
PRELIMINARY SPECIFICATION
2
P-0.6
01/05/05
PI3A4627C
3.0V, SOTiny Single-Supply 0.8 SPST (NC) CMOS
Analog Switch with -1.0V to 3.3V Operating Range
Caution: Stresses beyond those listed under “Absolute Maximum Ratings” may cause permanent damage to the device. This is a
stress only rating and operation of the device at these or any other conditions beyond those indicated in the operational sections of
this specification is not implied.
Absolute Maximum Ratings
Voltages Referenced to GND
VCC ......................................................................–0.5V to +3.6V
VIN, VCOM, VNC(1) ......................................–1.5V to VCC +0.3V
or 30mA, whichever occurs first
Current (any terminal).....................................................±200mA
Peak Current, COM, NC
(Pulsed at 1ms, 10% duty cycle).....................................±400mA
Note:
1. Signals on NC, COM, or IN exceeding VCC or GND are clamped by internal diodes. Limit forward diode current to 30mA.
Thermal Information
Continuous Power Dissipation
SOT-23 (derate 7.1mW/C above +70C)........................... 0.5W
Storage Temperature ........................................–65C to +150C
Lead Temperature (soldering, 10s) ................................. +300C
Electrical Specifications - Single +3.3V Supply
(VCC = +3.3V ± 10%, GND = 0V, VIH = 1.4V, VIL = 0.5V)
Description
Parameters
Test Conditions
Temp.(°C) Min.(1) Typ.(2) Max.(1) Units
Analog Switch
Analog Signal Range(3)
VANALOG
Full
-1
VCC
V
On Resistance
RON
VCC = 2.7V, ICOM = 100mA,
VNC = 1.5V
25
1.0
Full
1.0
On-Resistance Flatness(5)
RFLAT(ON)
VCC =2.7V, ICOM = 100mA,
VNC =0.8V, 2.0V
25
0.1
Full
0.1
NC COM Off Leakage
Current(6)
ICOM(OFF) or
INC(OFF)
VCC =3.3V, VCOM = 0V,
VNC = +2.0V
25
–1
1
A
Full
–2
2
COM On Leakage Cur-
rent(6)
ICOM(ON)
VCC =3.3V, VCOM = +2.0V
VNC =+ 2.0V
25
–1
1
Full
–2
2