参数资料
型号: PCA9552BS,118
厂商: NXP Semiconductors
文件页数: 1/28页
文件大小: 0K
描述: IC LED DRIVER BLINKER 24-HVQFN
产品培训模块: LED Controllers
I²C Bus Fundamentals
标准包装: 1
拓扑: 开路漏极,PWM
输出数: 16
内部驱动器:
类型 - 主要: LED 闪烁器
频率: 400kHz
电源电压: 2.3 V ~ 5.5 V
安装类型: 表面贴装
封装/外壳: 24-VFQFN 裸露焊盘
供应商设备封装: 24-HVQFN(4x4)
包装: 标准包装
工作温度: -40°C ~ 85°C
产品目录页面: 844 (CN2011-ZH PDF)
其它名称: 568-3389-6
PCA9552
16-bit I 2 C-bus LED driver with programmable blink rates
Rev. 05 — 9 March 2006
Product data sheet
1. General description
The PCA9552 LED blinker blinks LEDs in I 2 C-bus and SMBus applications where it is
necessary to limit bus traf?c or free up the I 2 C-bus master's (MCU, MPU, DSP, chip set,
etc.) timer. The uniqueness of this device is the internal oscillator with two programmable
blink rates. To blink LEDs using normal I/O expanders like the PCF8574 or PCA9554, the
bus master must send repeated commands to turn the LED on and off. This greatly
increases the amount of traf?c on the I 2 C-bus and uses up one of the master's timers. The
PCA9552 LED blinker instead requires only the initial setup command to program
BLINK RATE 1 and BLINK RATE 2 (that is, the frequency and duty cycle) for each
individual output. From then on, only one command from the bus master is required to
turn each individual open-drain output on, off, or to cycle at BLINK RATE 1 or
BLINK RATE 2. Maximum output sink current is 25 mA per bit and 200 mA per package.
Any bits not used for controlling the LEDs can be used for General Purpose Parallel
Input/Output (GPIO) expansion.
The active LOW hardware reset pin (RESET) and Power-On Reset (POR) initializes the
registers to their default state, all zeroes, causing the bits to be set HIGH (LED off).
Three hardware address pins on the PCA9552 allow eight devices to operate on the same
bus.
2. Features
s 16 LED drivers (on, off, ?ashing at a programmable rate)
s 2 selectable, fully programmable blink rates (frequency and duty cycle) between
0.172 Hz and 44 Hz (5.82 seconds and 0.023 seconds)
s Input/outputs not used as LED drivers can be used as regular GPIOs
s Internal oscillator requires no external components
s I 2 C-bus interface logic compatible with SMBus
s Internal power-on reset
s Noise ?lter on SCL/SDA inputs
s Active LOW reset input
s 16 open-drain outputs directly drive LEDs to 25 mA
s Edge rate control on outputs
s No glitch on power-up
s Supports hot insertion
s Low standby current
s Operating power supply voltage range of 2.3 V to 5.5 V
s 0 Hz to 400 kHz clock frequency
相关PDF资料
PDF描述
VJ1206A100KBLAT4X CAP CER 10PF 630V 10% NP0 1206
RW-1215D CONV DC/DC 3W 9-18VIN +/-15VOUT
CS8126-1YTHER5 IC REG LDO 5V .5A TO220-5
AIML-0805-R27K-T INDUCTOR MULTILAYER 0.27UH 0805
HMC36DRTH-S93 CONN EDGECARD 72POS DIP .100 SLD
相关代理商/技术参数
参数描述
PCA9552D 功能描述:LED照明驱动器 I2C LED BLINKR 16BIT RoHS:否 制造商:STMicroelectronics 输入电压:11.5 V to 23 V 工作频率: 最大电源电流:1.7 mA 输出电流: 最大工作温度: 安装风格:SMD/SMT 封装 / 箱体:SO-16N
PCA9552D,112 功能描述:LED照明驱动器 I2C LED BLINKR 16BIT RoHS:否 制造商:STMicroelectronics 输入电压:11.5 V to 23 V 工作频率: 最大电源电流:1.7 mA 输出电流: 最大工作温度: 安装风格:SMD/SMT 封装 / 箱体:SO-16N
PCA9552D,118 功能描述:LED照明驱动器 16-BIT I2C FM OD LED BLK RST RoHS:否 制造商:STMicroelectronics 输入电压:11.5 V to 23 V 工作频率: 最大电源电流:1.7 mA 输出电流: 最大工作温度: 安装风格:SMD/SMT 封装 / 箱体:SO-16N
PCA9552PW 功能描述:LED照明驱动器 I2C LED BLNKER 16BIT RoHS:否 制造商:STMicroelectronics 输入电压:11.5 V to 23 V 工作频率: 最大电源电流:1.7 mA 输出电流: 最大工作温度: 安装风格:SMD/SMT 封装 / 箱体:SO-16N
PCA9552PW,112 功能描述:LED照明驱动器 I2C LED BLNKER 16BIT RoHS:否 制造商:STMicroelectronics 输入电压:11.5 V to 23 V 工作频率: 最大电源电流:1.7 mA 输出电流: 最大工作温度: 安装风格:SMD/SMT 封装 / 箱体:SO-16N