- 您现在的位置：买卖IC网 > PDF目录3887 > PIC16C432-E/P (Microchip Technology)IC MCU CMOS 8-BIT 20MHZ 2K 20DIP PDF资料下载
参数资料
| 型号： | PIC16C432-E/P |
| 厂商： | Microchip Technology |
| 文件页数： | 46/70页 |
| 文件大小： | 0K |
| 描述： | IC MCU CMOS 8-BIT 20MHZ 2K 20DIP |
| 标准包装： | 25 |
| 系列： | PIC® 16C |
| 核心处理器： | PIC |
| 芯体尺寸： | 8-位 |
| 速度： | 20MHz |
| 连通性： | LIN（本地互连网络） |
| 外围设备： | 欠压检测/复位，POR，WDT |
| 输入/输出数： | 12 |
| 程序存储器容量： | 3.5KB（2K x 14） |
| 程序存储器类型： | OTP |
| RAM 容量： | 128 x 8 |
| 电压 - 电源 (Vcc/Vdd)： | 4.5 V ~ 5.5 V |
| 振荡器型： | 外部 |
| 工作温度： | -40°C ~ 125°C |
| 封装/外壳： | 20-DIP（0.300"，7.62mm） |
| 包装： | 管件 |
| 配用： | AC164029-ND - MODULE SKT PROMATEII 20DIP/SSOP DVA16XP201-ND - ADAPTER DEVICE FOR MPLAB-ICE |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页第29页第30页第31页第32页第33页第34页第35页第36页第37页第38页第39页第40页第41页第42页第43页第44页第45页当前第46页第47页第48页第49页第50页第51页第52页第53页第54页第55页第56页第57页第58页第59页第60页第61页第62页第63页第64页第65页第66页第67页第68页第69页第70页
PIC16C432
DS41140B-page 48
Preliminary
2002 Microchip Technology Inc.
9.4
Power-on Reset (POR), Power-up
Timer (PWRT), Oscillator Start-up
Timer (OST) and Brown-out Reset
(BOD)
9.4.1
POWER-ON RESET (POR)
The on-chip POR circuit holds the chip in RESET until
VDD has reached a high enough level for proper oper-
ation. To take advantage of the POR, just tie the MCLR
pin through a resistor to VDD. This will eliminate exter-
nal RC components usually needed to create Power-on
Reset. A maximum rise time for VDD is required. See
electrical specifications for details.
The POR circuit does not produce an internal RESET
when VDD declines.
When the device starts normal operation (exits the
RESET condition), device operating parameters (volt-
age, frequency, temperature, etc.) must be met to
ensure operation. If these conditions are not met, the
device must be held in RESET until the operating condi-
tions are met.
For additional information, refer to Application Note
AN607, “Power-up Trouble Shooting”.
9.4.2
POWER-UP TIMER (PWRT)
The Power-up Timer provides a fixed 72 ms (nominal)
timeout on power-up only, from POR or Brown-out
Reset. The Power-up Timer operates on an internal RC
oscillator. The chip is kept in RESET as long as PWRT
is active. The PWRT delay allows the VDD to rise to an
acceptable level. A configuration bit, PWRTE, can
disable (if set), or enable (if cleared or programmed)
the Power-up Timer. The Power-up Timer should
always be enabled when Brown-out Reset is enabled.
The Power-Up time delay will vary from chip-to-chip
and due to VDD, temperature and process variation.
See DC parameters for details.
9.4.3
OSCILLATOR START-UP TIMER
(OST)
The Oscillator Start-up Timer (OST) provides a 1024
oscillator cycle (from OSC1 input) delay after the
PWRT delay is over. This ensures that the crystal
oscillator or resonator has started and stabilized.
The OST timeout is invoked only for XT, LP and HS
modes and only on Power-on Reset or wake-up from
SLEEP.
9.4.4
BROWN-OUT RESET (BOD)
The PIC16C432 has an on-chip Brown-out Reset cir-
cuitry. A configuration bit, BOREN, can disable (if clear/
programmed), or enable (if set) the Brown-out Reset
circuitry. If VDD falls below 4.0V (refer to BVDD param-
eter D005) for greater than parameter (TBOR) in
Table 12-6, the brown-out situation will reset the chip.
A RESET won’t occur if VDD falls below 4.0V for less
than parameter (TBOR).
