- 您现在的位置：买卖IC网 > PDF目录3887 > PIC16C432-I/P (Microchip Technology)IC MCU CMOS 8-BIT 20MHZ 2K 20DIP PDF资料下载
参数资料
| 型号： | PIC16C432-I/P |
| 厂商： | Microchip Technology |
| 文件页数： | 51/70页 |
| 文件大小： | 0K |
| 描述： | IC MCU CMOS 8-BIT 20MHZ 2K 20DIP |
| 标准包装： | 25 |
| 系列： | PIC® 16C |
| 核心处理器： | PIC |
| 芯体尺寸： | 8-位 |
| 速度： | 20MHz |
| 连通性： | LIN（本地互连网络） |
| 外围设备： | 欠压检测/复位，POR，WDT |
| 输入/输出数： | 12 |
| 程序存储器容量： | 3.5KB（2K x 14） |
| 程序存储器类型： | OTP |
| RAM 容量： | 128 x 8 |
| 电压 - 电源 (Vcc/Vdd)： | 4.5 V ~ 5.5 V |
| 振荡器型： | 外部 |
| 工作温度： | -40°C ~ 85°C |
| 封装/外壳： | 20-DIP（0.300"，7.62mm） |
| 包装： | 管件 |
| 配用： | AC164029-ND - MODULE SKT PROMATEII 20DIP/SSOP DVA16XP201-ND - ADAPTER DEVICE FOR MPLAB-ICE |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页第29页第30页第31页第32页第33页第34页第35页第36页第37页第38页第39页第40页第41页第42页第43页第44页第45页第46页第47页第48页第49页第50页当前第51页第52页第53页第54页第55页第56页第57页第58页第59页第60页第61页第62页第63页第64页第65页第66页第67页第68页第69页第70页
2002 Microchip Technology Inc.
Preliminary
DS41140B-page 53
PIC16C432
9.5
Interrupts
The PIC16C432 has 4 sources of interrupt:
External interrupt RB0/INT
TMR0 overflow interrupt
PORTB change interrupts (pins RB<7:4>)
Comparator interrupt
LIN Bus wake-up can be wired to RB0, or compar-
ator
The interrupt control register (INTCON) and the Periph-
eral Interrupt Register (PIR1) record individual interrupt
requests in flag bits. INTCON and PIR1 have individual
and global interrupt enable bits.
A global interrupt enable bit, GIE (INTCON<7>)
enables (if set) all un-masked interrupts, or disables (if
cleared) all interrupts. Individual interrupts can be
disabled through their corresponding enable bits in
INTCON register. GIE is cleared on RESET.
The “return from interrupt” instruction, RETFIE, exits
interrupt routine, as well as sets the GIE bit, which re-
enables all unmasked interrupts.
The INT pin interrupt, the RB port change interrupt and
the TMR0 overflow interrupt flags are contained in the
INTCON register.
The peripheral interrupt flag is contained in the special
register PIR1. The corresponding interrupt enable bit is
contained in special registers PIE1.
When an interrupt is responded to, the GIE is cleared
to disable any further interrupt, the return address is
pushed into the stack and the PC is loaded with 0004h.
Once in the Interrupt Service Routine, the source(s) of
the interrupt can be determined by polling the interrupt
flag bits. The interrupt flag bit(s) must be cleared in soft-
ware before re-enabling interrupts to avoid RB0/INT
recursive interrupts.
For external interrupt events, such as the INT pin or
PORTB change interrupt, the interrupt latency will be
three or four instruction cycles. The exact latency
depends on when the interrupt event occurs (Figure 9-
16). The latency is the same for one or two cycle
instructions. Once in the Interrupt Service Routine, the
source(s) of the interrupt can be determined by polling
the interrupt flag bits. The interrupt flag bit(s) must be
cleared in software before re-enabling interrupts to
avoid multiple interrupt requests.
FIGURE 9-15:
INTERRUPT LOGIC
Note 1: Individual interrupt flag bits are set, regard-
less of the status of their corresponding
mask bit or the GIE bit.
