2
PS8194E 09/13/04
PI5C6800
10-Bit Bus Switch with
Precharged Outputs
Storage Temperature.....................................................–65°C to +150°C
Supply Voltage Range.........................................................–0.5V to +7V
DC Input Voltage
(2)
.............................................................–0.5V to +7V
Input Clamp Current, I
IK
(V
1
<0)..................................................–50mA
DC Output Current........................................................................120mA
Power Dissipation
(3)
........................................................................0.5W
Notes:
1.
Stresses greater than those listed under MAXIMUM RATINGS may cause permanent damage to the device. This is a stress rating only and
functional operation of the device at these or any other conditions above those indicated in the operational sections of this specification is not
implied. Exposure to absolute maximum rating conditions for extended periods may affect reliability.
The input and output negative-voltage ratings may be exceeded if the input and output clamp-current ratings are observed.
The maximum package power dissipation is calculated using a junction temperatue of 150°C and a board trace length of 750 mils.
2.
3.
Absolute Maximum Ratings Over Free-Air Temperature Range
(1)
(Above which the useful life may be impaired. For user guidelines, not tested.)
Recommended Operating Conditions
Parameters
V
CC
Supply Voltage
BIASV
Supply Voltage
V
IH
High-level input voltage
V
IL
Low-level input voltage
T
A
Operating free-air voltage
Description
Min.
4
1.3
2
Typ.
5.5
V
CC
Units
V
0.8
-40
85
°
C
Electrical Characteristics
(Over Recommended Operating Free-air Temperature Range)
Parameters
Test Condidtion
V
IK
V
CC
= 4.5V, I
I
= -18mA
I
I
V
CC
= 5.5V, V
I
= 5.5V or GND
I
O
V
CC
= 4.5V, BIASV = 2.4V, V
O
= 0
I
CC
V
CC
= 5.5V, I
O
= 0, V
I
= V
CC
or GND
I
CC(2)
V
CC
= 3.6V, One input at 2.7V Other at V
CC
or GND
C
IN
V
I
= 3V or 0
C
OFF
V
O
= 3V or 0, Switch Off
V
CC
= 4V
V
I
= 2.4V, I
I
= 15mA
V
I
= 0V, I
I
= 64mA
V
I
= 0V, I
I
= 30mA
V
I
= 2.4V, I
I
= 15mA
Notes:
1. Measured by the voltage drop between the A and B terminals at the indicated current through the switch. On-State resistance is determined by
the lower of the voltages of the two (A or B) terminals.
2. This is the increase in supply current for control input.
3. All typical values are at V
CC
= 5V, T
A
= 25°C.
Min.
Typ.
(3)
Max.
-1.2
±5
Units
V
μA
mA
μA
mA
-0.20
3
2.5
3.5
4.5
14
5
5
10
pF
R
ON(1)
22
7
7
15
V
CC
= 4.5V