- 您现在的位置：买卖IC网 > Datasheet目录350 > PCA9955TW,118 (NXP Semiconductors)IC LED DRVR CONST CURR Datasheet资料下载
参数资料
| 型号： | PCA9955TW,118 |
| 厂商： | NXP Semiconductors |
| 文件页数： | 2/6页 |
| 文件大小： | 0K |
| 描述： | IC LED DRVR CONST CURR |
| 标准包装： | 2,500 |
| 恒定电流： | 是 |
| 拓扑： | PWM |
| 输出数： | 16 |
| 内部驱动器： | 是 |
| 类型 - 主要： | 背光，LED 闪烁器 |
| 类型 - 次要： | RGBA |
| 频率： | 8MHz |
| 电源电压： | 3 V ~ 5.5 V |
| 输出电压： | 40V |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 28-SOIC（0.173"，4.40mm 宽）裸露焊盘 |
| 供应商设备封装： | 28-HTSSOP |
| 包装： | 带卷 (TR) |
| 工作温度： | -20°C ~ 85°C |
LEDs are used in a wide range of applications, from low-end status indicators to high-end video displays. System designers often
need the ability to control these LEDs, but can’t afford to tie up the system processor to do so. NXP’s LED controllers solve this
problem, performing a variety of control tasks while offloading the system processor. Having sent instructions to the LED controller,
the processor is free to engage in other tasks or go into a low-power state.
NXP’s LED controllers offer a variety of features needed in LED-driving applications. Some of these features include:
}
}
}
}
}
}
}
}
}
Blinking and dimming capability
Pulse-width modulation (PWM) for LED control
Color mixing capabilities
Fast-mode Plus (Fm+) communication channel with data transfer rate of up to 1 Mbps over the I 2 C-bus.
Different output drive types (push-pull, open-drain voltage switch or constant-current driver)
Independent control of LEDs
LED status and fault reading
Short-circuit protection
Over-temperature protection
The devices are classified in three groups: voltage-switch drivers, constant-current drivers, and Flash LED drivers.
These groups are discussed below.
Voltage-Switch Drivers
Voltage-switch output driver devices control the LED
connected to the output pin by switching the connection
to ground or supply on or off. A series resistor connected
between the LED and the device limits the current that flows
through the LED into the device.
Constant-Current Drivers
A current-regulated LED driver results in the LED light
remaining constant with the supply-voltage fluctuations.
NXP constant-current LED drivers are used for low-current
luminary lighting applications requiring accurate lighting
control independent of supply voltage, temperature, and LED
forward-bias voltage.
Voltage-switch devices have the advantage of dissipating the
heat outside the device, in the series resistor. Therefore the
device is insensitive to heat dissipation and is good for driving
multiple LEDs in series, with different forward-bias voltages
(V f ), from the same supply.
(a) Example Voltage-Switch Output Structure
Flash LED Drivers
NXP Flash LED Drivers are high-efficiency, maximum-output,
small footprint devices with touch capability and an indicator
LED output feature. These devices are highly integrated with
hardware and I 2 C interface modes.
(b) Example Constant-Current Output Structure
The LED controllers are supported by application boards and daughter cards, an established manufacturing infrastructure that
supports high volumes, and several technical documents. NXP helps system designers make lighting affordable, in everything
from indoor consumer electronics and appliances to outdoor decorative lighting.
相关PDF资料 |
PDF描述 |
|---|---|
| PCF85102C-2P/03,11 | IC EEPROM 2KBIT 100KHZ 8DIP |
| PCF85103C-2T/00,11 | IC EEPROM 2KBIT 100KHZ 8SOIC |
| PCF8570T/F5,512 | IC SRAM 2KBIT 100KHZ 8SOIC |
| PCF8582C-2T/03,118 | IC EEPROM 2KBIT 100KHZ 8SOIC |
| PCF8594C-2T/02,118 | IC EEPROM 4KBIT 100KHZ 8SOIC |
相关代理商/技术参数 |
参数描述 |
|---|---|
| PCA9956ATWY | 制造商:NXP Semiconductors 功能描述:PCA9956ATW/HTSSOP38/REEL13DP// - Tape and Reel 制造商:NXP Semiconductors 功能描述:IC LED DVR PWM CTLR 38HTSSOP |
| PCA9956BTWY | 功能描述:LED 驱动器 IC 24 输出 线性 PWM 调光 65mA 38-HTSSOP 制造商:nxp semiconductors 系列:- 包装:剪切带（CT） 零件状态:有效 类型:线性 拓扑:- 内部开关:是 输出数:24 电压 - 供电（最低）:3V 电压 -?供电（最高）:5.5V 电压 - 输出:- 电流 - 输出/通道:65mA 频率:- 调光:PWM 应用:背光 工作温度:-40°C ~ 85°C（TA） 安装类型:表面贴装 封装/外壳:38-TFSOP（0.173"，4.40mm 宽）裸焊盘 供应商器件封装:38-HTSSOP 标准包装:1 |
| PCA-A-043603 | 制造商:TDK Epcos 功能描述: |
| PCAA-10 | 制造商:Aeroflex / KDI 功能描述:ATTENUATOR - PCB MOUNT |
| PCAA2 | 制造商:KDI 功能描述: |
发布紧急采购，3分钟左右您将得到回复。