2: When an instruction that clears the GIE bit
is executed, any interrupts that were
pending for execution in the next cycle are
ignored. The CPU will execute a NOP in the
cycle immediately following the instruction
which clears the GIE bit. The interrupts
which were ignored are still pending to be
serviced when the GIE bit is set again.
RBIF
RBIE
T0IF
T0IE
INTF
INTE
GIE
PEIE
Wake-up
(If in SLEEP mode)
Interrupt
to CPU
CMIE
CMIF
相关PDF资料 |
PDF描述 |
|---|---|
| PIC16C432-E/P | IC MCU CMOS 8-BIT 20MHZ 2K 20DIP |
| PIC18LF452T-I/L | IC MCU FLASH 16KX16 A/D 44PLCC |
| PIC18LF442T-I/L | IC MCU FLASH 8KX16 A/D 44PLCC |
| PIC16HV540-04I/P | IC MCU OTP 512X12 18DIP |
| PIC16LC781T-I/SO | IC MCU OTP 1KX14 A/D D/A 20SOIC |
相关代理商/技术参数 |
参数描述 |
|---|---|
| PIC16C432T-E/SS | 功能描述:8位微控制器 -MCU 3.5KB 128 RAM 12 I/O RoHS:否 制造商:Silicon Labs 核心:8051 处理器系列:C8051F39x 数据总线宽度:8 bit 最大时钟频率:50 MHz 程序存储器大小:16 KB 数据 RAM 大小:1 KB 片上 ADC:Yes 工作电源电压:1.8 V to 3.6 V 工作温度范围:- 40 C to + 105 C 封装 / 箱体:QFN-20 安装风格:SMD/SMT |
| PIC16C432T-I/SS | 功能描述:8位微控制器 -MCU 3.5KB 128 RAM 12 I/O RoHS:否 制造商:Silicon Labs 核心:8051 处理器系列:C8051F39x 数据总线宽度:8 bit 最大时钟频率:50 MHz 程序存储器大小:16 KB 数据 RAM 大小:1 KB 片上 ADC:Yes 工作电源电压:1.8 V to 3.6 V 工作温度范围:- 40 C to + 105 C 封装 / 箱体:QFN-20 安装风格:SMD/SMT |
| PIC16C433/JW | 功能描述:8位微控制器 -MCU 3.5KB 128 RAM 6 I/O RoHS:否 制造商:Silicon Labs 核心:8051 处理器系列:C8051F39x 数据总线宽度:8 bit 最大时钟频率:50 MHz 程序存储器大小:16 KB 数据 RAM 大小:1 KB 片上 ADC:Yes 工作电源电压:1.8 V to 3.6 V 工作温度范围:- 40 C to + 105 C 封装 / 箱体:QFN-20 安装风格:SMD/SMT |
| PIC16C433-E/P | 功能描述:8位微控制器 -MCU 3.5KB 128 RAM 6 I/O RoHS:否 制造商:Silicon Labs 核心:8051 处理器系列:C8051F39x 数据总线宽度:8 bit 最大时钟频率:50 MHz 程序存储器大小:16 KB 数据 RAM 大小:1 KB 片上 ADC:Yes 工作电源电压:1.8 V to 3.6 V 工作温度范围:- 40 C to + 105 C 封装 / 箱体:QFN-20 安装风格:SMD/SMT |
| PIC16C433-E/SO | 功能描述:8位微控制器 -MCU 3.5KB 128 RAM 6 I/O RoHS:否 制造商:Silicon Labs 核心:8051 处理器系列:C8051F39x 数据总线宽度:8 bit 最大时钟频率:50 MHz 程序存储器大小:16 KB 数据 RAM 大小:1 KB 片上 ADC:Yes 工作电源电压:1.8 V to 3.6 V 工作温度范围:- 40 C to + 105 C 封装 / 箱体:QFN-20 安装风格:SMD/SMT |
发布紧急采购，3分钟左右您将得到回复。