- 您现在的位置：买卖IC网 > PDF目录1959 > PCA9575PW1,118 (NXP Semiconductors)IC I/O EXPANDER I2C 16B 24TSSOP PDF资料下载
参数资料
| 型号： | PCA9575PW1,118 |
| 厂商： | NXP Semiconductors |
| 文件页数： | 14/38页 |
| 文件大小： | 0K |
| 描述： | IC I/O EXPANDER I2C 16B 24TSSOP |
| 标准包装： | 1 |
| 接口： | I²C，SM 总线 |
| 输入/输出数： | 16 |
| 中断输出： | 是 |
| 频率 - 时钟： | 400kHz |
| 电源电压： | 1.1 V ~ 3.6 V |
| 工作温度： | -40°C ~ 85°C |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 24-TSSOP（0.173"，4.40mm 宽） |
| 供应商设备封装： | 24-TSSOP |
| 包装： | 标准包装 |
| 包括： | POR |
| 其它名称： | 568-9538-6 |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页第12页第13页当前第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页第29页第30页第31页第32页第33页第34页第35页第36页第37页第38页
PCA9575_3
NXP B.V. 2009. All rights reserved.
Product data sheet
Rev. 03 — 9 November 2009
21 of 38
NXP Semiconductors
PCA9575
16-bit I2C-bus and SMBus, level translating, low voltage GPIO
8.3 Acknowledge
The number of data bytes transferred between the START and the STOP conditions from
transmitter to receiver is not limited. Each byte of eight bits is followed by one
acknowledge bit. The acknowledge bit is a HIGH level put on the bus by the transmitter,
whereas the master generates an extra acknowledge related clock pulse.
A slave receiver which is addressed must generate an acknowledge after the reception of
each byte. Also a master must generate an acknowledge after the reception of each byte
that has been clocked out of the slave transmitter. The device that acknowledges has to
pull down the SDA line during the acknowledge clock pulse, so that the SDA line is stable
LOW during the HIGH period of the acknowledge related clock pulse; set-up time and hold
time must be taken into account.
A master receiver must signal an end of data to the transmitter by not generating an
acknowledge on the last byte that has been clocked out of the slave. In this event, the
transmitter must leave the data line HIGH to enable the master to generate a STOP
condition.
Fig 11. System conguration
002aaa966
MASTER
TRANSMITTER/
RECEIVER
SLAVE
RECEIVER
SLAVE
TRANSMITTER/
RECEIVER
MASTER
TRANSMITTER
MASTER
TRANSMITTER/
RECEIVER
SDA
SCL
I2C-BUS
MULTIPLEXER
SLAVE
Fig 12. Acknowledgement on the I2C-bus
002aaa987
S
START
condition
9
8
2
1
clock pulse for
acknowledgement
not acknowledge
acknowledge
data output
by transmitter
data output
by receiver
SCL from master
相关PDF资料 |
PDF描述 |
|---|---|
| PCA9621PW,118 | IC BUS PORT 8BIT 65MA 16TSSOP |
| PCA9655EDWR2G | IC I/O EXPANDER I2C 16B SOIC-24 |
| PCA9670D,512 | IC I/O EXPANDER I2C 8B 16SOIC |
| PCA9671D,112 | IC I/O EXPANDER I2C 16B 24SOIC |
| PCA9672PW,118 | IC I/O EXPANDER I2C 8B 16TSSOP |
相关代理商/技术参数 |
参数描述 |
|---|---|
| PCA9575PW2,118 | 功能描述:I2C 接口集成电路 I2C Bus/ SMBus Level Translating 28-Pin RoHS:否 制造商:NXP Semiconductors 电源电压-最大:5.5 V 电源电压-最小:2.3 V 最大工作频率:400 KHz 最大工作温度:+ 85 C 封装 / 箱体:TSSOP-16 |
| PCA9575PW2118 | 制造商:Rochester Electronics LLC 功能描述: 制造商:NXP 功能描述: 制造商:NXP Semiconductors 功能描述: |
| PCA9600D | 功能描述:缓冲器和线路驱动器 FM+ BUS BUFFER RoHS:否 制造商:Micrel 输入线路数量:1 输出线路数量:2 极性:Non-Inverting 电源电压-最大:+/- 5.5 V 电源电压-最小:+/- 2.37 V 最大工作温度:+ 85 C 安装风格:SMD/SMT 封装 / 箱体:MSOP-8 封装:Reel |
| PCA9600D,112 | 功能描述:缓冲器和线路驱动器 FM+ BUS BUFFER RoHS:否 制造商:Micrel 输入线路数量:1 输出线路数量:2 极性:Non-Inverting 电源电压-最大:+/- 5.5 V 电源电压-最小:+/- 2.37 V 最大工作温度:+ 85 C 安装风格:SMD/SMT 封装 / 箱体:MSOP-8 封装:Reel |
| PCA9600D,118 | 功能描述:缓冲器和线路驱动器 FM+ BUS BUFFER RoHS:否 制造商:Micrel 输入线路数量:1 输出线路数量:2 极性:Non-Inverting 电源电压-最大:+/- 5.5 V 电源电压-最小:+/- 2.37 V 最大工作温度:+ 85 C 安装风格:SMD/SMT 封装 / 箱体:MSOP-8 封装:Reel |
发布紧急采购，3分钟左右您将得到回复。