- 您现在的位置：买卖IC网 > PDF目录224693 > PCA9531BS (NXP Semiconductors N.V.) 8-bit I2C-bus LED dimmer PDF资料下载
参数资料
| 型号： | PCA9531BS |
| 厂商： | NXP Semiconductors N.V. |
| 元件分类： | LED驱动器 |
| 英文描述： | 8-bit I2C-bus LED dimmer |
| 封装： | PCA9531BS<SOT629-1 (HVQFN16)|<<http://www.nxp.com/packages/SOT629-1.html<1<Always Pb-free,;PCA9531D<SOT109-1 (SO16)|<<http://www.nxp.com/packages/SOT109-1.html<1<we |
| 文件页数： | 1/27页 |
| 文件大小： | 156K |
| 代理商： | PCA9531BS |
当前第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页
1.
General description
The PCA9531 is an 8-bit I2C-bus and SMBus I/O expander optimized for dimming LEDs in
256 discrete steps for Red/Green/Blue (RGB) color mixing and back light applications.
The PCA9531 contains an internal oscillator with two user programmable blink rates and
duty cycles coupled to the output PWM. The LED brightness is controlled by setting the
blink rate high enough (> 100 Hz) that the blinking cannot be seen and then using the duty
cycle to vary the amount of time the LED is on and thus the average current through the
LED.
The initial setup sequence programs the two blink rates/duty cycles for each individual
PWM. From then on, only one command from the bus master is required to turn individual
LEDs ON, OFF, BLINK RATE 1 or BLINK RATE 2. Based on the programmed frequency
and duty cycle, BLINK RATE 1 and BLINK RATE 2 will cause the LEDs to appear at a
different brightness or blink at periods up to 1.69 second. The open-drain outputs directly
drive the LEDs with maximum output sink current of 25 mA per bit and 100 mA per
package.
To blink LEDs at periods greater than 1.69 second the bus master (MCU, MPU, DSP,
chip set, etc.) must send repeated commands to turn the LED on and off as is currently
done when using normal I/O expanders like the NXP Semiconductors PCF8574 or
PCA9554. Any bits not used for controlling the LEDs can be used for General Purpose
parallel Input/Output (GPIO) expansion, which provides a simple solution when additional
I/O is needed for ACPI power switches, sensors, push-buttons, alarm monitoring, fans,
etc.
The active LOW hardware reset pin (RESET) and Power-On Reset (POR) initializes the
registers to their default state causing the bits to be set HIGH (LED off).
Three hardware address pins on the PCA9531 allow eight devices to operate on the same
bus.
2.
Features
I Eight LED drivers (on, off, ashing at a programmable rate)
I Two selectable, fully programmable blink rates (frequency and duty cycle) between
0.59 Hz and 152 Hz (1.69 second and 6.58 milliseconds)
I 256 brightness steps
I Input/outputs not used as LED drivers can be used as regular GPIOs
I Internal oscillator requires no external components
I I2C-bus interface logic compatible with SMBus
I Internal power-on reset
PCA9531
8-bit I2C-bus LED dimmer
Rev. 06 — 19 February 2009
Product data sheet
相关PDF资料 |
PDF描述 |
|---|---|
| PCA9531D | 8-bit I2C-bus LED dimmer |
| PCA9531PW | 8-bit I2C-bus LED dimmer |
| PCA9532BS | 16-bit I2C-bus LED dimmer |
| PCA9532D | 16-bit I2C-bus LED dimmer |
| PCA9532PW | 16-bit I2C-bus LED dimmer |
相关代理商/技术参数 |
参数描述 |
|---|---|
| PCA9531BS,118 | 功能描述:LED照明驱动器 8-BIT I2C FM OD LED RoHS:否 制造商:STMicroelectronics 输入电压:11.5 V to 23 V 工作频率: 最大电源电流:1.7 mA 输出电流: 最大工作温度: 安装风格:SMD/SMT 封装 / 箱体:SO-16N |
| PCA9531BS-T | 功能描述:LED照明驱动器 8-BIT I2C FM OD LED DIM RST RoHS:否 制造商:STMicroelectronics 输入电压:11.5 V to 23 V 工作频率: 最大电源电流:1.7 mA 输出电流: 最大工作温度: 安装风格:SMD/SMT 封装 / 箱体:SO-16N |
| PCA9531D | 功能描述:LED照明驱动器 8-BIT I2C FM OD LED DIM RST RoHS:否 制造商:STMicroelectronics 输入电压:11.5 V to 23 V 工作频率: 最大电源电流:1.7 mA 输出电流: 最大工作温度: 安装风格:SMD/SMT 封装 / 箱体:SO-16N |
| PCA9531D,112 | 功能描述:LED照明驱动器 8-BIT I2C FM OD LED RoHS:否 制造商:STMicroelectronics 输入电压:11.5 V to 23 V 工作频率: 最大电源电流:1.7 mA 输出电流: 最大工作温度: 安装风格:SMD/SMT 封装 / 箱体:SO-16N |
| PCA9531D,118 | 功能描述:LED照明驱动器 8-BIT I2C FM OD LED DIM RST RoHS:否 制造商:STMicroelectronics 输入电压:11.5 V to 23 V 工作频率: 最大电源电流:1.7 mA 输出电流: 最大工作温度: 安装风格:SMD/SMT 封装 / 箱体:SO-16N |
发布紧急采购，3分钟左右您将得到回复。