参数资料
型号: PKA2232PI
厂商: ERICSSON
英文描述: 25-40 W DC/DC Power Modules 24 V Input Series
中文描述: 25-40中西区区议会/ DC电源模块24 V输入系列
文件页数: 15/20页
文件大小: 864K
代理商: PKA2232PI
EN/LZT 146 09 R1A Ericsson Microelectronics AB, June 2000
15
EMC Specifications
The conducted EMI measurement was performed using a module
placed directly on the test bench.
The fundamental switching frequency is 300 kHz ±15% @ V
I
= 26V,
I
O
= (0.1...1.0) ×I
Omax
.
Output Ripple (V
O
ac)
Output ripple is measured as the peak to peak voltage of the funda-
mental switching frequency.
Conducted EMI Input terminal value (typ)
Over Voltage Protection (OVP)
The remote control can also be utilized for OVP by using the external
circuitry in fig. 2. Resistor values given are for 5V output applica-
tions, but can easily be adjusted for other output voltages and the
desired OVP level.
Maximum Capacitive Load
The maximum recommended capacitance connected directly to the
PKA DC/DC power modules’ output, without resistance or inductance
in series, is 100 F/A (output current rating). Connect capacitors
across the load for maximum effectiveness and maximum stability
margins.
Turn-off Input Voltage (V
Ioff
)
The input voltage is monitored and the PKA DC/DC power module
will turn on and turn off at predetermined levels. The levels can be
decreased by means of an external resistor connected between pin 1
and pin 4.
A 200 k resistor will decrease the shutdown voltage below 18 V. To
maintain the nominal output voltage at input voltages below V
I
min it
may be necessary to decrease the load.
Operating information
Remote Control (RC)
Turn-on or turn-off can be realized by using the RC-pin. Normal
operation is achieved if pin 1 is open (NC). If pin 1 is connected to pin
3 the PKA DC/DC power module turns off. To ensure safe turn-off the
voltage difference between pin 1 and 3 shall be less than 1.8 V. RC is
TTL open collector compatible (see fig. 1). Pin 1 is an output and no
current should be driven into pin 1. Use a diode if necessary e.g. totem
pole TTL logic. The internal pull-up resistance is 36 k
Fig. 1
RC
(pin 1)
TTL
PKA
Control
Logic
-VI
+VI
-In
(pin 3)
Test Set-up according to CISPR publ. 1A
.
5
50
Fig. 2
6
7
9
8
10
5
4
1
3
Parallel Operation
Due to the current limiting protection (hick-up), temperature coeffi-
cient and output voltage characteristic for PKA paralleling of modules
for increased power is not recommended. PKA can be paralleled for
redundancy.
Output Voltage Adjust (V
adj
)
The output voltage, V
O
, can be adjusted by using an external resistor.
The output voltage adjust function is not accurate and it is recom-
mended to use a potentiometer. To decrease the output voltage the
resistor should be connected between pin 10 and pin 9 (+Out 1). To
increase the output voltage the resistor should be connected between
pin 10 and pin 8 (–Out 1).
Current Limiting Protection
The output power is limited at loads above the output current limiting
threshold (I
lim
), specified as a minimum value.
As the PKA multiple output models are power limited, current limit-
ing threshold for an individual output is set by the loads on the other
outputs. The power module can withstand continuous short circuit
without destruction. A hick-up mode is used on all models to mini-
mize the internal power dissipation. The hick-up time constant is set
by the slow start.
相关PDF资料
PDF描述
PKA2323CI 25-40 W DC/DC Power Modules 24 V Input Series
PKF4310SI KPSE 10C 10#20 SKT PLUG
PKF4510 KPSE 3C 3#16 PIN PLUG
PKF4510PI KPSE 12C 8#20 4#16 PIN
PKF4510SI KPSE 19C 19#20 PIN PLUG
相关代理商/技术参数
参数描述
PKA2323CI 制造商:ERICSSON 制造商全称:Ericsson 功能描述:25-40 W DC/DC Power Modules 24 V Input Series
PKA2323PI 制造商:ERICSSON 制造商全称:Ericsson 功能描述:25-40 W DC/DC Power Modules 24 V Input Series
PKA2325CI 制造商:ERICSSON 制造商全称:Ericsson 功能描述:25-40 W DC/DC Power Modules 24 V Input Series
PKA2325PI 制造商:ERICSSON 制造商全称:Ericsson 功能描述:25-40 W DC/DC Power Modules 24 V Input Series
PKA2411PIL 制造商:ERICSSON 制造商全称:Ericsson 功能描述:25-40 W DC/DC Power Modules 24 V Input Series