- 您现在的位置：买卖IC网 > PDF目录11602 > PIC12C508A-04E/SN (Microchip Technology)IC MCU OTP 512X12 8SOIC PDF资料下载
参数资料
| 型号： | PIC12C508A-04E/SN |
| 厂商： | Microchip Technology |
| 文件页数： | 36/113页 |
| 文件大小： | 0K |
| 描述： | IC MCU OTP 512X12 8SOIC |
| 产品培训模块： | Asynchronous Stimulus 8-bit PIC® Microcontroller Portfolio |
| 标准包装： | 100 |
| 系列： | PIC® 12C |
| 核心处理器： | PIC |
| 芯体尺寸： | 8-位 |
| 速度： | 4MHz |
| 外围设备： | POR，WDT |
| 输入/输出数： | 5 |
| 程序存储器容量： | 768B（512 x 12） |
| 程序存储器类型： | OTP |
| RAM 容量： | 25 x 8 |
| 电压 - 电源 (Vcc/Vdd)： | 3 V ~ 5.5 V |
| 振荡器型： | 内部 |
| 工作温度： | -40°C ~ 125°C |
| 封装/外壳： | 8-SOIC（0.154"，3.90mm 宽） |
| 包装： | 管件 |
| 配用： | 309-1046-ND - ADAPTER 8-SOIC TO 8-DIP 309-1045-ND - ADAPTER 8-SOIC TO 8-DIP AC124001-ND - MODULE SKT PROMATEII 8DIP/SOIC |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页第29页第30页第31页第32页第33页第34页第35页当前第36页第37页第38页第39页第40页第41页第42页第43页第44页第45页第46页第47页第48页第49页第50页第51页第52页第53页第54页第55页第56页第57页第58页第59页第60页第61页第62页第63页第64页第65页第66页第67页第68页第69页第70页第71页第72页第73页第74页第75页第76页第77页第78页第79页第80页第81页第82页第83页第84页第85页第86页第87页第88页第89页第90页第91页第92页第93页第94页第95页第96页第97页第98页第99页第100页第101页第102页第103页第104页第105页第106页第107页第108页第109页第110页第111页第112页第113页
1999 Microchip Technology Inc.
DS40139E-page 29
PIC12C5XX
7.0
EEPROM PERIPHERAL
OPERATION
This
section
applies
to
PIC12CE518
and
PIC12CE519 only.
The PIC12CE518 and PIC12CE519 each have 16
bytes of EEPROM data memory. The EEPROM mem-
ory has an endurance of 1,000,000 erase/write cycles
and a data retention of greater than 40 years. The
EEPROM data memory supports a bi-directional 2-wire
bus and data transmission protocol. These two-wires
are serial data (SDA) and serial clock (SCL), that are
mapped to bit6 and bit7, respectively, of the GPIO reg-
ister (SFR 06h). Unlike the GP0-GP5 that are con-
nected to the I/O pins, SDA and SCL are only
connected to the internal EEPROM peripheral.
For
most applications, all that is required is calls to the fol-
lowing functions:
; Byte_Write: Byte write routine
;
Inputs: EEPROM Address
EEADDR
;
EEPROM Data
EEDATA
;
Outputs:
Return 01 in W if OK, else
return 00 in W
;
; Read_Current: Read EEPROM at address
currently held by EE device.
;
Inputs: NONE
;
Outputs:
EEPROM Data
EEDATA
;
Return 01 in W if OK, else
return 00 in W
;
; Read_Random: Read EEPROM byte at supplied
address
;
Inputs: EEPROM Address
EEADDR
;
Outputs:
EEPROM Data
EEDATA
;
Return 01 in W if OK,
else return 00 in W
The code for these functions is available on our website
www.microchip.com. The code will be accessed by
either including the source code FL51XINC.ASM or by
linking FLASH5IX.ASM.
It is very important to check the return codes when
using these calls, and retry the operation if unsuccess-
ful. Unsuccessful return codes occur when the EE data
memory is busy with the previous write, which can take
up to 4 mS.
7.0.1
SERIAL DATA
SDA is a bi-directional pin used to transfer addresses
and data into and data out of the device.
