- 您现在的位置：买卖IC网 > PDF目录22023 > PCA9531D,118 (NXP Semiconductors)IC LED DRIVER RGB 16-SOIC PDF资料下载
参数资料
| 型号： | PCA9531D,118 |
| 厂商： | NXP Semiconductors |
| 文件页数： | 8/27页 |
| 文件大小： | 0K |
| 描述： | IC LED DRIVER RGB 16-SOIC |
| 标准包装： | 2,500 |
| 拓扑： | 开路漏极，PWM |
| 输出数： | 8 |
| 内部驱动器： | 是 |
| 类型 - 主要： | 背光，LED 闪烁器 |
| 类型 - 次要： | RGB |
| 频率： | 400kHz |
| 电源电压： | 2.3 V ~ 5.5 V |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 16-SOIC（0.154"，3.90mm 宽） |
| 供应商设备封装： | 16-SO |
| 包装： | 带卷 (TR) |
| 工作温度： | -40°C ~ 85°C |
| 配用： | 568-4003-ND - DEMO BOARD LED DIMMER 568-3615-ND - DEMO BOARD I2C |
| 其它名称： | 935274731118 PCA9531D-T PCA9531D-T-ND |
第1页第2页第3页第4页第5页第6页第7页当前第8页第9页第10页第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页
NXP Semiconductors
PCA9531
8-bit I 2 C-bus LED dimmer
6.3.6 LS0 to LS1 - LED selector registers
The LSn LED select registers determine the source of the LED data.
00 = output is set high-impedance (LED off; default)
01 = output is set LOW (LED on)
10 = output blinks at PWM0 rate
11 = output blinks at PWM1 rate
Table 9. LS0 to LS1 - LED selector registers bit description
Legend: * default value.
Register
Bit
Value
Description
LS0 - LED0 to LED3 selector
LS0
7:6
5:4
3:2
1:0
00*
00*
00*
00*
LED3 selected
LED2 selected
LED1 selected
LED0 selected
LS1 - LED4 to LED7 selector
LS1
7:6
5:4
3:2
1:0
00*
00*
00*
00*
LED7 selected
LED6 selected
LED5 selected
LED4 selected
6.4 Pins used as GPIOs
LED pins not used to control LEDs can be used as General Purpose I/Os (GPIOs).
For use as input, set LEDn to high-impedance (00) and then read the pin state via the
Input register.
For use as output, connect external pull-up resistor to the pin and size it according to the
DC recommended operating characteristics. LEDn output pin is HIGH when the output is
programmed as high-impedance, and LOW when the output is programmed LOW through
the ‘LED selector’ register. The output can be pulse-width controlled when PWM0 or
PWM1 are used.
6.5 Power-on reset
When power is applied to V DD , an internal Power-On Reset (POR) holds the PCA9531 in
a reset condition until V DD has reached V POR . At that point, the reset condition is released
and the PCA9531 registers are initialized to their default states, all the outputs in the
OFF state. Thereafter, V DD must be lowered below 0.2 V to reset the device.
6.6 External RESET
A reset can be accomplished by holding the RESET pin LOW for a minimum of t w(rst) . The
PCA9531 registers and I 2 C-bus state machine will be held in their default states until the
RESET input is once again HIGH.
This input requires a pull-up resistor to V DD if no active connection is used.
PCA9531_6
? NXP B.V. 2009. All rights reserved.
Product data sheet
Rev. 06 — 19 February 2009
8 of 27
相关PDF资料 |
PDF描述 |
|---|---|
| TAJW226K010H | CAP TANT 22UF 10V 10% 2312 |
| EBC13DCSH | CONN EDGECARD 26POS DIP .100 SLD |
| PCA9626B,118 | IC LED DRIVER RGBA 48-LQFP |
| ADT7468ARQZ | IC REMOTE THERMAL CTRLR 24QSOP |
| TAJD476K025SNJ | CAP TANT 47UF 25V 10% 2917 |
相关代理商/技术参数 |
参数描述 |
|---|---|
| PCA9531PW | 功能描述:LED照明驱动器 8-BIT I2C FM OD LED DIM RST RoHS:否 制造商:STMicroelectronics 输入电压:11.5 V to 23 V 工作频率: 最大电源电流:1.7 mA 输出电流: 最大工作温度: 安装风格:SMD/SMT 封装 / 箱体:SO-16N |
| PCA9531PW,112 | 功能描述:LED照明驱动器 8-BIT I2C FM OD LED RoHS:否 制造商:STMicroelectronics 输入电压:11.5 V to 23 V 工作频率: 最大电源电流:1.7 mA 输出电流: 最大工作温度: 安装风格:SMD/SMT 封装 / 箱体:SO-16N |
| PCA9531PW,118 | 功能描述:LED照明驱动器 8-BIT I2C FM OD LED DIM RST RoHS:否 制造商:STMicroelectronics 输入电压:11.5 V to 23 V 工作频率: 最大电源电流:1.7 mA 输出电流: 最大工作温度: 安装风格:SMD/SMT 封装 / 箱体:SO-16N |
| PCA9532 | 制造商:NXP Semiconductors 功能描述:IC ((NW)) |
| PCA9532BS | 制造商:PHILIPS 制造商全称:NXP Semiconductors 功能描述:16-bit I2C-bus LED dimmer |
发布紧急采购，3分钟左右您将得到回复。