 - 输入:输出： | 无/无 |
| 频率 - 最大： | 32kHz |
| 电源电压： | 1.1 V ~ 3.6 V |
| 工作温度： | -10°C ~ 60°C |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 10-VFDFN 裸露焊盘 |
| 供应商设备封装： | 10-HVSON（3x3） |
| 包装： | 管件 |
| 其它名称： | 935275138118 PCA2002TK-T PCA2002TK-T-ND |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页当前第27页第28页第29页第30页
PCA2002
All information provided in this document is subject to legal disclaimers.
NXP B.V. 2011. All rights reserved.
Product data sheet
Rev. 8 — 25 November 2011
6 of 30
NXP Semiconductors
PCA2002
32 kHz watch circuit with programmable output period and pulse width
After measuring the effective oscillator frequency, the number of correction pulses must
be calculated and stored together with the calibration period in the OTP memory (see
The oscillator frequency can be measured at pad RESET, where a square wave signal
with the frequency of
is provided.
This frequency shows a jitter every minute or every two minutes, depending on the
programmed calibration period, which originates from the time calibration.
Details on how to measure the oscillator frequency and the programmed inhibition time
are given in Section 8.10.
8.3 Reset
At pin RESET an output signal with a frequency of
is provided.
Connecting pin RESET to VDD stops the motor drive and opens the motor switches.
After releasing pin RESET, the first motor pulse is generated exactly one period later with
the opposite polarity to the last pulse before stopping. The debounce time for the reset
function is between 31 ms and 62 ms.
Connecting pin RESET to VSS activates the test mode. In this mode the motor output
frequency is 32 Hz, which can be used to test the mechanical function of the watch.
8.4 Programming possibilities
The programming data is organized in an array of 8-bit words (see Table 5): Word A
contains the time calibration, word B the setting for the monitor pulses, word C is not used
and word D contains the type recognition.
Table 4.
Time calibration
Calibration
period
Correction per step (n = 1)
Correction per step (n = 127)
ppm
seconds per day ppm
seconds per day
1 minute
2.03
0.176
258
22.3
2 minutes
1.017
0.088
129
11.15
1
1024
------------
f
osc
1
1024
------------
f
osc
32Hz
=
Table 5.
Words and bits
Word
Bit
1
2
3
4
5
6
7
8
A
number of 8192 Hz pulses to be removed
calibration
period
B
pulse width
output period
duty
cycle
pulse
stretching
C
D
type
factory test bit
相关PDF资料 |
PDF描述 |
|---|---|
| PCKV857EV,118 | IC 1:10 2.5V PLL CLK-DRVR48TSSOP |
| PCM1602APTG4 | IC DAC 24BIT 6CH 192KHZ 48-LQFP |
| PCM1792DB | IC 24BIT AUDIO STEREO DAC 28SSOP |
| PCM3168ATPAPQ1 | IC 24-BIT AUDIO CODEC 64-HTQFP |
| PCM3168ATPAPRQ1G4 | IC 24-BIT AUDIO CODEC 64-HTQFP |
相关代理商/技术参数 |
参数描述 |
|---|---|
| PCA2002TK-T | 功能描述:马达/运动/点火控制器和驱动器 WATCH IC RoHS:否 制造商:STMicroelectronics 产品:Stepper Motor Controllers / Drivers 类型:2 Phase Stepper Motor Driver 工作电源电压:8 V to 45 V 电源电流:0.5 mA 工作温度:- 25 C to + 125 C 安装风格:SMD/SMT 封装 / 箱体:HTSSOP-28 封装:Tube |
| PCA2002U/10AA | 制造商:PHILIPS 制造商全称:NXP Semiconductors 功能描述:32 kHz watch circuit with programmable output period and pulse width |
| PCA2002U/10AB/1 | 制造商:PHILIPS 制造商全称:NXP Semiconductors 功能描述:32 kHz watch circuit with programmable output period and pulse width |
| PCA2002U/10AB/1,00 | 功能描述:马达/运动/点火控制器和驱动器 32KHZ WATCH CIRCUIT RoHS:否 制造商:STMicroelectronics 产品:Stepper Motor Controllers / Drivers 类型:2 Phase Stepper Motor Driver 工作电源电压:8 V to 45 V 电源电流:0.5 mA 工作温度:- 25 C to + 125 C 安装风格:SMD/SMT 封装 / 箱体:HTSSOP-28 封装:Tube |
| PCA2002U/10AB/1,005 | 制造商:NXP Semiconductors 功能描述: |
发布紧急采购，3分钟左右您将得到回复。