On any RESET (Power-on, Brown-out, Watchdog,
etc.), the chip will remain in RESET until VDD rises
above BVDD. The Power-up Timer will then be invoked
and will keep the chip in RESET an additional 72 ms.
If VDD drops below BVDD while the Power-up Timer is
running, the chip will go back into a Brown-out Reset and
the Power-up Timer will be re-initialized. Once VDD rises
above BVDD, the Power-up Timer will execute a 72 ms
RESET. The Power-up Timer should always be enabled
when Brown-out Reset is enabled. Figure 9-7 shows
typical Brown-out situations.
FIGURE 9-7:
BROWN-OUT SITUATIONS
72 ms
BVDD
VDD
Internal
Reset
BVDD
VDD
Internal
Reset
72 ms
<72 ms
72 ms
BVDD
VDD
Internal
Reset
相关PDF资料 |
PDF描述 |
|---|---|
| PIC18LF452T-I/L | IC MCU FLASH 16KX16 A/D 44PLCC |
| PIC18LF442T-I/L | IC MCU FLASH 8KX16 A/D 44PLCC |
| PIC16HV540-04I/P | IC MCU OTP 512X12 18DIP |
| PIC16LC781T-I/SO | IC MCU OTP 1KX14 A/D D/A 20SOIC |
| PIC16LC782T-I/SS | IC MCU OTP 2KX14 A/D D/A 20SSOP |
相关代理商/技术参数 |
参数描述 |
|---|---|
| PIC16C432-I/P | 功能描述:8位微控制器 -MCU 20MHz 2K EPROM RoHS:否 制造商:Silicon Labs 核心:8051 处理器系列:C8051F39x 数据总线宽度:8 bit 最大时钟频率:50 MHz 程序存储器大小:16 KB 数据 RAM 大小:1 KB 片上 ADC:Yes 工作电源电压:1.8 V to 3.6 V 工作温度范围:- 40 C to + 105 C 封装 / 箱体:QFN-20 安装风格:SMD/SMT |
| PIC16C432-I/SS | 功能描述:8位微控制器 -MCU 3.5KB 128 RAM 12 I/O RoHS:否 制造商:Silicon Labs 核心:8051 处理器系列:C8051F39x 数据总线宽度:8 bit 最大时钟频率:50 MHz 程序存储器大小:16 KB 数据 RAM 大小:1 KB 片上 ADC:Yes 工作电源电压:1.8 V to 3.6 V 工作温度范围:- 40 C to + 105 C 封装 / 箱体:QFN-20 安装风格:SMD/SMT |
| PIC16C432T-E/SS | 功能描述:8位微控制器 -MCU 3.5KB 128 RAM 12 I/O RoHS:否 制造商:Silicon Labs 核心:8051 处理器系列:C8051F39x 数据总线宽度:8 bit 最大时钟频率:50 MHz 程序存储器大小:16 KB 数据 RAM 大小:1 KB 片上 ADC:Yes 工作电源电压:1.8 V to 3.6 V 工作温度范围:- 40 C to + 105 C 封装 / 箱体:QFN-20 安装风格:SMD/SMT |
| PIC16C432T-I/SS | 功能描述:8位微控制器 -MCU 3.5KB 128 RAM 12 I/O RoHS:否 制造商:Silicon Labs 核心:8051 处理器系列:C8051F39x 数据总线宽度:8 bit 最大时钟频率:50 MHz 程序存储器大小:16 KB 数据 RAM 大小:1 KB 片上 ADC:Yes 工作电源电压:1.8 V to 3.6 V 工作温度范围:- 40 C to + 105 C 封装 / 箱体:QFN-20 安装风格:SMD/SMT |
| PIC16C433/JW | 功能描述:8位微控制器 -MCU 3.5KB 128 RAM 6 I/O RoHS:否 制造商:Silicon Labs 核心:8051 处理器系列:C8051F39x 数据总线宽度:8 bit 最大时钟频率:50 MHz 程序存储器大小:16 KB 数据 RAM 大小:1 KB 片上 ADC:Yes 工作电源电压:1.8 V to 3.6 V 工作温度范围:- 40 C to + 105 C 封装 / 箱体:QFN-20 安装风格:SMD/SMT |
发布紧急采购，3分钟左右您将得到回复。