For normal data transfer SDA is allowed to change only
during SCL low. Changes during SCL high are
reserved for indicating the START and STOP condi-
tions.
The EEPROM interface is a 2-wire bus protocol con-
sisting of data (SDA) and a clock (SCL).
Although
these lines are mapped into the GPIO register, they are
not accessible as external pins; only to the internal
EEPROM peripheral. SDA and SCL operation is also
slightly different than GPO-GP5 as listed below.
Namely, to avoid code overhead in modifying the TRIS
register, both SDA and SCL are always outputs. To
read data from the EEPROM peripheral requires out-
putting a ‘1’ on SDA placing it in high-Z state, where
only the internal 100K pull-up is active on the SDA line.
SDA:
Built-in 100K (typical) pull-up to VDD
Open-drain (pull-down only)
Always an output
Outputs a ‘1’ on reset
SCL:
Full CMOS output
Always an output
Outputs a ‘1’ on reset
The following example requires:
Code Space: 77 words
RAM Space: 5 bytes (4 are overlayable)
Stack Levels:1 (The call to the function itself. The
functions do not call any lower level functions.)
Timing:
- WRITE_BYTE takes 328 cycles
- READ_CURRENT takes 212 cycles
- READ_RANDOM takes 416 cycles.
IO Pins: 0 (No external IO pins are used)
This code must reside in the lower half of a page. The
code achieves it’s small size without additional calls
through the use of a sequencing table. The table is a
list of procedures that must be called in order. The
table uses an ADDWF PCL,F instruction, effectively a
computed goto, to sequence to the next procedure.
However the ADDWF PCL,F instruction yields an 8 bit
address, forcing the code to reside in the first 256
addresses of a page.
相关PDF资料 |
PDF描述 |
|---|---|
| PIC16LF1906-E/SS | MCU 14KB FLASH 512B RAM 28SSOP |
| PIC16F1824-E/ST | IC MCU 8BIT 7KB FLASH 14TSSOP |
| PIC16LF1824-E/ST | IC MCU 8BIT 7KB FLASH 14TSSOP |
| PIC16LF1513-E/SO | IC MCU 8BIT 7KB FLASH 28-SOIC |
| PIC16F1513-E/SO | IC MCU 8BIT 7KB FLASH 28-SOIC |
相关代理商/技术参数 |
参数描述 |
|---|---|
| PIC12C508A-04I | 制造商:MICROCHIP 制造商全称:Microchip Technology 功能描述:PIC12C5XX Data Sheet Errata |
| PIC12C508A-04I/JW | 制造商:未知厂家 制造商全称:未知厂家 功能描述:8-Bit Microcontroller |
| PIC12C508A-04I/MF | 功能描述:8位微控制器 -MCU .75KB 25 RAM 6 I/O 4 MHz IndTemp DFN8 RoHS:否 制造商:Silicon Labs 核心:8051 处理器系列:C8051F39x 数据总线宽度:8 bit 最大时钟频率:50 MHz 程序存储器大小:16 KB 数据 RAM 大小:1 KB 片上 ADC:Yes 工作电源电压:1.8 V to 3.6 V 工作温度范围:- 40 C to + 105 C 封装 / 箱体:QFN-20 安装风格:SMD/SMT |
| PIC12C508A-04I/P | 功能描述:8位微控制器 -MCU .75KB 25 RAM 6 I/O 4 MHz IndTemp PDIP8 RoHS:否 制造商:Silicon Labs 核心:8051 处理器系列:C8051F39x 数据总线宽度:8 bit 最大时钟频率:50 MHz 程序存储器大小:16 KB 数据 RAM 大小:1 KB 片上 ADC:Yes 工作电源电压:1.8 V to 3.6 V 工作温度范围:- 40 C to + 105 C 封装 / 箱体:QFN-20 安装风格:SMD/SMT |
| PIC12C508A-04I/P | 制造商:Microchip Technology Inc 功能描述:IC 8BIT CMOS MCU 12C508 DIP8 |
发布紧急采购，3分钟左右您将得到回复。