- 您现在的位置：买卖IC网 > PDF目录69044 > PKA2323PI (ERICSSON POWER MODULES AB) 2-OUTPUT 30 W DC-DC REG PWR SUPPLY MODULE PDF资料下载
参数资料
| 型号： | PKA2323PI |
| 厂商： | ERICSSON POWER MODULES AB |
| 元件分类： | 电源模块 |
| 英文描述： | 2-OUTPUT 30 W DC-DC REG PWR SUPPLY MODULE |
| 文件页数： | 7/17页 |
| 文件大小： | 849K |
| 代理商： | PKA2323PI |
EN/LZT 146 09 R1C Ericsson Power Modules AB, September 2003
15
EMC Specifications
The conducted EMI measurement was performed using a module
placed directly on the test bench.
The fundamental switching frequency is 300 kHz ±15% @ VI = 26V,
IO = (0.1...1.0) × IOmax.
Output Ripple (VOac)
Output ripple is measured as the peak to peak voltage of the funda-
mental switching frequency.
Conducted EMI Input terminal value (typ)
Maximum Capacitive Load
The maximum recommended capacitance connected directly to the
PKA DC/DC power modules’ output, without resistance or inductance
in series, is 100
F/A (output current rating). Connect capacitors
across the load for maximum effectiveness and maximum stability
margins.
Turn-off Input Voltage (VIoff)
The input voltage is monitored and the PKA DC/DC power module
will turn on and turn off at predetermined levels. The levels can be
decreased by means of an external resistor connected between pin 1
and pin 4.
A 200 k
resistor will decrease the shutdown voltage below 18 V. To
maintain the nominal output voltage at input voltages below VI min it
may be necessary to decrease the load.
Operating information
Remote Control (RC)
Turn-on or turn-off can be realized by using the RC-pin. Normal
operation is achieved if pin 1 is open (NC). If pin 1 is connected to pin
3 the PKA DC/DC power module turns off. To ensure safe turn-off the
voltage difference between pin 1 and 3 shall be less than 1.8 V. RC is
TTL open collector compatible (see fig. 1). Pin 1 is an output and no
current should be driven into pin 1. Use a diode if necessary e.g.
totem pole TTL logic. The internal pull-up resistance is 15 k
.
Fig. 1
RC
(pin 1)
TTL
PKA
Control
Logic
-VI
+VI
-In
(pin 3)
Test Set-up according to CISPR publ. 1A
.
5
50
Parallel Operation
Due to the current limiting protection (hick-up), temperature coeffi-
cient and output voltage characteristic for PKA paralleling of modules
for increased power is not recommended. PKA can be paralleled for
redundancy.
Output Voltage Adjust (Vadj)
The output voltage, VO, can be adjusted by using an external resistor.
The output voltage adjust function is not accurate and it is recom-
mended to use a potentiometer. To decrease the output voltage the
resistor should be connected between pin 10 and pin 9 (+ Out 1). To
increase the output voltage the resistor should be connected between
pin 10 and pin 8 (– Out 1).
Current Limiting Protection
The output power is limited at loads above the output current limit-
ing threshold (Ilim), specified as a minimum value.
As the PKA multiple output models are power limited, current limit-
ing threshold for an individual output is set by the loads on the other
outputs. The power module can withstand continuous short circuit
without destruction. A hick-up mode is used on all models to mini-
mize the internal power dissipation. The hick-up time constant is set
by the slow start.
相关PDF资料 |
PDF描述 |
|---|---|
| PKA2211PI | 1-OUTPUT 25 W DC-DC REG PWR SUPPLY MODULE |
| PKA2432PIL | 3-OUTPUT 40 W DC-DC REG PWR SUPPLY MODULE |
| PKA2325PI | 2-OUTPUT 30 W DC-DC REG PWR SUPPLY MODULE |
| PKA2232PI | 3-OUTPUT 25 W DC-DC REG PWR SUPPLY MODULE |
| PKA2231PI | 3-OUTPUT 25 W DC-DC REG PWR SUPPLY MODULE |
相关代理商/技术参数 |
参数描述 |
|---|---|
| PKA2325CI | 制造商:ERICSSON 制造商全称:Ericsson 功能描述:25-40 W DC/DC Power Modules 24 V Input Series |
| PKA2325PI | 制造商:ERICSSON 制造商全称:Ericsson 功能描述:25-40 W DC/DC Power Modules 24 V Input Series |
| PKA2411PIL | 制造商:ERICSSON 制造商全称:Ericsson 功能描述:25-40 W DC/DC Power Modules 24 V Input Series |
| PKA2432PIL | 制造商:ERICSSON 制造商全称:Ericsson 功能描述:25-40 W DC/DC Power Modules 24 V Input Series |
| PKA50B | 制造商:ALC 功能描述:ALCO BLACK KNOB S9B6B |
发布紧急采购，3分钟左右您将得到回复。