2
PS8753A
11/02/04
PI5V512
Low On-Resistance, 5V Wide-Bandwidth
5-port, 2:1 Mux/DeMux VideoSwitch
Storage Temperature ..........................................................–65°C to +150°C
Ambient Temperature with Power Applied .........................–40°C to +85°C
Supply Voltage to Ground Potential (Inputs & VCC Only)...–0.5V to +7.0V
Supply Voltage to Ground Potential (Outputs & D/O Only) –0.5V to +7.0V
DC Input Voltage ..................................................................–0.5V to +7.0V
DC Output Current.............................................................................120mA
Power Dissipation .................................................................................0.5W
Note:
Stresses greater than those listed under MAXIMUM RAT-
INGS may cause permanent damage to the device. This is
a stress rating only and functional operation of the device
at these or any other conditions above those indicated in the
operational sections of this specification is not implied. Ex-
posure to absolute maximum rating conditions for extended
periods may affect reliability.
Maximum Ratings
(Above which the useful life may be impaired. For user guidelines, not tested.)
DC Electrical Characteristics (Over the Operating Range, TA = –40°C to +85°C, VCC = 5V ±5%)
Parameters
Description
Test Conditions(1)
Min.
Typ.(2) Max. Units
VANALOG
Analog Signal Range
0
2.0
V
VIH
Input HIGH Voltage
Guaranteed Logic HIGH Level
2.0
VIL
Input LOW Voltage
Guaranteed Logic LOW Level
–0.5
0.8
IIH
Input HIGH Current
VCC = Max., VIN = VCC
±1
A
IIL
Input LOW Current
VCC = Max., VIN = GND
±1
IO
Analog Output Leakage Current
0 ≤ I0, I1 or D ≤ VCC, Switch OFF
±1
VIK
Clamp Diode Voltage
VCC = Min., IIN = -18mA
-0.7
-1.2
V
VH
Input Hysteresis at Control Pins
150
mV
RON
Switch On-Resistance(3)
VCC = Min., VIN = 1.0V,
ION = 13mA
5
8
VCC = Min., VIN = 2.0V,
ION = 26mA
7
12
Pin Description
Pin Name
Description
IA0, IB0, IC0, ID0, IEQ, IA1, IB1, IC1, ID1, IE1
Analog Video I/O
S
Select Input
EN
Enable
YA, YB, YC, DE, YD, EE
Analog Video I/O
GND
Ground
VCC
Power
Notes:
1.
For Max. or Min. conditions, use appropriate value specified under Electrical Characteristics for the applicable device type.
2.
Typical values are at Vcc = 5.0V, TA = 25°C ambient and maximum loading.
3.
Measured by the voltage drop between I0, I1, and D I/O pins at indicated current through the switch. On-Resistance is determined by the
lower of the voltages on the I0, I1, and D I/O pins.